| /linux-4.1.27/drivers/iio/light/ |
| D | isl29125.c | 54 u8 conf1; member
94 data->conf1 | isl29125_regs[si].mode); in isl29125_read_data()
118 i2c_smbus_write_byte_data(data->client, ISL29125_CONF1, data->conf1); in isl29125_read_data()
142 if (data->conf1 & ISL29125_MODE_RANGE) in isl29125_read_raw()
162 data->conf1 |= ISL29125_MODE_RANGE; in isl29125_write_raw()
164 data->conf1 &= ~ISL29125_MODE_RANGE; in isl29125_write_raw()
168 data->conf1); in isl29125_write_raw()
210 data->conf1 |= ISL29125_MODE_RGB; in isl29125_buffer_preenable()
212 data->conf1); in isl29125_buffer_preenable()
224 data->conf1 &= ~ISL29125_MODE_MASK; in isl29125_buffer_predisable()
[all …]
|
| /linux-4.1.27/drivers/hwmon/ |
| D | adm1031.c | 90 u8 conf1; member
179 data->conf1 = adm1031_read_value(client, ADM1031_REG_CONF1); in adm1031_update_device()
270 (*(data)->chan_select_table)[FAN_CHAN_FROM_REG((data)->conf1)][idx % 2]
358 old_fan_mode = data->conf1; in set_fan_auto_channel()
362 ret = get_fan_auto_nearest(data, nr, val, data->conf1); in set_fan_auto_channel()
368 data->conf1 = FAN_CHAN_TO_REG(reg, data->conf1); in set_fan_auto_channel()
369 if ((data->conf1 & ADM1031_CONF1_AUTO_MODE) ^ in set_fan_auto_channel()
371 if (data->conf1 & ADM1031_CONF1_AUTO_MODE) { in set_fan_auto_channel()
389 data->conf1 = FAN_CHAN_TO_REG(reg, data->conf1); in set_fan_auto_channel()
390 adm1031_write_value(client, ADM1031_REG_CONF1, data->conf1); in set_fan_auto_channel()
[all …]
|
| D | emc2103.c | 139 u8 conf1; in read_fan_config_from_i2c() local
141 if (read_u8_from_i2c(client, REG_FAN_CONF1, &conf1) < 0) in read_fan_config_from_i2c()
144 data->fan_multiplier = 1 << ((conf1 & 0x60) >> 5); in read_fan_config_from_i2c()
145 data->fan_rpm_control = (conf1 & 0x80) != 0; in read_fan_config_from_i2c()
|
| /linux-4.1.27/drivers/atm/ |
| D | lanai.c | 289 u32 conf1, conf2; /* CONFIG[12] registers */ member
498 reg_write(lanai, lanai->conf1, Config1_Reg); in conf1_write()
510 if (unlikely((lanai->conf1 & CONFIG1_POWERDOWN) != 0)) in conf2_write_if_powerup()
877 #define set_config1(x) do { lanai->conf1 = x; conf1_write(lanai); \ in eeprom_read()
879 #define clock_h() set_config1(lanai->conf1 | CONFIG1_PROMCLK) in eeprom_read()
880 #define clock_l() set_config1(lanai->conf1 &~ CONFIG1_PROMCLK) in eeprom_read()
881 #define data_h() set_config1(lanai->conf1 | CONFIG1_PROMDATA) in eeprom_read()
882 #define data_l() set_config1(lanai->conf1 &~ CONFIG1_PROMDATA) in eeprom_read()
895 tmp = (lanai->conf1 & ~CONFIG1_PROMDATA) | in eeprom_read()
897 if (lanai->conf1 != tmp) { in eeprom_read()
[all …]
|
| /linux-4.1.27/drivers/misc/carma/ |
| D | carma-fpga.c | 544 u32 conf1, conf2, version; in data_calculate_bufsize() local
554 conf1 = fpga_read_reg(priv, i, MMAP_REG_CORL_CONF1); in data_calculate_bufsize()
559 num_corl = (conf1 & 0x000000F0) >> 4; in data_calculate_bufsize()
560 num_pack = (conf1 & 0x00000F00) >> 8; in data_calculate_bufsize()
561 num_lags = (conf1 & 0x00FFF000) >> 12; in data_calculate_bufsize()
562 num_meta = (conf1 & 0x7F000000) >> 24; in data_calculate_bufsize()
565 num_corl = (conf1 & 0x000000F0) >> 4; in data_calculate_bufsize()
567 num_lags = (conf1 & 0x000FFF00) >> 8; in data_calculate_bufsize()
568 num_meta = (conf1 & 0x7FF00000) >> 20; in data_calculate_bufsize()
|
| /linux-4.1.27/drivers/media/rc/ |
| D | ene_ir.c | 590 u8 conf1 = ene_read_reg(dev, ENE_CIRCFG); in ene_tx_enable() local
593 dev->saved_conf1 = conf1; in ene_tx_enable()
607 conf1 &= ~ENE_CIRCFG_RX_EN; in ene_tx_enable()
610 conf1 |= ENE_CIRCFG_TX_EN | ENE_CIRCFG_TX_IRQ; in ene_tx_enable()
611 ene_write_reg(dev, ENE_CIRCFG, conf1); in ene_tx_enable()
|
| /linux-4.1.27/drivers/pci/ |
| D | quirks.c | 1507 u32 conf1, conf5, class; in quirk_jmicron_ata() local
1514 pci_read_config_dword(pdev, 0x40, &conf1); in quirk_jmicron_ata()
1517 conf1 &= ~0x00CFF302; /* Clear bit 1, 8, 9, 12-19, 22, 23 */ in quirk_jmicron_ata()
1525 conf1 |= 0x0002A100; /* Set 8, 13, 15, 17 */ in quirk_jmicron_ata()
1538 conf1 |= 0x00C2A1B3; /* Set 0, 1, 4, 5, 7, 8, 13, 15, 17, 22, 23 */ in quirk_jmicron_ata()
1543 conf1 |= 0x00C00000; /* Set 22, 23 */ in quirk_jmicron_ata()
1547 pci_write_config_dword(pdev, 0x40, conf1); in quirk_jmicron_ata()
|
| /linux-4.1.27/Documentation/x86/x86_64/ |
| D | boot-options.txt | 174 pci=conf1 Use conf1 access.
|
| /linux-4.1.27/Documentation/ |
| D | kernel-parameters.txt | 2659 conf1 [X86] Force use of PCI Configuration
|