1menu "Remoteproc drivers"
2
3# REMOTEPROC gets selected by whoever wants it
4config REMOTEPROC
5	tristate
6	depends on HAS_DMA
7	select CRC32
8	select FW_LOADER
9	select VIRTIO
10	select VIRTUALIZATION
11
12config OMAP_REMOTEPROC
13	tristate "OMAP remoteproc support"
14	depends on HAS_DMA
15	depends on ARCH_OMAP4 || SOC_OMAP5
16	depends on OMAP_IOMMU
17	select REMOTEPROC
18	select MAILBOX
19	select OMAP2PLUS_MBOX
20	select RPMSG
21	help
22	  Say y here to support OMAP's remote processors (dual M3
23	  and DSP on OMAP4) via the remote processor framework.
24
25	  Currently only supported on OMAP4.
26
27	  Usually you want to say y here, in order to enable multimedia
28	  use-cases to run on your platform (multimedia codecs are
29	  offloaded to remote DSP processors using this framework).
30
31	  It's safe to say n here if you're not interested in multimedia
32	  offloading or just want a bare minimum kernel.
33
34config STE_MODEM_RPROC
35	tristate "STE-Modem remoteproc support"
36	depends on HAS_DMA
37	select REMOTEPROC
38	default n
39	help
40	  Say y or m here to support STE-Modem shared memory driver.
41	  This can be either built-in or a loadable module.
42	  If unsure say N.
43
44config DA8XX_REMOTEPROC
45	tristate "DA8xx/OMAP-L13x remoteproc support"
46	depends on ARCH_DAVINCI_DA8XX
47	select CMA if MMU
48	select REMOTEPROC
49	select RPMSG
50	help
51	  Say y here to support DA8xx/OMAP-L13x remote processors via the
52	  remote processor framework.
53
54	  You want to say y here in order to enable AMP
55	  use-cases to run on your platform (multimedia codecs are
56	  offloaded to remote DSP processors using this framework).
57
58	  This module controls the name of the firmware file that gets
59	  loaded on the DSP.  This file must reside in the /lib/firmware
60	  directory.  It can be specified via the module parameter
61	  da8xx_fw_name=<filename>, and if not specified will default to
62	  "rproc-dsp-fw".
63
64	  It's safe to say n here if you're not interested in multimedia
65	  offloading.
66
67endmenu
68