| /linux-4.4.14/include/linux/ |
| D | cpu_cooling.h | 44 u32 capacitance, get_static_t plat_static_func);
59 u32 capacitance,
72 u32 capacitance, in of_cpufreq_power_cooling_register() argument
94 u32 capacitance, get_static_t plat_static_func) in cpufreq_power_cooling_register() argument
109 u32 capacitance, in of_cpufreq_power_cooling_register() argument
|
| /linux-4.4.14/drivers/thermal/ |
| D | cpu_cooling.c | 270 u32 capacitance) in build_dyn_power_table() argument
321 power = (u64)capacitance * freq_mhz * voltage_mv * voltage_mv; in build_dyn_power_table()
787 const struct cpumask *clip_cpus, u32 capacitance, in __cpufreq_cooling_register() argument
840 if (capacitance) { in __cpufreq_cooling_register()
847 ret = build_dyn_power_table(cpufreq_dev, capacitance); in __cpufreq_cooling_register()
977 cpufreq_power_cooling_register(const struct cpumask *clip_cpus, u32 capacitance, in cpufreq_power_cooling_register() argument
980 return __cpufreq_cooling_register(NULL, clip_cpus, capacitance, in cpufreq_power_cooling_register()
1011 u32 capacitance, in of_cpufreq_power_cooling_register() argument
1017 return __cpufreq_cooling_register(np, clip_cpus, capacitance, in of_cpufreq_power_cooling_register()
|
| /linux-4.4.14/arch/arm/mach-omap2/ |
| D | vc.c | 612 u32 capacitance; in omap4_vc_i2c_timing_init() local
623 capacitance = DIV_ROUND_UP(sr_i2c_pcb_length, 8); in omap4_vc_i2c_timing_init()
626 capacitance += 4; in omap4_vc_i2c_timing_init()
629 capacitance += voltdm->pmic->i2c_pad_load; in omap4_vc_i2c_timing_init()
634 while (i2c_data->load > capacitance) in omap4_vc_i2c_timing_init()
|
| /linux-4.4.14/Documentation/devicetree/bindings/net/ieee802154/ |
| D | at86rf230.txt | 15 - xtal-trim: u8 value for fine tuning the internal capacitance
|
| /linux-4.4.14/Documentation/thermal/ |
| D | cpu-cooling-api.txt | 40 const struct cpumask *clip_cpus, u32 capacitance,
49 models). "capacitance" is the dynamic power coefficient (See 2.1
54 struct device_node *np, const struct cpumask *clip_cpus, u32 capacitance,
116 Where `capacitance` is a constant that represents an indicative
|
| /linux-4.4.14/Documentation/devicetree/bindings/iio/adc/ |
| D | vf610-adc.txt | 22 source resistance (R_as) and capacitance (C_as). Refer the datasheet's
|
| /linux-4.4.14/Documentation/devicetree/bindings/spi/ |
| D | spi-rockchip.txt | 28 Rx data (may need to be fine tuned for high capacitance lines).
|
| /linux-4.4.14/Documentation/devicetree/bindings/input/ |
| D | cap11xx.txt | 26 smaller delta capacitance is required to
|
| D | ads7846.txt | 36 a function of Vcc and the capacitance
|
| /linux-4.4.14/Documentation/devicetree/bindings/display/ |
| D | ssd1307fb.txt | 27 This needs to be the higher, the higher the capacitance
|
| /linux-4.4.14/Documentation/devicetree/bindings/regulator/ |
| D | regulator.txt | 23 and board design issues such as trace capacitance and load on the supply.
|
| /linux-4.4.14/Documentation/ |
| D | pinctrl.txt | 12 load capacitance etc.
20 can control PINs. It may be able to multiplex, bias, set load capacitance,
|
| /linux-4.4.14/Documentation/spi/ |
| D | spi-summary | 292 changed by the capacitance at one pin.
|
| /linux-4.4.14/Documentation/ABI/testing/ |
| D | sysfs-bus-iio | 118 Raw capacitance measurement from channel Y. Units after
125 Raw differential capacitance measurement equivalent to
|