/linux-4.4.14/drivers/net/wireless/iwlwifi/mvm/ |
H A D | fw-api-rx.h | 87 * @system_timestamp: GP2 at on air rise 88 * @timestamp: TSF at on air rise 89 * @beacon_time_stamp: beacon at on-air rise 95 * @frame_time: frame's time on the air, based on byte count and frame rate
|
H A D | fw-api-tx.h | 508 * @bitmap: the bitmap of the BA notification as seen in the air
|
/linux-4.4.14/drivers/net/wireless/ath/ath10k/ |
H A D | pci.h | 117 * "coming IN over air through Target to Host" as with a WiFi Rx operation. 118 * Conversely, PIPEDIR_OUT means "going OUT from Host through Target over air"
|
H A D | wmi.h | 4532 * scheduler air time limit for this VDEV. used by off chan 4663 * scheduler air time limit for this VDEV. used by off chan 5007 * chainmask yields no beacons on the air at all.
|
H A D | mac.c | 4389 * because hw could beacon some random data on the air. On ath10k_add_interface()
|
/linux-4.4.14/drivers/macintosh/ |
H A D | windfarm_lm75_sensor.c | 114 name = "incoming-air-temp"; wf_lm75_probe()
|
H A D | windfarm_pm121.c | 937 all = pm121_register_sensor(sr, "incoming-air-temp", pm121_new_sensor()
|
/linux-4.4.14/drivers/net/wireless/ath/ath9k/ |
H A D | dynack.c | 282 /* ackto = slottime + sifs + air delay */ ath_dynack_node_init() 317 /* ackto = slottime + sifs + air delay */ ath_dynack_reset()
|
H A D | mac.c | 88 * before the PCU will initiate sending the frame on the air. This can
|
/linux-4.4.14/drivers/staging/rtl8723au/include/ |
H A D | odm.h | 165 /* In SWAW_STEP_PEAK, driver needs to switch antenna and listen to the signal on the air. */ 809 /* In SWAW_STEP_PEAK, driver needs to switch antenna and listen to the signal on the air. */
|
H A D | rtl8723a_spec.h | 1821 * by 25,000 microseconds of NAV through sending CTS in the air. We
|
/linux-4.4.14/drivers/uwb/ |
H A D | lc-dev.c | 375 * A device went off the air, clean up after it! 399 * A device went on the air, start it up!
|
/linux-4.4.14/drivers/net/wireless/ti/wl1251/ |
H A D | tx.h | 182 * Total air access duration consumed by this
|
/linux-4.4.14/drivers/net/wireless/ti/wlcore/ |
H A D | tx.h | 167 /* Total air access duration including all retrys and overheads.*/
|
/linux-4.4.14/include/net/sctp/ |
H A D | command.h | 116 * thin air in the hopes othat we don't trigger a kernel panic.
|
/linux-4.4.14/drivers/staging/rtl8188eu/include/ |
H A D | odm.h | 186 * the signal on the air. */ 1070 * signal on the air. */
|
H A D | rtl8188e_spec.h | 350 * by 25,000 microseconds of NAV through sending CTS in the air.
|
/linux-4.4.14/drivers/net/ethernet/i825xx/ |
H A D | sun3_82586.h | 23 #define IEOB_ONAIR 0x40 /* put us on the air */
|
/linux-4.4.14/drivers/staging/wilc1000/ |
H A D | host_interface.h | 897 * @brief Sends a beacon to the firmware to be transmitted over the air 900 * @param[in] u32Interval Beacon Interval. Period between two successive beacons on air 925 * @brief Removes the beacon and stops trawilctting it over the air
|
H A D | linux_wlan.c | 845 c_val[0] = 1; /* TXOP Prot disable in N mode: No RTS-CTS on TX A-MPDUs to save air-time. */ linux_wlan_init_test_config()
|
/linux-4.4.14/drivers/atm/ |
H A D | iphase.c | 382 u16 adtf, air, *ptr16; ia_open_abr_vc() local 448 air = srv_p->pcr << (15 - srv_p->rif); ia_open_abr_vc() 449 if (air == 0) air = 1; ia_open_abr_vc() 450 r_abr_vc->r_air = cellrate_to_float(air); ia_open_abr_vc() 1586 abr_vc_table->air = 0x5eb1; rx_init() 2672 abr_vc_table->air = 0x5eb1; ia_close()
|
H A D | iphase.h | 225 u_short air; member in struct:abr_vc_table
|
/linux-4.4.14/arch/s390/include/asm/ |
H A D | kvm_host.h | 33 * which we don't use. 4096 is an out-of-thin-air value. If we need
|
/linux-4.4.14/drivers/net/ieee802154/ |
H A D | mrf24j40.c | 743 /* Turn back on reception of packets off the air. */ mrf24j40_handle_rx_read_buf_unlock() 822 /* Turn off reception of packets off the air. This prevents the mrf24j40_handle_rx()
|
H A D | atusb.c | 41 #define ATUSB_TX_TIMEOUT_MS 200 /* on the air timeout */
|
/linux-4.4.14/include/linux/ |
H A D | ieee80211.h | 2173 * - Coverage class - index into air propagation time (Table 7-27), 2174 * in microseconds, you can compute the air propagation time from 2177 * yet. A value of 0 inicates air propagation of <= 1 us.
