| /linux-4.1.27/arch/cris/boot/compressed/ |
| D | head_v10.S | 27 ;; We need to initialze DRAM registers before we start using the DRAM
52 ;; We assume 8 MB is the minimum DRAM in an eLinux
58 ;; in the flash (since we wont try to copy it to DRAM
69 ;; Copy text+data to DRAM
115 move.d RAM_INIT_MAGIC, $r8 ; Tell kernel that DRAM is initialized
|
| D | README | 11 burned into a flash or executed directly at the DRAM origin.
20 Be careful - it assumes some things about free locations in DRAM. It
21 assumes the DRAM starts at 0x40000000 and that it is at least 8 MB,
|
| D | head_v32.S | 26 ;; Initialize the DRAM registers.
43 ;; We assume 8 MB is the minimum DRAM and put
|
| /linux-4.1.27/sound/isa/gus/ |
| D | gus_dram.c | 43 outsb(GUSP(gus, DRAM), buffer, size1); in snd_gus_dram_poke()
79 insb(GUSP(gus, DRAM), buffer, size1); in snd_gus_dram_peek()
|
| D | gus_main.c | 170 gus->gf1.reg_dram = GUSP(gus, DRAM); in snd_gus_create()
|
| D | gus_io.c | 33 inb(GUSP(gus, DRAM)); in snd_gf1_delay()
|
| D | gus_pcm.c | 329 outsb(GUSP(gus, DRAM), buf, len); in snd_gf1_pcm_poke_block()
|
| /linux-4.1.27/arch/cris/arch-v32/kernel/ |
| D | head.S | 45 ;; 0x40004000 if DRAM.
162 ; Check if starting from DRAM (network->RAM boot or unpacked
184 ;; Initialize DRAM.
199 ;; Copy the text and data section to DRAM. This depends on that the
341 ;; Clear romfs_in_flash flag, as we now know romfs is in DRAM
|
| /linux-4.1.27/arch/arm/ |
| D | Kconfig-nommu | 13 hex '(S)DRAM Base Address' if SET_MEM_PARAM
17 hex '(S)DRAM SIZE' if SET_MEM_PARAM
|
| /linux-4.1.27/arch/cris/boot/rescue/ |
| D | head_v10.S | 79 ;; of itself (after having setup the DRAM etc).
157 ;; We need to setup the bus registers before we start using the DRAM
307 move.d RAM_INIT_MAGIC, $r8 ; Tell next product that DRAM is
319 move.d RAM_INIT_MAGIC, $r8 ; Tell next product that DRAM is
|
| D | kimagerescue.S | 66 ;; We need to setup the bus registers before we start using the DRAM
70 ;; We assume 8 MB is the minimum DRAM in an eLinux
|
| /linux-4.1.27/arch/cris/arch-v10/lib/ |
| D | hw_settings.S | 33 ; SDRAM or EDO DRAM?
|
| D | dram_init.S | 78 and.d 0x800000, $r1 ; DRAM width is bit 23
|
| /linux-4.1.27/arch/arm/mach-lpc32xx/ |
| D | suspend.S | 54 @ This guarantees a small windows where DRAM isn't busy
|
| /linux-4.1.27/arch/arm/mach-shmobile/include/mach/ |
| D | head-kzm9g.txt | 151 LIST "DRAM initialization code:"
397 LIST "Magic to avoid hangs and corruption on DRAM writes."
401 LIST "a corrupt image to DRAM."
404 LIST "the DRAM controller. Such an invalidation should not be necessary at"
406 LIST "at the minimal snippet of code necessary to avoid the DRAM stability"
|
| /linux-4.1.27/Documentation/arm/SA1100/ |
| D | LART | 5 applications. It has 32 MB DRAM, 4MB Flash ROM, double RS232 and all
|
| D | Itsy | 11 64 Meg of DRAM and 32 Meg of Flash. The initial work includes support for
|
| /linux-4.1.27/drivers/idle/ |
| D | Kconfig | 25 DRAM devices.
|
| /linux-4.1.27/arch/cris/arch-v10/kernel/ |
| D | head.S | 31 ;; 0x00000000 if Flash, 0x40004000 if DRAM
43 ;; to 0x40000000 (where the actual DRAM resides) otherwise
146 ;; Check if we start from DRAM or FLASH by testing PC
177 ;; We need to initialze DRAM registers before we start using the DRAM
186 ;; Copy text+data to DRAM
196 ;; DRAM and we never get here in the first place :))
|
| /linux-4.1.27/Documentation/devicetree/bindings/clock/ |
| D | exynos4415-clock.txt | 11 - "samsung,exynos4415-cmu-dmc" - for the Exynos4415 SoC DRAM Memory
|
| D | mvebu-core-clock.txt | 11 3 = hclk (DRAM control clock)
|
| D | exynos5433-clock.txt | 15 which generates clocks for DRAM Memory Controller domain.
|
| /linux-4.1.27/drivers/powercap/ |
| D | Kconfig | 28 fine grained control. These domains include processor package, DRAM
|
| /linux-4.1.27/drivers/edac/ |
| D | Kconfig | 111 Support for error detection and correction of DRAM ECC errors on
121 errors into DRAM.
131 which trigger the DRAM ECC Read and Write respectively.
