1# 2# UWB device configuration 3# 4 5menuconfig UWB 6 tristate "Ultra Wideband devices" 7 default n 8 help 9 UWB is a high-bandwidth, low-power, point-to-point radio 10 technology using a wide spectrum (3.1-10.6GHz). It is 11 optimized for in-room use (480Mbps at 2 meters, 110Mbps at 12 10m). It serves as the transport layer for other protocols, 13 such as Wireless USB (WUSB). 14 15 The topology is peer to peer; however, higher level 16 protocols (such as WUSB) might impose a master/slave 17 relationship. 18 19 Say Y here if your computer has UWB radio controllers (USB or PCI) 20 based. You will need to enable the radio controllers 21 below. It is ok to select all of them, no harm done. 22 23 For more help check the UWB and WUSB related files in 24 <file:Documentation/usb/>. 25 26 To compile the UWB stack as a module, choose M here. 27 28if UWB 29 30config UWB_HWA 31 tristate "UWB Radio Control driver for WUSB-compliant USB dongles (HWA)" 32 depends on USB 33 help 34 This driver enables the radio controller for HWA USB 35 devices. HWA stands for Host Wire Adapter, and it is a UWB 36 Radio Controller connected to your system via USB. Most of 37 them come with a Wireless USB host controller also. 38 39 To compile this driver select Y (built in) or M (module). It 40 is safe to select any even if you do not have the hardware. 41 42config UWB_WHCI 43 tristate "UWB Radio Control driver for WHCI-compliant cards" 44 depends on PCI 45 help 46 This driver enables the radio controller for WHCI cards. 47 48 WHCI is a specification developed by Intel 49 (http://www.intel.com/technology/comms/wusb/whci.htm) much 50 in the spirit of USB's EHCI, but for UWB and Wireless USB 51 radio/host controllers connected via memory mapping (eg: 52 PCI). Most of these cards come also with a Wireless USB host 53 controller. 54 55 To compile this driver select Y (built in) or M (module). It 56 is safe to select any even if you do not have the hardware. 57 58config UWB_I1480U 59 tristate "Support for Intel Wireless UWB Link 1480 HWA" 60 depends on UWB_HWA 61 select FW_LOADER 62 help 63 This driver enables support for the i1480 when connected via 64 USB. It consists of a firmware uploader that will enable it 65 to behave as an HWA device. 66 67 To compile this driver select Y (built in) or M (module). It 68 is safe to select any even if you do not have the hardware. 69 70endif # UWB 71