1#
2# Myricom device configuration
3#
4
5config NET_VENDOR_MYRI
6	bool "Myricom devices"
7	default y
8	depends on PCI && INET
9	---help---
10	  If you have a network (Ethernet) card belonging to this class, say
11	  Y and read the Ethernet-HOWTO, available from
12	  <http://www.tldp.org/docs.html#howto>.
13
14	  Note that the answer to this question doesn't directly affect the
15	  kernel: saying N will just cause the configurator to skip all
16	  the questions about Myricom cards. If you say Y, you will be asked for
17	  your specific card in the following questions.
18
19if NET_VENDOR_MYRI
20
21config MYRI10GE
22	tristate "Myricom Myri-10G Ethernet support"
23	depends on PCI && INET
24	select FW_LOADER
25	select CRC32
26	---help---
27	  This driver supports Myricom Myri-10G Dual Protocol interface in
28	  Ethernet mode. If the eeprom on your board is not recent enough,
29	  you will need a newer firmware image.
30	  You may get this image or more information, at:
31
32	  <http://www.myri.com/scs/download-Myri10GE.html>
33
34	  To compile this driver as a module, choose M here. The module
35	  will be called myri10ge.
36
37config MYRI10GE_DCA
38	bool "Direct Cache Access (DCA) Support"
39	default y
40	depends on MYRI10GE && DCA && !(MYRI10GE=y && DCA=m)
41	---help---
42	  Say Y here if you want to use Direct Cache Access (DCA) in the
43	  driver.  DCA is a method for warming the CPU cache before data
44	  is used, with the intent of lessening the impact of cache misses.
45
46endif # NET_VENDOR_MYRI
47