Home
last modified time | relevance | path

Searched refs:dd_dev_err (Results 1 – 20 of 20) sorted by relevance

/linux-4.4.14/drivers/staging/rdma/hfi1/
Dpcie.c186 dd_dev_err(dd, "chip PIO range does not match\n"); in hfi1_pcie_ddinit()
275 dd_dev_err(dd, "Transaction Pending bit is not clearing, proceeding with reset anyway\n"); in hfi1_pcie_flr()
320 dd_dev_err(dd, "pci_enable_msix_range %d vectors failed: %d, falling back to INTx\n", in msix_setup()
374 dd_dev_err(dd, "Can't find PCI Express capability!\n"); in pcie_speeds()
402 dd_dev_err(dd, "PCIe width %u (x16 HFI)\n", dd->lbus_width); in pcie_speeds()
756 dd_dev_err(dd, in load_eq_table()
758 dd_dev_err(dd, " prec attn post\n"); in load_eq_table()
760 dd_dev_err(dd, " p%02d: %02x %02x %02x\n", in load_eq_table()
762 dd_dev_err(dd, " %02x %02x %02x\n", in load_eq_table()
810 dd_dev_err(dd, "%s: no parent device\n", __func__); in trigger_sbr()
[all …]
Dpio.c126 dd_dev_err(dd, "%s: invalid control %d\n", __func__, op); in pio_send_control()
256 dd_dev_err( in init_sc_pools_and_sizes()
269 dd_dev_err( in init_sc_pools_and_sizes()
277 dd_dev_err( in init_sc_pools_and_sizes()
286 dd_dev_err( in init_sc_pools_and_sizes()
319 dd_dev_err( in init_sc_pools_and_sizes()
342 dd_dev_err( in init_sc_pools_and_sizes()
353 dd_dev_err( in init_sc_pools_and_sizes()
363 dd_dev_err( in init_sc_pools_and_sizes()
380 dd_dev_err( in init_sc_pools_and_sizes()
[all …]
Dfirmware.c263 dd_dev_err(dd, "timeout reading 8051 data\n"); in __read_8051_data()
348 dd_dev_err(dd, "timeout writing 8051 data\n"); in write_8051()
369 dd_dev_err(dd, in invalid_header()
407 dd_dev_err(dd, in payload_check()
431 dd_dev_err(dd, "cannot load firmware \"%s\", err %d\n", in obtain_one_firmware()
438 dd_dev_err(dd, "firmware \"%s\" is too small\n", name); in obtain_one_firmware()
500 …dd_dev_err(dd, "driver is unable to validate firmware without r2 and mu (not in firmware file)\n"); in obtain_one_firmware()
524 dd_dev_err(dd, in obtain_one_firmware()
707 dd_dev_err(dd, "%s security engine not idle - giving up\n", in run_rsa()
744 dd_dev_err(dd, "%s firmware security bad idle state\n", in run_rsa()
[all …]
Deprom.c150 dd_dev_err(dd, "waited too long for SPI FLASH busy to clear - failing\n"); in wait_for_not_busy()
201 dd_dev_err(dd, in erase_32kb_range()
346 dd_dev_err(dd, in handle_eprom_command()
416 dd_dev_err(dd, "%s: unexpected command %d\n", in handle_eprom_command()
452 dd_dev_err(dd, in eprom_init()
Dsdma.c328 …dd_dev_err(dd, "%s: engine %u timeout waiting for packets to egress, remaining count %u, bouncing … in sdma_wait_for_packet_egress()
408 dd_dev_err(sde->dd, "expected %llu got %llu\n", in sdma_flush()
458 dd_dev_err(sde->dd, in sdma_err_halt_wait()
493 dd_dev_err(sde->dd, in sdma_err_progress_check_schedule()
505 dd_dev_err(sde->dd, "SDE progress check event\n"); in sdma_err_progress_check()
546 dd_dev_err(sde->dd, "CONFIG SDMA(%u) %s:%d %s()\n", in sdma_hw_clean_up_task()
598 dd_dev_err(sde->dd, "expected %llu got %llu\n", in sdma_flush_descq()
1148 dd_dev_err(dd, "failed to allocate SendDMA head memory\n"); in sdma_init()
1160 dd_dev_err(dd, "failed to allocate SendDMA pad memory\n"); in sdma_init()
1261 dd_dev_err(dd, "sde %u: dmawait list not empty!\n", in sdma_exit()
[all …]
Dchip.c1286 dd_dev_err(dd, "Invalid cntr register access mode"); in read_write_csr()
1341 dd_dev_err(dd, "Could not acquire LCB for counter 0x%x", csr); in dc_access_lcb_cntr()
1391 dd_dev_err(dd, "Invalid cntr sw access mode"); in read_write_sw()
1482 dd_dev_err(dd, "Per CPU cntrs can only be zeroed"); in read_write_cpu()
1484 dd_dev_err(dd, "Invalid cntr sw cpu access mode"); in read_write_cpu()
2434 dd_dev_err(dd, "Repeating %s bits 0x%llx - masking\n", in interrupt_clear_down()
