| /linux-4.4.14/drivers/pinctrl/ |
| D | pinctrl-lpc18xx.c | 231 LPC_P(1,3, GPIO, CTOUT, SGPIO, EMC, USB0, SSP1, R, SDMMC, 0, ND);
232 LPC_P(1,4, GPIO, CTOUT, SGPIO, EMC, USB0, SSP1, R, SDMMC, 0, ND);
233 LPC_P(1,5, GPIO, CTOUT, R, EMC, USB0, SSP1, SGPIO, SDMMC, 0, ND);
235 LPC_P(1,7, GPIO, UART1, CTOUT, EMC, USB0, R, R, R, 0, ND);
249 LPC_P(2,0, SGPIO, UART0, EMC, USB0, GPIO, R, TIMER3, ENET, 0, ND);
250 LPC_P(2,1, SGPIO, UART0, EMC, USB0, GPIO, R, TIMER3, R, 0, ND);
251 LPC_P(2,2, SGPIO, UART0, EMC, USB0, GPIO, CTIN, TIMER3, R, 0, ND);
252 LPC_P(2,3, SGPIO, I2C1, UART3, CTIN, GPIO, R, TIMER3, USB0, 0, HD);
253 LPC_P(2,4, SGPIO, I2C1, UART3, CTIN, GPIO, R, TIMER3, USB0, 0, HD);
254 LPC_P(2,5, SGPIO, CTIN, USB1, ADCTRIG, GPIO, R, TIMER3, USB0, 0, HD);
[all …]
|
| /linux-4.4.14/Documentation/devicetree/bindings/usb/ |
| D | fsl-usb.txt | 40 - fsl,invert-drvvbus : boolean; for MPC5121 USB0 only. Indicates the
42 - fsl,invert-pwr-fault : boolean; for MPC5121 USB0 only. Indicates
|
| /linux-4.4.14/arch/powerpc/boot/dts/ |
| D | mpc5121ads.dts | 129 /* mpc5121ads only uses USB0 */
134 /* USB0 using internal UTMI PHY */
|
| D | pdm360ng.dts | 135 /* USB0 using internal UTMI PHY */
|
| D | sequoia.dts | 155 USB0: ehci@e0000300 { label
|
| D | mpc5121.dtsi | 309 /* USB0 using internal UTMI PHY */
|
| D | canyonlands.dts | 166 USB0: ehci@bffd0400 { label
|
| /linux-4.4.14/Documentation/devicetree/bindings/reset/ |
| D | nxp,lpc1850-rgu.txt | 23 17 USB0
|
| /linux-4.4.14/arch/arm/boot/dts/ |
| D | dove-sbc-a510.dts | 48 * 0.0 USB0 VBUS_EN (active high)
49 * 0.1 USB0 VBUS_GOOD
|
| D | am335x-pepper.dts | 592 /* USB0 Over-Current (active low) */
|
| /linux-4.4.14/arch/sh/kernel/cpu/sh4a/ |
| D | setup-sh7724.c | 882 USB0, USB1, enumerator
944 INTC_VECT(USB0, 0xA20),
1022 INTC_GROUP(USB, USB0, USB1),
1060 { 0, 0, 0, CMT, 0, USB1, USB0, 0 } },
|
| D | setup-sh7757.c | 803 USB0, USB1, enumerator
864 INTC_VECT(USB0, 0x840),
978 IRQ9, IRQ8, SCIF1, SCIF0, USB0, 0, 0, USB1,
1078 { INT2PRI12, 0, 32, 8, { USB0, 0, IRQ15, USB1 } },
|
| /linux-4.4.14/Documentation/devicetree/bindings/clock/ |
| D | lpc1850-cgu.txt | 46 1 BASE_USB0_CLK Base clock for USB0
|
| /linux-4.4.14/drivers/clk/nxp/ |
| D | clk-lpc18xx-cgu.c | 223 LPC1XX_CGU_BASE_CLK(USB0, base_usb0_src_ids, 0),
|
| /linux-4.4.14/drivers/phy/ |
| D | Kconfig | 65 This driver is need for USB0 support on LPC18xx/43xx and takes
|