| /linux-4.4.14/Documentation/video4linux/bttv/ |
| D | README.quirks | 54 rules are satisfied. Before GNT is asserted by the PCI arbiter, this
59 FRAME will be asserted (typically - each initiator will assert FRAME on
60 the cycle following GNT). When FRAME is asserted, it is the initiator s
63 not allow the other request to hold REQ asserted. The decision lock may
66 asynchronously until GNT is again asserted.
73 during the same cycle that GNT is de-asserted. This is non PCI 2.1
77 to the internal functions unless REQ is asserted. This prevents a bus
78 transaction from starting the same cycle as GNT is de-asserted. This
|
| /linux-4.4.14/Documentation/devicetree/bindings/mmc/ |
| D | mmc-pwrseq-simple.txt | 11 - reset-gpios : contains a list of GPIO specifiers. The reset GPIOs are asserted
13 They will be de-asserted right after the power has been provided to the
|
| D | mmc-pwrseq-emmc.txt | 15 - reset-gpios : contains a GPIO specifier. The reset GPIO is asserted
|
| /linux-4.4.14/Documentation/devicetree/bindings/reset/ |
| D | st,sti-picophyreset.txt | 8 The actual action taken when softreset is asserted is hardware dependent.
9 However, when asserted it may not be possible to access the hardware's
|
| D | st,sti-softreset.txt | 9 The actual action taken when softreset is asserted is hardware dependent.
10 However, when asserted it may not be possible to access the hardware's
|
| D | st,sti-powerdown.txt | 10 The actual action taken when powerdown is asserted is hardware dependent.
11 However, when asserted it may not be possible to access the hardware's
|
| D | reset.txt | 75 child device has reset asserted.
|
| /linux-4.4.14/Documentation/hwmon/ |
| D | adm9240 | 77 Temperature alarm is asserted once the temperature exceeds the high limit,
99 - low speed alarm will be asserted if fan speed is
110 - alarm will be asserted
139 An alarm is asserted for any voltage going below or above the set limits.
150 An alarm is asserted when the CI pin goes active high. The ADM9240
|
| D | lm93 | 92 signals. I.e. when #P1_PROCHOT is asserted, the LM93 will automatically
112 which 1 indicates #VRD_HOT is asserted and 0 indicates it is negated. These
233 If the #PROCHOT or #VRDHOT signals are asserted while bound to a PWM output
282 vrdhot<n> 0 means negated, 1 means asserted
292 pwm_auto_prochot_ramp ramp time per step when #PROCHOT asserted
294 pwm_auto_vrdhot_ramp ramp time per step when #VRDHOT asserted
|
| D | adm1026 | 46 be asserted. The current temperature and limits have a resolution of 1
|
| D | w83792d | 96 Tart will be asserted while target temperature cannot be achieved after 3 minutes
|
| D | lm85 | 227 Tmin control and THERM asserted counts. Automatic Tmin control acts to
|
| /linux-4.4.14/arch/powerpc/kvm/ |
| D | book3s_xics.c | 96 state->asserted = 1; in ics_deliver_irq()
98 state->asserted = 0; in ics_deliver_irq()
807 if (state->asserted) in kvmppc_h_eoi()
960 irq->saved_priority, irq->asserted, in xics_debug_show()
1177 if (irqp->asserted) in xics_get_source()
1231 irqp->asserted = 0; in xics_set_source()
1233 irqp->asserted = 1; in xics_set_source()
|
| D | book3s_xics.h | 42 u8 asserted; /* Only for LSI */ member
|
| D | book3s_hv_rm_xics.c | 614 if (state->asserted) { in kvmppc_rm_h_eoi()
|
| /linux-4.4.14/Documentation/devicetree/bindings/pci/ |
| D | fsl,imx6q-pcie.txt | 12 - "msi": The interrupt that is asserted when an MSI is received
|
| D | layerscape-pci.txt | 22 "intr": The interrupt that is asserted for controller interrupts
|
| D | nvidia,tegra20-pcie.txt | 18 "intr": The Tegra interrupt that is asserted for controller interrupts
19 "msi": The Tegra interrupt that is asserted when an MSI is received
|
| /linux-4.4.14/Documentation/blackfin/ |
| D | bfin-spi-notes.txt | 6 the Slave Select is always under software control and being asserted during
|
| /linux-4.4.14/Documentation/devicetree/bindings/memory-controllers/ |
| D | mvebu-devbus.txt | 64 DEV_OEn and DEV_CSn are asserted at the same cycle.
73 DEV_OEn and DEV_CSn are de-asserted at the same cycle
76 DEV_OEn is always de-asserted the next cycle after
|
| /linux-4.4.14/Documentation/devicetree/bindings/sound/ |
| D | cs4271.txt | 25 line is de-asserted. That also means that clocks cannot be changed
|
| /linux-4.4.14/Documentation/devicetree/bindings/mtd/ |
| D | fsmc-nand.txt | 30 command is asserted. Zero means one cycle, 255 means 256
|
| /linux-4.4.14/Documentation/devicetree/bindings/leds/ |
| D | leds-aat1290.txt | 4 asserted high, enable flash strobe and movie mode (max 1/2 of flash current)
|
| /linux-4.4.14/Documentation/ |
| D | smsc_ece1099.txt | 17 The bus interrupt pin (BC_INT# or SMBUS_INT#) is asserted if
|
| D | memory-hotplug.txt | 206 memory class object of _HID "PNP0C80". When a notify is asserted to PNP0C80,
215 "PNP0A05", or "PNP0A06", notification is asserted to it, and ACPI handler
|
| /linux-4.4.14/Documentation/devicetree/bindings/media/ |
| D | stih407-c8sectpfe.txt | 45 (all bits/bytes with ts_valid or ts_packet asserted are valid).
