/linux-4.4.14/Documentation/hwmon/ |
D | amc6821 | 61 which is rw. Below this temperature fan stops. 77 Below this temperature the fan stops in
|
D | g762 | 50 integer value between 0 and 255. 0 stops the fan, 255 makes 56 entry (0 stops the fan, 255 makes it run at full speed). In closed-loop mode
|
D | g760a | 22 Setting a period of 0 stops the fan; setting the period to 255 sets
|
D | thmc50 | 70 so it stops fans even if the value 0 into the ANALOG_OUT register does not.
|
/linux-4.4.14/Documentation/video4linux/ |
D | pxa_camera.txt | 27 Once the last buffer is filled in, the QCI interface stops. 138 - DMA controller finishes Videobuffer2, and DMA stops 168 Note: if DMA stops just after pxa_camera_check_link_miss() reads DDADR()
|
D | v4l2-controls.txt | 460 starts or stops streaming.
|
D | v4l2-framework.txt | 1099 * del: called when a listener stops listening
|
/linux-4.4.14/Documentation/thermal/ |
D | x86_pkg_temperature_thermal | 40 Setting 0, stops sending thermal notifications.
|
/linux-4.4.14/Documentation/isdn/ |
D | README.audio | 102 hangup of the remote side) Emulator stops 105 stops recording, sends DLE,ETX.
|
/linux-4.4.14/Documentation/networking/ |
D | netif-msg.txt | 24 3 Interface starts and stops, including normal status messages
|
D | cxacru.txt | 90 "restart" (stops, waits 1.5s, then starts)
|
D | operstates.txt | 87 set this flag. On netif_carrier_off(), the scheduler stops sending
|
/linux-4.4.14/arch/powerpc/boot/dts/ |
D | adder875-redboot.dts | 76 // Temporary until code stops depending on it.
|
D | adder875-uboot.dts | 75 // Temporary until code stops depending on it.
|
D | ep8248e.dts | 99 // Temporary until code stops depending on it.
|
D | mgcoge.dts | 106 // Temporary until code stops depending on it.
|
/linux-4.4.14/drivers/net/ethernet/chelsio/cxgb4vf/ |
D | adapter.h | 236 unsigned long stops; /* # of times queue has been stopped */ member
|
D | sge.c | 1141 txq->q.stops++; in txq_stop() 2480 txq->q.stops = 0; in t4vf_sge_alloc_eth_txq()
|
D | cxgb4vf_main.c | 1929 T("TxQFull:", q.stops); in sge_qstats_show()
|
/linux-4.4.14/drivers/net/ethernet/chelsio/cxgb3/ |
D | adapter.h | 184 unsigned long stops; /* # of times q has been stopped */ member
|
D | sge.c | 1211 q->stops++; in t3_stop_tx_queue() 1388 q->stops++; in check_desc_avail() 1500 q->stops++; in restart_ctrlq() 1705 q->stops++; in restart_offloadq()
|
/linux-4.4.14/Documentation/devicetree/bindings/mfd/ |
D | max14577.txt | 33 stops. Valid values:
|
/linux-4.4.14/Documentation/input/ |
D | ff.txt | 118 stops the effect if it was playing. 190 case, the driver stops the effect, up-load it, and restart it.
|
D | atarikbd.txt | 132 command in this mode not only stop the output but also temporarily stops 142 only stops the output but also temporarily stops scanning the button (samples 381 MONITORING mode, the PAUSE OUTPUT command also temporarily stops the
|
/linux-4.4.14/Documentation/filesystems/ |
D | quota.txt | 59 - four warnings are also defined for the event when user stops
|
/linux-4.4.14/Documentation/x86/x86_64/ |
D | machinecheck | 41 the polling interval. When the poller stops finding MCEs, it
|
/linux-4.4.14/Documentation/dmaengine/ |
D | dmatest.txt | 38 stops.
|
/linux-4.4.14/drivers/net/ethernet/chelsio/cxgb4/ |
D | sge.c | 1088 q->q.stops++; in eth_txq_stop() 1359 q->q.stops++; in ctrlq_check_stop() 1439 unsigned long old = q->q.stops; in restart_ctrlq() 1442 if (q->q.stops != old) { /* suspended anew */ in restart_ctrlq() 1522 q->q.stops++; in txq_stop_maperr() 1540 q->q.stops++; in ofldtxq_stop() 2631 q->stops = q->restarts = 0; in init_txq()
|
D | cxgb4.h | 589 unsigned long stops; /* # of times q has been stopped */ member
|
D | cxgb4_debugfs.c | 2323 TL("TxQFull:", q.stops); in sge_qinfo_show() 2421 TL("TxQFull:", q.stops); in sge_qinfo_show()
|
/linux-4.4.14/Documentation/sound/alsa/soc/ |
D | codec.txt | 161 minimise any system noise. The mute stops any digital data from
|
/linux-4.4.14/Documentation/locking/ |
D | locktorture.txt | 11 and stops when the module is unloaded. This program is based on how RCU
|
/linux-4.4.14/Documentation/video4linux/cx2341x/ |
D | fw-decoder-api.txt | 32 playback stops at specified PTS.
