1Cirrus Logic CLPS711X Interrupt Controller
2
3Required properties:
4
5- compatible: Should be "cirrus,clps711x-intc".
6- reg: Specifies base physical address of the registers set.
7- interrupt-controller: Identifies the node as an interrupt controller.
8- #interrupt-cells: Specifies the number of cells needed to encode an
9  interrupt source. The value shall be 1.
10
11The interrupt sources are as follows:
12ID	Name	Description
13---------------------------
141:	BLINT	Battery low (FIQ)
153:	MCINT	Media changed (FIQ)
164:	CSINT	CODEC sound
175:	EINT1	External 1
186:	EINT2	External 2
197:	EINT3	External 3
208:	TC1OI	TC1 under flow
219:	TC2OI	TC2 under flow
2210:	RTCMI	RTC compare match
2311:	TINT	64Hz tick
2412:	UTXINT1	UART1 transmit FIFO half empty
2513:	URXINT1	UART1 receive FIFO half full
2614:	UMSINT	UART1 modem status changed
2715:	SSEOTI	SSI1 end of transfer
2816:	KBDINT	Keyboard
2917:	SS2RX	SSI2 receive FIFO half or greater full
3018:	SS2TX	SSI2 transmit FIFO less than half empty
3128:	UTXINT2	UART2 transmit FIFO half empty
3229:	URXINT2	UART2 receive FIFO half full
3332:	DAIINT	DAI interface (FIQ)
34
35Example:
36	intc: interrupt-controller {
37		compatible = "cirrus,clps711x-intc";
38		reg = <0x80000000 0x4000>;
39		interrupt-controller;
40		#interrupt-cells = <1>;
41	};
42