| /linux-4.4.14/arch/arm/mach-imx/ |
| D | mach-imx27_visstrim_m10.c | 172 .flags = GPIOF_DIR_OUT | GPIOF_INIT_HIGH,
177 .flags = GPIOF_DIR_OUT | GPIOF_INIT_LOW,
182 .flags = GPIOF_DIR_OUT | GPIOF_INIT_LOW,
187 .flags = GPIOF_DIR_OUT,
192 .flags = GPIOF_DIR_OUT,
197 .flags = GPIOF_DIR_OUT,
202 .flags = GPIOF_DIR_OUT,
|
| /linux-4.4.14/include/linux/ |
| D | gpio.h | 9 #define GPIOF_DIR_OUT (0 << 0) macro
16 #define GPIOF_OUT_INIT_LOW (GPIOF_DIR_OUT | GPIOF_INIT_LOW)
17 #define GPIOF_OUT_INIT_HIGH (GPIOF_DIR_OUT | GPIOF_INIT_HIGH)
|
| D | fmc.h | 120 # define GPIOF_DIR_OUT (0 << 0) macro
|
| /linux-4.4.14/drivers/staging/iio/adc/ |
| D | ad7606_core.c | 312 .flags = GPIOF_DIR_OUT | ((st->oversampling & 1) ? in ad7606_request_gpios()
318 .flags = GPIOF_DIR_OUT | ((st->oversampling & 2) ? in ad7606_request_gpios()
324 .flags = GPIOF_DIR_OUT | ((st->oversampling & 4) ? in ad7606_request_gpios()
361 ret = gpio_request_one(st->pdata->gpio_range, GPIOF_DIR_OUT | in ad7606_request_gpios()
|
| /linux-4.4.14/drivers/rtc/ |
| D | rtc-moxart.c | 287 GPIOF_DIR_OUT, "rtc_sclk"); in moxart_rtc_probe()
294 GPIOF_DIR_OUT, "rtc_reset"); in moxart_rtc_probe()
|
| /linux-4.4.14/drivers/video/backlight/ |
| D | lms283gf05.c | 162 GPIOF_DIR_OUT | (!pdata->reset_inverted ? in lms283gf05_probe()
|
| D | gpio_backlight.c | 117 ret = devm_gpio_request_one(gbl->dev, gbl->gpio, GPIOF_DIR_OUT | in gpio_backlight_probe()
|
| D | bd6107.c | 151 GPIOF_DIR_OUT | GPIOF_INIT_LOW, "reset"); in bd6107_probe()
|
| /linux-4.4.14/drivers/staging/iio/resolver/ |
| D | ad2s1200.c | 112 ret = devm_gpio_request_one(&spi->dev, pins[pn], GPIOF_DIR_OUT, in ad2s1200_probe()
|
| D | ad2s1210.c | 643 unsigned long flags = st->pdata->gpioin ? GPIOF_DIR_IN : GPIOF_DIR_OUT; in ad2s1210_setup_gpios()
657 unsigned long flags = st->pdata->gpioin ? GPIOF_DIR_IN : GPIOF_DIR_OUT; in ad2s1210_free_gpios()
|
| /linux-4.4.14/drivers/gpio/ |
| D | gpio-74xx-mmio.c | 92 return (priv->flags & MMIO_74XX_DIR_OUT) ? GPIOF_DIR_OUT : GPIOF_DIR_IN; in mmio_74xx_get_direction()
|
| D | gpio-generic.c | 320 GPIOF_DIR_OUT : GPIOF_DIR_IN; in bgpio_get_dir()
377 GPIOF_DIR_IN : GPIOF_DIR_OUT; in bgpio_get_dir_inv()
|
| D | gpio-ich.c | 178 return ichx_read_bit(GPIO_IO_SEL, nr) ? GPIOF_DIR_IN : GPIOF_DIR_OUT; in ichx_gpio_get_direction()
|
| D | gpio-dln2.c | 207 return GPIOF_DIR_OUT; in dln2_gpio_get_direction()
|
| D | gpio-bcm-kona.c | 132 return val ? GPIOF_DIR_IN : GPIOF_DIR_OUT; in bcm_kona_gpio_get_dir()