|
/linux-4.4.14/Documentation/usb/ |
D | error-codes.txt | 78 one or more packets could finish before an error stops further endpoint I/O.
|
/linux-4.4.14/Documentation/i2c/ |
D | slave-interface | 107 still shifted out. If the master sends NACK and stops reading after the byte
|
/linux-4.4.14/Documentation/acpi/ |
D | method-tracing.txt | 64 the "trace points" the AML interpreter starts/stops to execute a control
|
/linux-4.4.14/Documentation/security/ |
D | keys-request-key.txt | 169 The process stops immediately a valid key is found with permission granted to
|
/linux-4.4.14/Documentation/ |
D | memory-hotplug.txt | 435 MEM_ONLINE, or MEM_OFFLINE action to cancel hotplugging. It stops 438 NOTIFY_STOP stops further processing of the notification queue.
|
D | assoc_array.txt | 320 return the result of the last iterator function called. Iteration stops
|
D | xillybus.txt | 281 stops momentarily before a DMA buffer is filled, the intuitive expectation is
|
D | applying-patches.txt | 135 If patch stops and presents a "File to patch:" prompt, then patch could not
|
D | md.txt | 273 When written, doesn't tear down array, but just stops it
|
D | DMA-API.txt | 649 before it stops. This number is initialized to
|
/linux-4.4.14/Documentation/powerpc/ |
D | transactional_memory.txt | 193 GDB and ptrace are not currently TM-aware. If one stops during a transaction,
|
/linux-4.4.14/Documentation/power/ |
D | charger-manager.txt | 90 the timer (CM uses jiffies as timer) stops during suspend. Then, CM
|
/linux-4.4.14/Documentation/s390/ |
D | s390dbf.txt | 90 The second trigger which stops the debug feature is a kernel oops. 177 Description: stops the debug feature if stopping is allowed. Currently
|
D | Debugging390.txt | 1602 display: prints variable or register each time program stops
|
/linux-4.4.14/Documentation/sound/alsa/ |
D | OSS-Emulation.txt | 180 filled. The latter stops writing the silence data ahead
|
/linux-4.4.14/Documentation/sysctl/ |
D | fs.txt | 192 on systems without separated partitions, this stops unauthorized users
|
D | vm.txt | 803 Allowing zone reclaim to write out pages stops processes that are
|
/linux-4.4.14/Documentation/frv/ |
D | mmu-layout.txt | 212 (*) Every time the kernel stops, certain state information is dumped into __debug_mmu. This
|
/linux-4.4.14/arch/arm/boot/dts/ |
D | dra72-evm.dts | 464 * VIN2_S0 driven high otherwise Ethernet stops working
|
/linux-4.4.14/Documentation/RCU/ |
D | torture.txt | 11 when the module is loaded, and stops when the module is unloaded.
|
/linux-4.4.14/tools/perf/ |
D | design.txt | 425 non-leader stops that counter from counting but doesn't affect any
|
/linux-4.4.14/Documentation/blockdev/ |
D | paride.txt | 139 a parallel port IDE adapter. Once it finds one, the probe stops. So,
|
D | README.DAC960 | 359 Note that the flush-cache command also stops an asynchronous rebuild or
|
/linux-4.4.14/arch/s390/ |
D | Kconfig | 797 Writing 1 or 0 to /proc/appldata/timer starts(1) or stops(0) the timer,
|
/linux-4.4.14/kernel/trace/ |
D | Kconfig | 482 zero is entered, profiling stops. A "functions" file is created in
|
/linux-4.4.14/Documentation/scsi/ |
D | ChangeLog.megaraid_sas | 495 is 2 or greater,the driver stops sending cmd to FW temporarily. IO is
|
D | sym53c8xx_2.txt | 184 SCRIPTS (avoids the phase mismatch interrupt that stops the SCSI processor
|
D | ncr53c8xx.txt | 207 SCRIPTS (avoids the phase mismatch interrupt that stops the SCSI processor
|
D | ChangeLog.lpfc | 1552 els_timeout routine. It now stops all timeout routines
|
/linux-4.4.14/Documentation/laptops/ |
D | thinkpad-acpi.txt | 1156 stops the fan. The higher the level, the higher the fan speed, although 1201 Note that the watchdog timer stops after it enables the fan. It will be
|
/linux-4.4.14/Documentation/vm/ |
D | unevictable-lru.txt | 542 stops there.
|
/linux-4.4.14/Documentation/kbuild/ |
D | makefiles.txt | 562 explaining to the user why it stops.
|
/linux-4.4.14/Documentation/virtual/uml/ |
D | UserModeLinux-HOWTO.txt | 3980 processing stops, which means that the 'root=' argument that UML 4086 it when it stops in start_kernel and make it crash. Now ^C gdb and
|
/linux-4.4.14/lib/ |
D | Kconfig.debug | 904 writing 0 stops it. This feature is useful to collect information
|
/linux-4.4.14/Documentation/devicetree/ |
D | booting-without-of.txt | 427 This is the version of this structure. Version 1 stops
|