| /linux-4.4.14/drivers/net/wireless/brcm80211/brcmsmac/ |
| H A D | types.h | 96 #define D11CONF 0x0fffffb0 /* Supported D11 revs: 4, 5, 7-27
100 #define NCONF 0x000001ff /* Supported nphy revs:
112 #define LCNCONF 0x00000007 /* Supported lcnphy revs:
118 #define SSLPNCONF 0x0000000f /* Supported sslpnphy revs:
|
| /linux-4.4.14/arch/x86/include/asm/uv/ |
| H A D | bios.h | 60 u32 revision; /* distinguish different firmware revs */
|
| /linux-4.4.14/arch/powerpc/platforms/85xx/ |
| H A D | ksi8560.c | 162 seq_printf(m, "Unknown Hardware and CPLD revs\n"); ksi8560_show_cpuinfo()
|
| /linux-4.4.14/arch/mips/include/asm/xtalk/ |
| H A D | xwidget.h | 120 char *revs[16]; member in struct:widget_ident
|
| /linux-4.4.14/arch/sh/boards/mach-sdk7786/ |
| H A D | setup.c | 157 * clock A (slot 1 and the CPU clock). Newer revs of the PCB shove
|
| /linux-4.4.14/arch/powerpc/platforms/powermac/ |
| H A D | cache.S | 25 * paranoid, but I've had enough issues with various CPU revs and
222 /* Due to a bug with the HW flush on some CPU revs, we occasionally
|
| H A D | feature.c | 2516 * that all Apple OF revs did it properly, I do it the paranoid way. probe_motherboard()
2627 * revs 1.5 to 2.O and Pangea. Seem to toggle the UniN Maxbus/PCI probe_uninorth()
|
| H A D | pci.c | 240 * revs of K2 on recent G5s, except for the host bridge itself, which u3_ht_skip_device()
|
| /linux-4.4.14/arch/powerpc/sysdev/ |
| H A D | mv64x60_dev.c | 140 pdata.cache_mgmt = 1; /* All current revs need this set */ mv64x60_mpsc_device_setup()
176 pdata.brg_can_tune = 1; /* All current revs need this set */ mv64x60_mpsc_device_setup()
|
| /linux-4.4.14/drivers/usb/host/ |
| H A D | ohci-pci.c | 40 /* AMD 756, for most chips (early revs), corrupts register
|
| H A D | ohci.h | 706 * till some bits (mostly reserved) are clear; ok for all revs.
|
| /linux-4.4.14/arch/mips/include/asm/sibyte/ |
| H A D | sb1250_defs.h | 95 * ordering, so be careful when adding support for new minor revs.
|
| H A D | sb1250_scd.h | 352 /* This feature is present in 1250 C0 and later, but *not* in 112x A revs. */
|
| /linux-4.4.14/drivers/media/i2c/ |
| H A D | msp3400-driver.c | 754 /* Has scart4 input: not in pre D revisions, not in stripped D revs */ msp_probe()
767 /* Has subwoofer output: not in pre-D revs and not in stripped down msp_probe()
|
| H A D | msp3400-kthreads.c | 275 /* Note: for the C and D revs no NTSC stereo + SAP is possible as msp3400c_set_audmode()
|
| /linux-4.4.14/drivers/ata/ |
| H A D | pata_cmd64x.c | 464 /* Early revs have no CNTRL_CH0 */ cmd64x_init_one()
|
| /linux-4.4.14/arch/powerpc/kvm/ |
| H A D | book3s_hv_rm_mmu.c | 500 struct revmap_entry *rev, *revs[4]; kvmppc_h_bulk_remove() local
573 revs[n] = rev; kvmppc_h_bulk_remove()
588 rev = revs[k]; kvmppc_h_bulk_remove()
|
| /linux-4.4.14/drivers/ssb/ |
| H A D | driver_chipcommon.c | 73 case SSB_CLKMODE_SLOW: /* For revs 6..9 only */ ssb_chipco_set_clockmode()
|
| /linux-4.4.14/drivers/ide/ |
| H A D | alim15x3.c | 311 * 0x53 changes meaning on later revs - we must no touch init_chipset_ali15x3()
|
| /linux-4.4.14/drivers/gpu/drm/r128/ |
| H A D | r128_drv.h | 493 * need to keep this set. It works around a bug in early revs of the
|
| /linux-4.4.14/drivers/net/ethernet/broadcom/ |
| H A D | bgmac.h | 202 #define BGMAC_CMDCFG_SR_REV0 0x00000800 /* Set to reset mode, for other revs */
|
| /linux-4.4.14/arch/sparc/include/uapi/asm/ |
| H A D | unistd.h | 99 #define __NR_msync 65 /* Common in newer 1.3.x revs... */
|
| /linux-4.4.14/drivers/net/wireless/ath/ath5k/ |
| H A D | reset.c | 1011 /* For older revs we scale power on sw during tx power ath5k_hw_commit_eeprom_settings()
1221 * For revs. after Oahu, only save ath5k_hw_reset()
|
| H A D | base.c | 2340 * least on older hardware revs. ath5k_intr()
|
| /linux-4.4.14/drivers/scsi/ |
| H A D | esp_scsi.h | 154 * bit on other revs of the ESP.
