1TI Wilink 6/7/8 (wl12xx/wl18xx) SDIO devices
2
3This node provides properties for controlling the wilink wireless device. The
4node is expected to be specified as a child node to the SDIO controller that
5connects the device to the system.
6
7Required properties:
8 - compatible: should be one of the following:
9    * "ti,wl1271"
10    * "ti,wl1273"
11    * "ti,wl1281"
12    * "ti,wl1283"
13    * "ti,wl1801"
14    * "ti,wl1805"
15    * "ti,wl1807"
16    * "ti,wl1831"
17    * "ti,wl1835"
18    * "ti,wl1837"
19 - interrupts : specifies attributes for the out-of-band interrupt.
20
21Optional properties:
22 - interrupt-parent : the phandle for the interrupt controller to which the
23	device interrupts are connected.
24 - ref-clock-frequency : ref clock frequency in Hz
25 - tcxo-clock-frequency : tcxo clock frequency in Hz
26
27Note: the *-clock-frequency properties assume internal clocks. In case of external
28clock, new bindings (for parsing the clock nodes) have to be added.
29
30Example:
31
32&mmc3 {
33	status = "okay";
34	vmmc-supply = <&wlan_en_reg>;
35	bus-width = <4>;
36	cap-power-off-card;
37	keep-power-in-suspend;
38
39	#address-cells = <1>;
40	#size-cells = <0>;
41	wlcore: wlcore@2 {
42		compatible = "ti,wl1835";
43		reg = <2>;
44		interrupt-parent = <&gpio0>;
45		interrupts = <19 IRQ_TYPE_LEVEL_HIGH>;
46	};
47};
48