| /linux-4.1.27/Documentation/devicetree/bindings/power_supply/ |
| D | lp8727_charger.txt | 12 AC and USB charging parameters
15 - charging-current: value of 'enum lp8727_ichg' (u8)
31 /* AC charger: 5% EOC and 500mA charging current */
35 charging-current = /bits/ 8 <4>;
38 /* USB charger: 10% EOC and 400mA charging current */
42 charging-current = /bits/ 8 <2>;
|
| D | charger-manager.txt | 25 - cm-battery-* : threshold battery temperature for charging
26 -cold : critical cold temperature of battery for charging
28 -hot : critical hot temperature of battery for charging
30 - cm-dis/charging-max = limits of charging duration
60 /* Allow charging for 5hr */
61 cm-charging-max = <18000000>;
|
| D | tps65090.txt | 7 -ti,enable-low-current-chrg: Enables charging when a low current is detected
8 while the default logic is to stop charging.
|
| D | max8925_batter.txt | 6 - topoff-threshold: set charging current in topoff mode
7 - fast-charge: set charging current in fast mode
|
| D | gpio-charger.txt | 13 usb-dcp (USB dedicated charging port)
14 usb-cdp (USB charging downstream port)
|
| D | ti,bq24735.txt | 13 - ti,charge-current : Used to control and set the charging current. This value
17 - ti,charge-voltage : Used to control and set the charging voltage. This value
|
| /linux-4.1.27/Documentation/ABI/testing/ |
| D | sysfs-class-power | 9 A userspace daemon can monitor the battery charging logic
29 the device will terminate fast-charge mode (charging current
43 the device will terminate fast-charge mode (charging current
55 This entry shows and sets the charging current threshold for
56 entering top-off charging mode. When charging current in fast
58 interrupt and start top-off charging mode.
72 the device will terminate top-off charge mode (charging current
|
| D | sysfs-platform-msi-laptop | 48 overclocked. Turbo mode is available only if charging. It is
|
| D | sysfs-driver-toshiba_acpi | 76 Description: This file controls the USB Sleep & Charge charging mode, which
|
| /linux-4.1.27/Documentation/devicetree/bindings/rtc/ |
| D | rtc-palmas.txt | 15 battery is chargeable or not. If charging battery then driver can
16 enable the charging.
17 - ti,backup-battery-charge-high-current: Enable high current charging in
18 backup battery. Device supports the < 100mA and > 100mA charging.
|
| D | abracon,abx80x.txt | 26 and valid to enable charging:
|
| /linux-4.1.27/arch/sh/boards/mach-hp6xx/ |
| D | hp6xx_apm.c | 34 int battery, backup, charging, percentage; in hp6x0_apm_get_power_status() local
39 charging = adc_single(ADC_CHANNEL_CHARGE); in hp6x0_apm_get_power_status()
60 } else if (charging < 8) { in hp6x0_apm_get_power_status()
|
| /linux-4.1.27/drivers/macintosh/ |
| D | apm_emu.c | 35 char charging = 0; in pmu_apm_get_power_status() local
64 charging++; in pmu_apm_get_power_status()
78 if (charging > 0) { in pmu_apm_get_power_status()
|
| D | Kconfig | 83 control system power, and battery charging on the portable models.
|
| /linux-4.1.27/Documentation/devicetree/bindings/power/ |
| D | twl-charger.txt | 10 - ti,bb-uvolt: microvolts for charging the backup battery.
11 - ti,bb-uamp: microamps for charging the backup battery.
|
| D | bq2415x.txt | 23 - ti,battery-regulation-voltage: integer, maximum charging voltage in mV.
24 - ti,charge-current: integer, maximum charging current in mA.
|
| /linux-4.1.27/drivers/mfd/ |
| D | tps65010.c | 78 unsigned charging:1; member
219 seq_printf(s, "%scharging\n\n", tps->charging ? "" : "(not) "); in dbg_show()
365 unsigned charging = 0; in tps65010_interrupt() local
383 charging = 1; in tps65010_interrupt()
385 charging = 1; in tps65010_interrupt()
387 if (charging != tps->charging) { in tps65010_interrupt()
388 tps->charging = charging; in tps65010_interrupt()
390 DRIVER_NAME, charging ? "" : in tps65010_interrupt()
399 if ((tps->model != TPS65013 || !tps->charging) in tps65010_interrupt()
|
| D | Kconfig | 839 of the AB3100 such as battery-backed RTC, charging control,
1036 lithium ion/polymer battery charging, and other features that
1049 regulators, lithium ion/polymer battery charging, touch screen
|
| /linux-4.1.27/Documentation/hwmon/ |
| D | twl4030-madc-hwmon | 44 degree Celsius. The Battery charging current channel represents
45 battery charging current in mA.
|
| D | da9052 | 31 charging current ICH, battery temperature TBAT, battery junction temperature
|
| /linux-4.1.27/include/linux/power/ |
| D | twl4030_madc_battery.h | 33 struct twl4030_madc_bat_calibration *charging; member
|
| /linux-4.1.27/drivers/w1/slaves/ |
| D | Kconfig | 88 as the one who is responsible for charging/discharging/monitoring
100 as the one who is responsible for charging/discharging/monitoring
112 as the one who is responsible for charging/discharging/monitoring
|
| /linux-4.1.27/Documentation/power/ |
| D | charger-manager.txt | 35 consumption and slow down charging process. Or even, such peak power
36 consumption can stop chargers in the middle of charging
38 only affects the charging time, but the lifespan of the battery.