|
| /linux-4.4.14/drivers/infiniband/hw/mthca/ |
| H A D | mthca_cq.c | 559 * Arbel FW 5.1.400. This bug should be fixed in later FW revs. mthca_poll_one()
|
| /linux-4.4.14/drivers/net/ |
| H A D | sungem_phy.c | 1096 /* two revs in darwin for the 88e1101 ... I could use a datasheet
|
| /linux-4.4.14/net/sunrpc/xprtrdma/ |
| H A D | rpc_rdma.c | 214 * RDMA/Sessions NFSv4 proposal addresses this for future v4 revs.)
|
| /linux-4.4.14/arch/powerpc/kernel/ |
| H A D | misc_32.S | 249 SYNC /* Some chip revs have problems here... */
|
| H A D | cputable.c | 800 { /* 750FX (All revs except 2.0) */
|
| H A D | entry_32.S | 750 SYNC /* Some chip revs have problems here... */
|
| /linux-4.4.14/drivers/staging/lustre/lustre/llite/ |
| H A D | rw.c | 38 * Lustre Lite I/O page cache routines shared by different kernel revs
|
| /linux-4.4.14/drivers/scsi/aic7xxx/ |
| H A D | aic79xx.h | 311 * in some situations. Some aic79xx chip revs. are more
|
| /linux-4.4.14/drivers/net/ethernet/packetengines/ |
| H A D | yellowfin.c | 213 HasMACAddrBug=32, /* Only on early revs. */
|
| /linux-4.4.14/drivers/net/ethernet/amd/ |
| H A D | lance.c | 1213 of QNX reports that some revs of the 79C965 clear it. */ lance_rx()
|
| H A D | pcnet32.c | 1233 * Boyd of QNX reports that some revs of the 79C965 clear it. pcnet32_rx()
|
| /linux-4.4.14/drivers/tty/serial/ |
| H A D | pmac_zilog.c | 1258 /* XXX Check which revs of machines actually allow 1 and 4Mb speeds __pmz_set_termios()
|
| /linux-4.4.14/drivers/parisc/ |
| H A D | lba_pci.c | 1599 ** Early LBA revs go fatal on *any* master abort. lba_driver_probe()
|
| /linux-4.4.14/drivers/net/ethernet/dec/tulip/ |
| H A D | tulip_core.c | 313 /* On some chip revs we must set the MII/SYM port before the reset!? */ tulip_up()
|
| /linux-4.4.14/drivers/video/fbdev/aty/ |
| H A D | radeon_base.c | 1578 /* Not all chip revs have the same format for this register, radeon_calc_pll_regs()
|
| /linux-4.4.14/drivers/net/wireless/b43/ |
| H A D | phy_g.c | 1614 B43_WARN_ON(phy->radio_rev == 6 || phy->radio_rev == 7); /* We had code for these revs here... */ b43_phy_initb6()
|
| /linux-4.4.14/drivers/pci/ |
| H A D | quirks.c | 808 * We check all revs >= B0 (yet not in the pre production!) as the bug
|
| /linux-4.4.14/drivers/net/ethernet/nvidia/ |
| H A D | forcedeth.c | 100 #define DEV_NEED_TX_LIMIT2 0x0180000 /* device needs to limit tx, expect for some revs */
|
| /linux-4.4.14/drivers/net/ethernet/intel/e1000/ |
| H A D | e1000_hw.c | 1128 /* Force MDI for earlier revs of the IGP PHY */ e1000_copper_link_igp_setup()
|