1TI BQ24735 Charge Controller
2~~~~~~~~~~
3
4Required properties :
5 - compatible : "ti,bq24735"
6
7Optional properties :
8 - interrupts : Specify the interrupt to be used to trigger when the AC
9   adapter is either plugged in or removed.
10 - ti,ac-detect-gpios : This GPIO is optionally used to read the AC adapter
11   presence. This is a Host GPIO that is configured as an input and
12   connected to the bq24735.
13 - ti,charge-current : Used to control and set the charging current. This value
14   must be between 128mA and 8.128A with a 64mA step resolution. The POR value
15   is 0x0000h. This number is in mA (e.g. 8192), see spec for more information
16   about the ChargeCurrent (0x14h) register.
17 - ti,charge-voltage : Used to control and set the charging voltage. This value
18   must be between 1.024V and 19.2V with a 16mV step resolution. The POR value
19   is 0x0000h. This number is in mV (e.g. 19200), see spec for more information
20   about the ChargeVoltage (0x15h) register.
21 - ti,input-current : Used to control and set the charger input current. This
22   value must be between 128mA and 8.064A with a 128mA step resolution. The
23   POR value is 0x1000h. This number is in mA (e.g. 8064), see the spec for
24   more information about the InputCurrent (0x3fh) register.
25
26Example:
27
28	bq24735@9 {
29		compatible = "ti,bq24735";
30		reg = <0x9>;
31		ti,ac-detect-gpios = <&gpio 72 0x1>;
32	}
33