1DesignWare HDMI bridge bindings
2
3Required properties:
4- compatible: platform specific such as:
5   * "snps,dw-hdmi-tx"
6   * "fsl,imx6q-hdmi"
7   * "fsl,imx6dl-hdmi"
8   * "rockchip,rk3288-dw-hdmi"
9- reg: Physical base address and length of the controller's registers.
10- interrupts: The HDMI interrupt number
11- clocks, clock-names : must have the phandles to the HDMI iahb and isfr clocks,
12  as described in Documentation/devicetree/bindings/clock/clock-bindings.txt,
13  the clocks are soc specific, the clock-names should be "iahb", "isfr"
14-port@[X]: SoC specific port nodes with endpoint definitions as defined
15   in Documentation/devicetree/bindings/media/video-interfaces.txt,
16   please refer to the SoC specific binding document:
17    * Documentation/devicetree/bindings/display/imx/hdmi.txt
18    * Documentation/devicetree/bindings/display/rockchip/dw_hdmi-rockchip.txt
19
20Optional properties
21- reg-io-width: the width of the reg:1,4, default set to 1 if not present
22- ddc-i2c-bus: phandle of an I2C controller used for DDC EDID probing
23- clocks, clock-names: phandle to the HDMI CEC clock, name should be "cec"
24
25Example:
26	hdmi: hdmi@0120000 {
27		compatible = "fsl,imx6q-hdmi";
28		reg = <0x00120000 0x9000>;
29		interrupts = <0 115 0x04>;
30		gpr = <&gpr>;
31		clocks = <&clks 123>, <&clks 124>;
32		clock-names = "iahb", "isfr";
33		ddc-i2c-bus = <&i2c2>;
34
35		port@0 {
36			reg = <0>;
37
38			hdmi_mux_0: endpoint {
39				remote-endpoint = <&ipu1_di0_hdmi>;
40			};
41		};
42
43		port@1 {
44			reg = <1>;
45
46			hdmi_mux_1: endpoint {
47				remote-endpoint = <&ipu1_di1_hdmi>;
48			};
49		};
50	};
51