195 E3-1200 based DRAM controllers.
366 tristate "Cavium Octeon DRAM Memory Controller (LMC)"
|
| /linux-4.1.27/arch/c6x/kernel/ |
| D | vectors.S | 12 ; At RESET the processor sets up the DRAM timing parameters and
|
| /linux-4.1.27/arch/arm64/boot/dts/freescale/ |
| D | fsl-ls2085a.dtsi | 122 /* DRAM space - 1, size : 2 GB DRAM */
|
| /linux-4.1.27/Documentation/devicetree/bindings/arm/tegra/ |
| D | nvidia,tegra20-pmc.txt | 29 0 (LP0): CPU + Core voltage off and DRAM in self-refresh
30 1 (LP1): CPU voltage off and DRAM in self-refresh
|
| /linux-4.1.27/arch/cris/arch-v10/ |
| D | Kconfig | 267 Waitstates for SRAM, Flash and peripherals (not DRAM). 95f8 is a
290 The R_DRAM_CONFIG register specifies everything on how the DRAM
301 Different DRAM chips have different speeds. Current Axis products
302 use 50ns DRAM chips which can use the timing: 5611.
|
| D | README.mm | 58 E0000000|______________________| | DRAM |
73 | kernel seg_0 - seg_a | \==>| DRAM |
144 NOTE: while setting up the MMU, we run in a non-mapped mode in the DRAM (0x40 function
|
| /linux-4.1.27/arch/arm/mach-sa1100/ |
| D | sleep.S | 133 @ Step 5 clear DRAM refresh control register
|
| /linux-4.1.27/arch/cris/arch-v32/mach-fs/ |
| D | dram_init.S | 59 and.d 0x200, $r1 ; DRAM width is bit 9
|
| /linux-4.1.27/arch/arm/mach-tegra/ |
| D | sleep-tegra20.S | 392 str r1, [r0, #EMC_SELF_REF] @ take DRAM out of self refresh
500 str r2, [r1, #EMC_REQ_CTRL] @ stall incoming DRAM requests
|
| D | sleep-tegra30.S | 454 str r1, [r0, #EMC_SELF_REF] @ take DRAM out of self refresh
770 str r1, [r0, #EMC_REQ_CTRL] @ stall incoming DRAM requests
|
| /linux-4.1.27/Documentation/ABI/testing/ |
| D | sysfs-devices-edac | 101 Description: This attribute file will display what type of DRAM device is
110 mean a Chipkill with x4 DRAM.
|
| /linux-4.1.27/Documentation/devicetree/bindings/arm/ |
| D | fw-cfg.txt | 12 DTB that QEMU places at the bottom of the guest's DRAM.
|
| /linux-4.1.27/arch/cris/ |
| D | Kconfig | 163 int "DRAM size (dec, in MB)"
166 Size of DRAM (decimal in MB) typically 2, 8 or 16.
|
| /linux-4.1.27/Documentation/cris/ |
| D | README | 37 * EDO or page-mode DRAM
|
| /linux-4.1.27/arch/frv/kernel/ |
| D | sleep.S | 205 # now that DRAM is back, this is the end of the code which gets
|
| /linux-4.1.27/Documentation/acpi/apei/ |
| D | einj.txt | 174 …0 (channel:0 slot:0 page:0x12345 offset:0x0 grain:32 syndrome:0x0 - area:DRAM err_code:0001:0090 …
|
| /linux-4.1.27/Documentation/blockdev/ |
| D | README.DAC960 | 163 4MB/8MB EDRAM or 2MB/4MB/8MB/16MB/32MB DRAM Memory
167 4MB/8MB EDRAM or 2MB/4MB/8MB/16MB/32MB DRAM Memory
171 2MB/4MB/8MB/16MB/32MB DRAM Memory
175 2MB/4MB/8MB/16MB/32MB DRAM Memory
|
| /linux-4.1.27/include/video/ |
| D | mach64.h | 882 #define DRAM 1 macro
|
| /linux-4.1.27/Documentation/ |
| D | bus-virt-phys-mapping.txt | 132 of a video graphics card it can be normal DRAM that is just used for a frame
|
| D | edac.txt | 306 This attribute file will display what type of DRAM device is
|
| /linux-4.1.27/drivers/mtd/devices/ |
| D | Kconfig | 24 bool "PMC551 256M DRAM Bugfix"
|
| /linux-4.1.27/drivers/video/fbdev/aty/ |
| D | mach64_ct.c | 450 case DRAM: in aty_init_pll_ct()
|
| /linux-4.1.27/arch/alpha/ |
| D | Kconfig | 144 Address, CIA) - a 383 pin plastic PGA). It provides a DRAM
383 2 PCI, one pair are on a shared slot). Supports 36-bit DRAM SIMs.
|
| /linux-4.1.27/Documentation/virtual/kvm/ |
| D | timekeeping.txt | 64 |------>| CLOCK OUT | ---------> 66.3 KHZ DRAM
|
| /linux-4.1.27/Documentation/laptops/ |
| D | thinkpad-acpi.txt | 880 9: MCH (northbridge) to DRAM Bus
|
| /linux-4.1.27/drivers/video/fbdev/ |
| D | Kconfig | 1721 prompt "DRAM timing"
|
| /linux-4.1.27/arch/x86/ |
| D | Kconfig | 970 the DRAM Error Threshold.
|