2458 dd_dev_err(dd, "Unexpected misc interrupt (%u) - reserved\n", in is_misc_err_int()
2489 dd_dev_err(dd, in is_sendctxt_err_int()
2497 dd_dev_err(dd, "%s: context %u(%u): no sc?\n", __func__, in is_sendctxt_err_int()
2528 dd_dev_err(sde->dd, "CONFIG SDMA(%u) %s:%d %s()\n", sde->this_idx, in handle_sdma_eng_err()
[all …]
Dtwsi.c133 dd_dev_err(dd, "SCL interface stuck low > %d uSec\n", in scl_out()
322 dd_dev_err(dd, "GPIO pins not at rest: %d\n", in hfi1_twsi_reset()
403 dd_dev_err(dd, in hfi1_twsi_blk_rd()
470 dd_dev_err(dd, in hfi1_twsi_blk_wr()
Dsysfs.c610 dd_dev_err(dd, in hfi1_create_port_files()
620 dd_dev_err(dd, in hfi1_create_port_files()
630 dd_dev_err(dd, in hfi1_create_port_files()
640 dd_dev_err(dd, in hfi1_create_port_files()
651 dd_dev_err(dd, in hfi1_create_port_files()
662 dd_dev_err(dd, in hfi1_create_port_files()
671 dd_dev_err(dd, in hfi1_create_port_files()
Dinit.c148 dd_dev_err(dd, in hfi1_create_ctxts()
165 dd_dev_err(dd, in hfi1_create_ctxts()
174 dd_dev_err(dd, in hfi1_create_ctxts()
254 dd_dev_err(dd, in hfi1_create_ctxtdata()
278 dd_dev_err(dd, "ctxt%u: requested too many RcvArray entries.\n", in hfi1_create_ctxtdata()
712 dd_dev_err(dd, in hfi1_init()
723 dd_dev_err(dd, "Failed to allocate user events page\n"); in hfi1_init()
730 dd_dev_err(dd, "Failed to allocate dev status page\n"); in hfi1_init()
1401 dd_dev_err(dd, "Failed to create /dev devices: %d\n", -j); in init_one()
1483 dd_dev_err(dd, in hfi1_create_rcvhdrq()
[all …]
Ddriver.c983 dd_dev_err(dd, "%s: cannot stop/drain VLs - refusing to change per-VL MTUs\n", in set_mtu()
1150 dd_dev_err(dd, in hfi1_reset_device()
1166 dd_dev_err(rcd->dd, in handle_eflags()
1211 dd_dev_err(packet->rcd->dd, in process_receive_bypass()
1221 dd_dev_err(packet->rcd->dd, in process_receive_error()
1232 dd_dev_err(packet->rcd->dd, in kdeth_process_expected()
1242 dd_dev_err(packet->rcd->dd, in kdeth_process_eager()
1249 dd_dev_err(packet->rcd->dd, "Invalid packet type %d. Dropping\n", in process_receive_invalid()
Ddiag.c289 dd_dev_err(dd, "Unable to init snoop/capture device"); in hfi1_diag_add()
395 dd_dev_err(dd, "Invalid version %u for diagpkt_write\n", in diagpkt_send()
599 dd_dev_err(dd, "Couldn't create %s device: %d", name, ret); in hfi1_snoop_add()
1567 dd_dev_err(ppd->dd, "Unable to copy header to snoop/capture packet\n"); in snoop_recv_handler()
1695 dd_dev_err(ppd->dd, in snoop_send_pio_handler()
Dverbs.c1364 dd_dev_err(dd, "CONFIG SDMA %s:%d %s()\n", in hfi1_verbs_send()
1366 dd_dev_err(dd, "SDMA hdrwords = %u, len = %u\n", hdrwords, len); in hfi1_verbs_send()
2109 dd_dev_err(dd, "cannot register verbs: %d!\n", -ret); in hfi1_register_ib_device()
2126 dd_dev_err(dd, "txwait list not empty!\n"); in hfi1_unregister_ib_device()
2128 dd_dev_err(dd, "memwait list not empty!\n"); in hfi1_unregister_ib_device()
2130 dd_dev_err(dd, "DMA MR not NULL!\n"); in hfi1_unregister_ib_device()
Duser_sdma.c403 dd_dev_err(dd, "[%u] Failed to allocate TxReq cache\n", in hfi1_user_sdma_alloc_queues()
948 dd_dev_err(pq->dd, in user_sdma_send_pkts()
1384 dd_dev_err(pq->dd, "SDMA completion with error %d", status); in user_sdma_txreq_cb()
Dqsfp.c160 dd_dev_err(dd, "I2C interface bus stuck non-idle\n"); in __i2c_read()
Dmr.c329 dd_dev_err( in hfi1_dereg_mr()
Dfile_ops.c570 dd_dev_err(dd, "Eager buffer map size invalid (%lu != %lu)\n", in hfi1_file_mmap()
1008 dd_dev_err(dd, in allocate_ctxt()
1595 dd_dev_err(dd, "Fail vaddr %p, %u pages, !access_ok\n", in exp_tid_setup()
Dud.c857 dd_dev_err(dd, "QP type %d mgmt_pkey_idx < 0 and packet not dropped???\n", in hfi1_ud_rcv()
Dhfi.h1766 #define dd_dev_err(dd, fmt, ...) \ macro
Dqp.c1505 dd_dev_err(dd, "QP memory leak! %u still in use\n", in hfi1_qp_exit()
Dmad.c498 dd_dev_err(dd, "%s: unable to read LTP RTT\n", __func__); in read_ltp_rtt()