| /linux-4.4.14/arch/c6x/lib/ |
| D | memcpy_64plus.S | 29 [A0] STB .D1T1 A5,*A3++
31 [A1] STB .D1T1 A7,*A3++
32 [A1] STB .D1T1 A8,*A3++
|
| D | csum_64plus.S | 97 STB .D2T1 A7,*B4++
99 STB .D2T1 A8,*B4++
109 STB .D2T1 A7,*B4++
111 STB .D2T1 A8,*B4++
128 STB .D2T2 B7,*B4++
134 STB .D2T2 B7,*B4++
|
| /linux-4.4.14/drivers/soc/brcmstb/ |
| D | Kconfig | 2 bool "Broadcom STB SoC drivers"
5 Enables drivers for the Broadcom Set-Top Box (STB) series of chips.
|
| /linux-4.4.14/Documentation/video4linux/bttv/ |
| D | ICs | 33 STB TV pci:
36 if you want better support for STB cards send me info!
|
| D | Insmod-options | 93 tda9873 = 1 this one on your card (STB uses these)
153 one. This chip is seen on most STB TV/FM cards (usually from
|
| D | Cards | 584 STB
586 STB Gateway 6000704 (bt878)
587 STB Gateway 6000699 (bt848)
588 STB Gateway 6000402 (bt848)
589 STB TV130 PCI
|
| /linux-4.4.14/arch/blackfin/include/asm/ |
| D | bfin_serial.h | 71 #define STB 0x1000 /* Stop Bits */ macro
79 #define LCR_MASK (SB | STP | EPS | PEN | STB | WLS_MASK)
116 #define STB 0x04 /* Stop Bits */ macro
122 #define LCR_MASK (SB | STP | EPS | PEN | STB | WLS_MASK)
|
| /linux-4.4.14/Documentation/arm/sti/ |
| D | stih416-overview.txt | 8 for satellite, cable, terrestrial and IP-STB markets.
|
| D | stih415-overview.txt | 8 for satellite, cable, terrestrial and IP-STB markets.
|
| D | stih418-overview.txt | 9 and IP-STB markets.
|
| D | stih407-overview.txt | 9 and IP-STB markets.
|
| /linux-4.4.14/arch/arm/boot/dts/ |
| D | bcm7445-bcm97445svmb.dts | 5 model = "Broadcom STB (bcm7445), SVMB reference board";
|
| D | bcm7445.dtsi | 8 model = "Broadcom STB (bcm7445)";
|
| /linux-4.4.14/drivers/power/reset/ |
| D | Kconfig | 42 bool "Broadcom STB reset driver"
47 This driver provides restart support for Broadcom STB boards.
49 Say Y here if you have a Broadcom STB board and you wish
|
| /linux-4.4.14/Documentation/devicetree/bindings/ata/ |
| D | brcm,sata-brcmstb.txt | 1 * Broadcom SATA3 AHCI Controller for STB
|
| /linux-4.4.14/Documentation/devicetree/bindings/phy/ |
| D | brcm,brcmstb-sata-phy.txt | 1 * Broadcom SATA3 PHY for STB
|
| /linux-4.4.14/Documentation/devicetree/bindings/arm/bcm/ |
| D | brcm,brcmstb.txt | 1 ARM Broadcom STB platforms Device Tree Bindings
13 model = "Broadcom STB (bcm7445)";
144 A Broadcom STB SoC typically has a number of independent memory controllers,
|
| /linux-4.4.14/drivers/media/pci/bt8xx/ |
| D | Kconfig | 18 the Miro, Hauppauge and STB boards. Please read the material in
|
| /linux-4.4.14/Documentation/video4linux/ |
| D | CARDLIST.bttv | 4 3 -> STB, Gateway P/N 6000699 (bt848)
41 40 -> STB TV PCI FM, Gateway P/N 6000704 (bt878), 3Dfx VoodooTV 100 [10b4:2636,10b4:2645,121a:3060]
|
| /linux-4.4.14/Documentation/devicetree/bindings/mtd/ |
| D | brcm,brcmnand.txt | 1 * Broadcom STB NAND Controller
9 This controller was originally designed for STB SoCs (BCM7xxx) but is now
|
| /linux-4.4.14/arch/arm64/boot/dts/marvell/ |
| D | berlin4ct-stb.dts | 50 model = "Marvell BG4CT STB board";
|
| /linux-4.4.14/Documentation/devicetree/bindings/gpio/ |
| D | brcm,brcmstb-gpio.txt | 1 Broadcom STB "UPG GIO" GPIO controller
|
| /linux-4.4.14/Documentation/sound/alsa/soc/ |
| D | DAI.txt | 22 I2S is a common 4 wire DAI used in HiFi, STB and portable devices. The Tx and
|
| /linux-4.4.14/drivers/bus/ |
| D | Kconfig | 59 bool "Broadcom STB GISB bus arbiter"
|
| /linux-4.4.14/arch/arm/mach-bcm/ |
| D | Kconfig | 166 Say Y if you intend to run the kernel on a Broadcom ARM-based STB
|
| /linux-4.4.14/drivers/phy/ |
| D | Kconfig | 376 tristate "Broadcom STB SATA PHY driver"
381 Enable this to support the SATA3 PHY on 28nm Broadcom STB SoCs.
|
| /linux-4.4.14/drivers/eisa/ |
| D | eisa.ids | 959 ISAB401 "STB Systems EGA Plus"
960 ISAB402 "STB Chauffeur HT"
961 ISAB403 "STB VGA Extra"
962 ISAB404 "STB EGA MultiRes"
|
| /linux-4.4.14/drivers/ata/ |
| D | Kconfig | 102 tristate "Broadcom STB AHCI SATA support"
106 STB SoC's.
|
| /linux-4.4.14/drivers/pwm/ |
| D | Kconfig | 114 tristate "Broadcom STB PWM support"
|
| /linux-4.4.14/sound/isa/ |
| D | Kconfig | 253 soundcards (Gravis UltraSound Plug & Play, STB SoundRage32,
|
| /linux-4.4.14/drivers/gpio/ |
| D | Kconfig | 142 Say yes here to enable GPIO support for Broadcom STB (BCM7XXX) SoCs.
927 This chip can be found on Miro, Hauppauge and STB TV-cards.
|
| /linux-4.4.14/drivers/tty/serial/ |
| D | bfin_uart.c | 824 lcr |= STB; in bfin_serial_set_termios()
|
| D | Kconfig | 1302 BCM7xxx (STB) - DOCSIS console
|
| /linux-4.4.14/drivers/mtd/nand/ |
| D | Kconfig | 395 tristate "Broadcom STB NAND controller"
|
| /linux-4.4.14/Documentation/sound/alsa/ |
| D | ALSA-Configuration.txt | 1169 Module for Gravis UltraSound PnP, Dynasonic 3-D/Pro, STB Sound Rage 32
1191 Module for UltraSound 32-Pro (sound card from STB used by Compaq)
|
| /linux-4.4.14/arch/arm/ |
| D | Kconfig.debug | 185 If you have a Broadcom STB chip and would like early print
|
| /linux-4.4.14/ |
| D | MAINTAINERS | 2451 BROADCOM STB NAND FLASH DRIVER
|