|
| /linux-4.4.14/arch/arm/mach-davinci/ |
| D | board-omapl138-hawk.c | 262 GPIOF_DIR_OUT, "USB1 VBUS"); in omapl138_hawk_usb_init()
|
| /linux-4.4.14/arch/arm/mach-pxa/ |
| D | magician.c | 371 { EGPIO_MAGICIAN_BL_POWER, GPIOF_DIR_OUT, "Backlight power" },
372 { EGPIO_MAGICIAN_BL_POWER2, GPIOF_DIR_OUT, "Backlight power 2" },
|
| D | palmtreo.c | 470 const unsigned long lcd_flags = GPIOF_INIT_HIGH | GPIOF_DIR_OUT; in treo680_gpio_init()
|
| /linux-4.4.14/drivers/spi/ |
| D | spi-ath79.c | 128 flags = GPIOF_DIR_OUT; in ath79_spi_setup_cs()
|
| /linux-4.4.14/Documentation/zh_CN/ |
| D | gpio.txt | 300 * GPIOF_DIR_OUT - 配置方向为输出
|
| /linux-4.4.14/drivers/pinctrl/vt8500/ |
| D | pinctrl-wmt.c | 499 return GPIOF_DIR_OUT; in wmt_gpio_get_direction()
|
| /linux-4.4.14/drivers/input/touchscreen/ |
| D | auo-pixcir-ts.c | 611 GPIOF_DIR_OUT | GPIOF_INIT_HIGH, in auo_pixcir_probe()
|
| /linux-4.4.14/drivers/leds/ |
| D | leds-lp55xx-common.c | 402 GPIOF_DIR_OUT, "lp5523_enable"); in lp55xx_init_device()
|
| /linux-4.4.14/drivers/nfc/ |
| D | trf7970a.c | 2023 GPIOF_DIR_OUT | GPIOF_INIT_LOW, "trf7970a EN"); in trf7970a_probe()
2036 GPIOF_DIR_OUT | GPIOF_INIT_LOW, "trf7970a EN2"); in trf7970a_probe()
|
| /linux-4.4.14/drivers/mfd/ |
| D | arizona-core.c | 1035 GPIOF_DIR_OUT | GPIOF_INIT_LOW, in arizona_dev_init()
|
| /linux-4.4.14/Documentation/fmc/ |
| D | carrier.txt | 239 int mode; /* GPIOF_DIR_OUT etc, from <linux/gpio.h> */
|
| /linux-4.4.14/Documentation/gpio/ |
| D | consumer.txt | 165 This function will return either GPIOF_DIR_IN or GPIOF_DIR_OUT.
|
| D | gpio-legacy.txt | 318 * GPIOF_DIR_OUT - to configure direction as output
|
| /linux-4.4.14/drivers/media/i2c/s5c73m3/ |
| D | s5c73m3-core.c | 1560 unsigned int flags = GPIOF_DIR_OUT; in s5c73m3_configure_gpios()
|
| /linux-4.4.14/drivers/media/i2c/ |
| D | s5k5baf.c | 1805 int flags = GPIOF_DIR_OUT; in s5k5baf_configure_gpios()
|
| /linux-4.4.14/drivers/net/ethernet/oki-semi/pch_gbe/ |
| D | pch_gbe_main.c | 2720 unsigned long flags = GPIOF_DIR_OUT | GPIOF_INIT_HIGH | GPIOF_EXPORT; in pch_gbe_minnow_platform_init()
|
| /linux-4.4.14/drivers/net/wireless/ath/ath9k/ |
| D | hw.c | 2730 gpio_request_one(gpio, GPIOF_DIR_OUT | GPIOF_INIT_LOW, label); in ath9k_hw_request_gpio()
|
| /linux-4.4.14/drivers/regulator/ |
| D | core.c | 1899 GPIOF_DIR_OUT | config->ena_gpio_flags, in regulator_ena_gpio_request()
|