| /linux-4.4.14/drivers/staging/media/lirc/ |
| D | lirc_sir.c | 574 soutp(UART_MCR, UART_MCR_RTS|UART_MCR_DTR|UART_MCR_OUT2); in init_hardware()
578 soutp(UART_MCR, UART_MCR_RTS|UART_MCR_OUT2); in init_hardware()
581 soutp(UART_MCR, UART_MCR_RTS|UART_MCR_DTR|UART_MCR_OUT2); in init_hardware()
586 soutp(UART_MCR, UART_MCR_DTR|UART_MCR_OUT2); in init_hardware()
594 soutp(UART_MCR, UART_MCR_RTS|UART_MCR_DTR|UART_MCR_OUT2); in init_hardware()
628 outb(UART_MCR_DTR|UART_MCR_RTS|UART_MCR_OUT2, io + UART_MCR); in init_hardware()
778 soutp(UART_MCR, UART_MCR_RTS|UART_MCR_DTR|UART_MCR_OUT2); in init_act200()
783 soutp(UART_MCR, UART_MCR_DTR|UART_MCR_OUT2); in init_act200()
787 soutp(UART_MCR, UART_MCR_RTS|UART_MCR_DTR|UART_MCR_OUT2); in init_act200()
791 soutp(UART_MCR, UART_MCR_RTS|UART_MCR_OUT2); in init_act200()
[all …]
|
| D | lirc_serial.c | 126 .on = (UART_MCR_RTS | UART_MCR_OUT2 | UART_MCR_DTR),
127 .off = (UART_MCR_RTS | UART_MCR_OUT2),
143 .on = UART_MCR_OUT2,
144 .off = (UART_MCR_RTS | UART_MCR_DTR | UART_MCR_OUT2),
155 .on = (UART_MCR_RTS | UART_MCR_DTR | UART_MCR_OUT2),
156 .off = (UART_MCR_RTS | UART_MCR_DTR | UART_MCR_OUT2),
168 .off = (UART_MCR_RTS | UART_MCR_DTR | UART_MCR_OUT2),
178 .on = (UART_MCR_RTS | UART_MCR_OUT2 | UART_MCR_DTR),
179 .off = (UART_MCR_RTS | UART_MCR_OUT2),
|
| /linux-4.4.14/sound/drivers/ |
| D | serial-u16550.c | 419 | UART_MCR_OUT2 /* Set OUT2 - not always required, but when in snd_uart16550_do_open()
428 outb(UART_MCR_RTS | (0&UART_MCR_DTR) | UART_MCR_OUT2, in snd_uart16550_do_open()
434 outb(UART_MCR_RTS | UART_MCR_DTR | UART_MCR_OUT2, in snd_uart16550_do_open()
481 |(0 & UART_MCR_OUT2) /* Deactivate OUT2 */ in snd_uart16550_do_close()
488 outb(UART_MCR_RTS | (0&UART_MCR_DTR) | (0&UART_MCR_OUT2), in snd_uart16550_do_close()
494 outb(UART_MCR_RTS | UART_MCR_DTR | (0&UART_MCR_OUT2), in snd_uart16550_do_close()
|
| /linux-4.4.14/drivers/usb/serial/ |
| D | ark3116.c | 456 (ctrl & UART_MCR_OUT2 ? TIOCM_OUT2 : 0); in ark3116_tiocmget()
478 priv->mcr |= UART_MCR_OUT2; in ark3116_tiocmset()
486 priv->mcr &= ~UART_MCR_OUT2; in ark3116_tiocmset()
|
| D | f81232.c | 193 val = UART_MCR_OUT2 | priv->modem_control; in f81232_set_mctrl()
|
| D | mos7720.c | 1094 mos7720_port->shadowMCR = UART_MCR_OUT2; /* Must set to enable ints! */ in mos7720_open()
1633 mos7720_port->shadowMCR = UART_MCR_OUT2; in change_port_settings()
