1Device-Tree bindings for Samsung Exynos SoC display controller (DECON) 2 3DECON (Display and Enhancement Controller) is the Display Controller for the 4Exynos series of SoCs which transfers the image data from a video memory 5buffer to an external LCD interface. 6 7Required properties: 8- compatible: value should be "samsung,exynos5433-decon"; 9- reg: physical base address and length of the DECON registers set. 10- interrupts: should contain a list of all DECON IP block interrupts in the 11 order: VSYNC, LCD_SYSTEM. The interrupt specifier format 12 depends on the interrupt controller used. 13- interrupt-names: should contain the interrupt names: "vsync", "lcd_sys" 14 in the same order as they were listed in the interrupts 15 property. 16- clocks: must include clock specifiers corresponding to entries in the 17 clock-names property. 18- clock-names: list of clock names sorted in the same order as the clocks 19 property. Must contain "aclk_decon", "aclk_smmu_decon0x", 20 "aclk_xiu_decon0x", "pclk_smmu_decon0x", clk_decon_vclk", 21 "sclk_decon_eclk" 22- ports: contains a port which is connected to mic node. address-cells and 23 size-cells must 1 and 0, respectively. 24- port: contains an endpoint node which is connected to the endpoint in the mic 25 node. The reg value muset be 0. 26- i80-if-timings: specify whether the panel which is connected to decon uses 27 i80 lcd interface or mipi video interface. This node contains 28 no timing information as that of fimd does. Because there is 29 no register in decon to specify i80 interface timing value, 30 it is not needed, but make it remain to use same kind of node 31 in fimd and exynos7 decon. 32 33Example: 34SoC specific DT entry: 35decon: decon@13800000 { 36 compatible = "samsung,exynos5433-decon"; 37 reg = <0x13800000 0x2104>; 38 clocks = <&cmu_disp CLK_ACLK_DECON>, <&cmu_disp CLK_ACLK_SMMU_DECON0X>, 39 <&cmu_disp CLK_ACLK_XIU_DECON0X>, 40 <&cmu_disp CLK_PCLK_SMMU_DECON0X>, 41 <&cmu_disp CLK_SCLK_DECON_VCLK>, 42 <&cmu_disp CLK_SCLK_DECON_ECLK>; 43 clock-names = "aclk_decon", "aclk_smmu_decon0x", "aclk_xiu_decon0x", 44 "pclk_smmu_decon0x", "sclk_decon_vclk", "sclk_decon_eclk"; 45 interrupt-names = "vsync", "lcd_sys"; 46 interrupts = <0 202 0>, <0 203 0>; 47 48 ports { 49 #address-cells = <1>; 50 #size-cells = <0>; 51 52 port@0 { 53 reg = <0>; 54 decon_to_mic: endpoint { 55 remote-endpoint = <&mic_to_decon>; 56 }; 57 }; 58 }; 59}; 60 61Board specific DT entry: 62&decon { 63 i80-if-timings { 64 }; 65}; 66