Searched refs:proximity (Results 1 – 22 of 22) sorted by relevance
16 BH1770GLC and SFH7770 are combined ambient light and proximity sensors.17 ALS and proximity parts operates on their own, but they shares common I2C19 but ALS side results are used to estimate reliability of the proximity sensor.25 amount of reflected IR light and produces proximity result. Resolution is27 reliability of the proximity results. Thus ALS is always running while28 proximity detection is needed.32 by using a delayed work. As long as there is proximity threshold above33 interrupts the delayed work is pushed forward. So, when proximity level goes35 finally run. This is handled as no proximity indication.86 RO - measured proximity value[all …]
16 APDS990x is a combined ambient light and proximity sensor. ALS and proximity18 while the proximity functionality is enabled.88 RO - measured proximity value95 RW - enable / disable proximity - uses counting logic96 1 enables the proximity97 0 disables the proximity101 values: 0 or prox0_sensor_range value. 0 means no proximity,102 1023 means proximity. This causes minimal number of interrupts.111 RW - threshold level which trigs proximity events.
7 tristate "ISL 29018 light and proximity sensor"13 proximity infrared sensing from Intersil ISL29018.15 in lux, proximity infrared sensing and normal infrared sensing.26 of ambient light and proximity.36 tristate "TAOS TSL/TMD2x71 and TSL/TMD2x72 Family of light and proximity sensors"
54 tristate "Avago APDS9960 gesture/RGB/ALS/proximity sensor"61 APDS9960 gesture/RGB/ALS/proximity sensor.113 This option enables proximity & RGB sensor using127 Say Y here if you have a Sharp GP2AP020A00F proximity/ALS combo-chip174 tristate "JSA1212 ALS and proximity sensor driver"179 proximity & ALS sensor device.185 tristate "ROHM RPR0521 ALS and proximity sensor driver"190 ambient light and proximity sensor device.220 ambient light and proximity sensor. This driver also supports LTR-559237 tristate "TXC PA12203001 light and proximity sensor"[all …]
36 tristate "SX9500 Semtech proximity sensor"43 proximity/button sensor.
42 in proximity mode. When this is enabled, then the device should44 proximity reading. If this is not enabled, the driver can still52 This property is supported by proximity sensors and should be
28 obj-y += proximity/
65 source "drivers/iio/proximity/Kconfig"
1 * Avago APDS9960 gesture/RGB/ALS/proximity sensor
3 The proximity detector sensor requires power supply
9 of the cm36651 for proximity detection.
50 the proximity of the ADIN2 pin to the OV pin. ADIN2 is, however, not available
362 SFH7770 (Osram) combined ambient light and proximity sensor chip.368 tristate "APDS990X combined als and proximity sensors"373 combined ambient light and proximity sensor chip.
343 /* ALS and proximity sensor */
347 /* ALS and proximity sensor */
173 proximity of the device and while the value of the BTN_TOUCH code is 0. If
154 are in radio proximity to allow drivers to connect to them. As well, it
660 !rtlpriv->proximity.proxim_on) { in rtl_op_config()
2629 struct proxim proximity; member
2219 rtlpriv->proximity.proxim_on = false; in rtl_pci_probe()
252 Say Y here if you have a Sharp GP2AP002A00F proximity/als combo-chip
1236 to SI units is not possible. Higher proximity measurements