|
| /linux-4.4.14/drivers/tty/serial/8250/ |
| D | 8250.h | 127 #define ALPHA_KLUDGE_MCR (UART_MCR_OUT2 | UART_MCR_OUT1)
|
| D | 8250_port.c | 1250 serial_out(up, UART_MCR, UART_MCR_OUT1 | UART_MCR_OUT2); in autoconfig_irq()
1260 UART_MCR_DTR | UART_MCR_RTS | UART_MCR_OUT2); in autoconfig_irq()
1674 mcr |= UART_MCR_OUT2; in serial8250_do_set_mctrl()
|
| /linux-4.4.14/include/uapi/linux/ |
| D | serial_reg.h | 126 #define UART_MCR_OUT2 0x08 /* Out2 complement */ macro
|
| /linux-4.4.14/drivers/staging/speakup/ |
| D | serialio.c | 124 outb(UART_MCR_DTR | UART_MCR_RTS | UART_MCR_OUT2, in start_serial_interrupt()
|
| /linux-4.4.14/drivers/ssb/ |
| D | driver_extif.c | 47 regs[UART_MCR] = (UART_MCR_LOOP | UART_MCR_OUT2 | UART_MCR_RTS); in serial_exists()
|
| /linux-4.4.14/drivers/isdn/hisax/ |
| D | elsa_ser.c | 175 cs->hw.elsa.MCR = UART_MCR_DTR | UART_MCR_RTS | UART_MCR_OUT2; in mstartup()
222 cs->hw.elsa.MCR &= ~UART_MCR_OUT2; in mshutdown()
|
| /linux-4.4.14/drivers/bluetooth/ |
| D | dtl1_cs.c | 478 outb((UART_MCR_DTR | UART_MCR_RTS | UART_MCR_OUT2), iobase + UART_MCR); in dtl1_open()
|
| D | btuart_cs.c | 495 outb((UART_MCR_DTR | UART_MCR_RTS | UART_MCR_OUT2), iobase + UART_MCR); in btuart_open()
|
| /linux-4.4.14/drivers/tty/serial/ |
| D | sunsu.c | 136 value |= UART_MCR_OUT2; in serial_out()
596 mcr |= UART_MCR_OUT2; in sunsu_set_mctrl()
|
| D | omap-serial.c | 679 mcr |= UART_MCR_OUT2; in serial_omap_set_mctrl()
685 old_mcr &= ~(UART_MCR_LOOP | UART_MCR_OUT2 | UART_MCR_OUT1 | in serial_omap_set_mctrl()
|
| D | vr41xx_siu.c | 214 mcr |= UART_MCR_OUT2; in siu_set_mctrl()
|
| D | pxa.c | 315 mcr |= UART_MCR_OUT2; in serial_pxa_set_mctrl()
|
| D | ioc3_serial.c | 1755 mcr |= UART_MCR_OUT2; in ic3_set_mctrl()
|
| D | ioc4_serial.c | 2475 mcr |= UART_MCR_OUT2; in ic4_set_mctrl()
|
| /linux-4.4.14/drivers/mmc/card/ |
| D | sdio_uart.c | 231 mcr |= UART_MCR_OUT2; in sdio_uart_write_mctrl()
|
| /linux-4.4.14/drivers/net/irda/ |
| D | ali-ircc.c | 1088 outb((UART_MCR_DTR | UART_MCR_RTS | UART_MCR_OUT2), iobase+UART_MCR); in ali_ircc_sir_change_speed()
|
| D | smsc-ircc2.c | 1923 outb((UART_MCR_DTR | UART_MCR_RTS | UART_MCR_OUT2), sir_base + UART_MCR); in smsc_ircc_sir_start()
|
| /linux-4.4.14/drivers/isdn/i4l/ |
| D | isdn_tty.c | 1065 info->mcr = UART_MCR_DTR | UART_MCR_RTS | UART_MCR_OUT2; in isdn_tty_startup()
|