|
/linux-4.4.14/drivers/net/ethernet/sfc/ |
H A D | falcon_boards.c | 30 /* Board temperature is about 15°C above ambient when air flow is
|
H A D | mcdi_pcol.h | 3864 /* enum: air flow: bool */
|
/linux-4.4.14/include/net/bluetooth/ |
H A D | l2cap.h | 345 * ever be sent over the air. Therefore, use a value that's unlikely to
|
/linux-4.4.14/drivers/net/wireless/ath/ath6kl/ |
H A D | txrx.c | 1574 * OS stack as well as on the air. ath6kl_rx() 1581 * frame to it on the air else send the ath6kl_rx()
|
/linux-4.4.14/drivers/media/tuners/ |
H A D | xc5000.c | 879 /* Fix me: it could be air. */ xc5000_config_tv()
|
H A D | xc4000.c | 1415 /* FIXME: it could be air. */ xc4000_set_analog_params()
|
H A D | r820t.c | 1454 /* lna off (air-in off) */ r820t_imr_prepare()
|
/linux-4.4.14/drivers/net/wireless/hostap/ |
H A D | hostap_80211_rx.c | 715 * IEEE 802.11 format, i.e., in the format it was sent over air.
|
/linux-4.4.14/drivers/net/usb/ |
H A D | sierra_net.c | 78 u16 link_up; /* air link up or down */
|
/linux-4.4.14/drivers/net/wireless/ath/wil6210/ |
H A D | wil6210.h | 75 * as it will go over the air, and need to be 8 byte aligned
|
/linux-4.4.14/fs/cachefiles/ |
H A D | rdwr.c | 206 /* let the thread pool have some air occasionally */ cachefiles_read_copier()
|
/linux-4.4.14/include/net/ |
H A D | wimax.h | 156 * that is kind of left up in the air to common sense.
|
H A D | mac80211.h | 61 * sent over the air except for the FCS which should be calculated by the
|
/linux-4.4.14/drivers/net/wireless/ipw2x00/ |
H A D | libipw_rx.c | 330 * IEEE 802.11 format, i.e., in the format it was sent over air.
|
H A D | ipw2200.c | 5432 /* TODO: Look at sniffed packets in the air to determine if the basic rate
|
/linux-4.4.14/drivers/net/wan/ |
H A D | z85230.c | 696 * A Z85[2]30 device has stuck its hand in the air for attention.
|
/linux-4.4.14/drivers/net/wireless/iwlegacy/ |
H A D | commands.h | 1226 __le64 timestamp; /* TSF at on air rise */ 1227 __le32 beacon_time_stamp; /* beacon at on-air rise */ 1233 __le16 frame_time; /* frame's time on the air */
|
/linux-4.4.14/drivers/net/wireless/iwlwifi/dvm/ |
H A D | commands.h | 1114 __le64 timestamp; /* TSF at on air rise */ 1115 __le32 beacon_time_stamp; /* beacon at on-air rise */ 1121 __le16 frame_time; /* frame's time on the air */
|
/linux-4.4.14/net/mac80211/ |
H A D | ieee80211_i.h | 410 u32 admitted_time; /* in usecs, unlike over the air */
|
/linux-4.4.14/drivers/staging/rtl8192e/ |
H A D | rtllib_rx.c | 1525 * IEEE 802.11 format, i.e., in the format it was sent over air.
|
/linux-4.4.14/drivers/staging/rtl8192u/ieee80211/ |
H A D | ieee80211_rx.c | 877 * IEEE 802.11 format, i.e., in the format it was sent over air.
|
/linux-4.4.14/drivers/net/wireless/ |
H A D | mac80211_hwsim.c | 14 * competition for "air time" at TBTT
|
/linux-4.4.14/net/batman-adv/ |
H A D | translation-table.c | 458 * size when transmitted over the air
|
/linux-4.4.14/drivers/net/wireless/brcm80211/brcmfmac/ |
H A D | cfg80211.c | 1867 * beacon from target AP at a noisy air only during connect brcmf_cfg80211_connect()
|
/linux-4.4.14/drivers/net/wireless/brcm80211/brcmsmac/ |
H A D | main.c | 669 /* calc ceiling of bits/rate = microseconds of air time */ brcms_c_calc_frame_time()
|
/linux-4.4.14/drivers/net/ethernet/broadcom/bnx2x/ |
H A D | bnx2x_main.c | 14433 * and in the air. We also check that number of outstanding bnx2x_cnic_sp_post()
|