|
| /linux-4.4.14/Documentation/devicetree/bindings/i2c/ |
| D | i2c-arb-gpio-challenge.txt | 35 3. Check THEIR_CLAIMS. If none are asserted then the we have the bus and we are
|
| /linux-4.4.14/Documentation/virtual/kvm/arm/ |
| D | vgic-mapped-irqs.txt | 85 asserted, typically until the guest programs the device to deassert the
95 takes a new interrupt if and only if the physical line is still asserted.
|
| /linux-4.4.14/Documentation/devicetree/bindings/powerpc/fsl/ |
| D | dcsr.txt | 76 match. Which counter asserted the interrupt is captured in an EPU
82 Which event source asserted the interrupt is captured in an EPU
|
| /linux-4.4.14/Documentation/devicetree/bindings/gpio/ |
| D | gpio.txt | 91 GPIO controller that achieves (or represents, for inputs) a logically asserted
92 value at the device. The exact definition of logically asserted should be
|
| /linux-4.4.14/Documentation/devicetree/bindings/net/ |
| D | fsl-tsec-phy.txt | 61 waking up by Filer General Purpose Interrupt (FGPI) asserted on the
|
| /linux-4.4.14/drivers/net/ethernet/broadcom/bnx2x/ |
| D | bnx2x_main.c | 3990 static void bnx2x_attn_int_asserted(struct bnx2x *bp, u32 asserted) in bnx2x_attn_int_asserted() argument
4001 if (bp->attn_state & asserted) in bnx2x_attn_int_asserted()
4008 aeu_mask, asserted); in bnx2x_attn_int_asserted()
4009 aeu_mask &= ~(asserted & 0x3ff); in bnx2x_attn_int_asserted()
4016 bp->attn_state |= asserted; in bnx2x_attn_int_asserted()
4019 if (asserted & ATTN_HARD_WIRED_MASK) { in bnx2x_attn_int_asserted()
4020 if (asserted & ATTN_NIG_FOR_FUNC) { in bnx2x_attn_int_asserted()
4038 if (asserted & ATTN_SW_TIMER_4_FUNC) in bnx2x_attn_int_asserted()
4041 if (asserted & GPIO_2_FUNC) in bnx2x_attn_int_asserted()
4044 if (asserted & GPIO_3_FUNC) in bnx2x_attn_int_asserted()
[all …]
|
| /linux-4.4.14/Documentation/spi/ |
| D | pxa2xx | 134 asserted around the complete message. Use SSPFRM as a GPIO (through cs_control)
|
| /linux-4.4.14/Documentation/networking/caif/ |
| D | spi_porting.txt | 43 variable indicates whether the GPIO should be asserted (HIGH) or
|
| /linux-4.4.14/drivers/scsi/aic7xxx/ |
| D | aic79xx.seq | 359 * ATN can be asserted even if the current
804 * we have selected out with ATN asserted and the target
840 * asserted.
1395 * they were asserted within the bus settle delay window.
1399 * an async phase due to our asserted ACK. Each
2006 * will not be asserted if the NONPACKREQ is for us,
|
| D | aic7xxx.seq | 231 * If ATN isn't asserted, the target isn't interested
649 * asserted.
|
| D | aic7xxx.reg | 147 * asserted.
|
| /linux-4.4.14/tools/perf/ |
| D | design.txt | 120 cycles while bus lock signal asserted" events on Intel Core CPUs, pass
|
| /linux-4.4.14/Documentation/scsi/ |
| D | sym53c8xx_2.txt | 563 logic state, 100 micro-seconds after having asserted the SCSI RESET line.
566 RESET has been asserted, any signal to TRUE may indicate a SCSI BUS problem.
|
| D | ncr53c8xx.txt | 996 logic state, 100 micro-seconds after having asserted the SCSI RESET line.
999 RESET has been asserted, any signal to TRUE may indicate a SCSI BUS problem.
|
| /linux-4.4.14/Documentation/dmaengine/ |
| D | provider.txt | 64 and whenever a DRQ will be asserted, it will go through the collection
|
| /linux-4.4.14/Documentation/networking/ |
| D | z8530drv.txt | 453 will just wait until the CTS signal is asserted. This
|
| D | bonding.txt | 539 The default value is 0. This will cause carrier to be asserted (for
|
| /linux-4.4.14/tools/power/cpupower/po/ |
| D | de.po | 360 msgid " (asserted by call to hardware)"
|
| D | it.po | 358 msgid " (asserted by call to hardware)"
|
| D | cs.po | 363 msgid " (asserted by call to hardware)"
|
| D | fr.po | 358 msgid " (asserted by call to hardware)"
|
| D | pt.po | 357 msgid " (asserted by call to hardware)"
|
| /linux-4.4.14/Documentation/PCI/ |
| D | pci.txt | 439 it was one of the remaining devices asserted the IRQ line. Since none
|
| /linux-4.4.14/Documentation/virtual/kvm/ |
| D | api.txt | 654 means active (asserted), 0 means inactive (deasserted).
2329 as from an EOI, the gsi is de-asserted and the user is notified via
3331 it is still asserted. Vector is the LAPIC interrupt vector for which the
|
| /linux-4.4.14/arch/arm/crypto/ |
| D | sha512-core.S_shipped | 36 @ Technical writers asserted that 3-way S4 pipeline can sustain
|