50 restarts charging. This check is also performed while suspended by
173 : This callback returns 0 if the temperature is safe for charging,
198 a) charger-on/off b) external-power-in/out c) battery-in/out (while charging)
|
| D | power_supply_class.txt | 24 typically expected feedback of battery charging/fully charged status and
75 STATUS - this attribute represents operating status (charging, full,
126 the current drawn from a charging source.
159 while battery is charging)
|
| /linux-4.1.27/Documentation/devicetree/bindings/pwm/ |
| D | ti,twl-pwmled.txt | 5 On TWL6030 series: LED PWM (mainly used as charging indicator LED)
|
| /linux-4.1.27/drivers/power/ |
| D | twl4030_madc_battery.c | 83 calibration = bat->pdata->charging; in twl4030_madc_bat_voltscale()
223 sort(pdata->charging, pdata->charging_size, in twl4030_madc_battery_probe()
|
| D | ab8500_fg.c | 138 bool charging; member
1214 if (di->flags.charging) { in ab8500_fg_calculate_scaled_capacity()
1250 if (di->flags.charging) { in ab8500_fg_update_cap_scalers()
1291 if (!(!di->flags.charging && di->bat_cap.level > in ab8500_fg_check_capacity_limits()
1358 } else if (!(!di->flags.charging && in ab8500_fg_check_capacity_limits()
1759 if (di->flags.charging) in ab8500_fg_algorithm()
1779 di->flags.charging, in ab8500_fg_algorithm()
1807 if (di->flags.charging) in ab8500_fg_periodic_work()
2209 if (!di->flags.charging) in ab8500_fg_get_ext_psy_data()
2211 di->flags.charging = false; in ab8500_fg_get_ext_psy_data()
[all …]
|
| D | max14577_charger.c | 109 int ret, charging; in max14577_get_charge_type() local
119 ret = max14577_get_charger_state(chg, &charging); in max14577_get_charge_type()
123 if (charging == POWER_SUPPLY_STATUS_CHARGING) in max14577_get_charge_type()
|
| D | Kconfig | 101 as the one who is responsible for charging/discharging/monitoring
344 system. The charger-manager also can monitor charging status in
409 Say Y here to enable support for battery charging with TPS65090
|
| D | charger-manager.c | 207 bool charging = false; in is_charging() local
262 charging = true; in is_charging()
266 return charging; in is_charging()
|
| /linux-4.1.27/Documentation/devicetree/bindings/mfd/ |
| D | max77693.txt | 62 high temperature charging mode. If die temperature exceeds this value
63 the charging current will be reduced by 105 mA/Celsius.
|
| D | max8998.txt | 4 regulators, real time clock, battery charging controller and several
13 In addition, it includes a real time clock and battery charging controller
|
| D | cros-ec.txt | 4 implements various function such as keyboard and battery charging.
|
| D | max14577.txt | 32 In an overvoltage condition, INT asserts and charging
|
| /linux-4.1.27/Documentation/devicetree/bindings/leds/ |
| D | leds-pwm.txt | 45 charging {
|
| D | leds-gpio.txt | 63 linux,default-trigger = "max8903-charger-charging";
|
| /linux-4.1.27/drivers/staging/iio/ |
| D | TODO | 24 by a driver of the SoC's battery charging unit to avoid any damage to the
|
| /linux-4.1.27/drivers/hid/ |
| D | wacom_wac.c | 1942 int pid, battery, charging; in wacom_wireless_irq() local
1954 charging = !!(data[5] & 0x80); in wacom_wireless_irq()
1961 wacom_notify_battery(wacom, battery, charging, 1, 0); in wacom_wireless_irq()
1992 bool charging = !!(data[8] & 0x80); in wacom_status_irq() local
1994 wacom_notify_battery(wacom_wac, battery, charging, in wacom_status_irq()
1995 battery || charging, 1); in wacom_status_irq()
|
| /linux-4.1.27/arch/arm/boot/dts/ |
| D | omap4-sdp.dts | 97 charging {
|
| /linux-4.1.27/Documentation/cgroups/ |
| D | memory.txt | 490 pgpgin - # of charging events to the memory cgroup. The charging
|
| /linux-4.1.27/Documentation/laptops/ |
| D | laptop-mode.txt | 760 ACTION="`cat $BATT_INFO | grep charging | cut -c 26-`"
|
| D | thinkpad-acpi.txt | 930 except the charging or discharging battery to determine which
|
| /linux-4.1.27/Documentation/usb/ |
| D | power-management.txt | 558 a charging application. In any event a logically off port will lose
|
| /linux-4.1.27/drivers/rtc/ |
| D | Kconfig | 663 features such as alarms and trickle charging.
|