| /linux-4.4.14/drivers/tty/serial/ |
| D | m32r_sio_reg.h | 148 #define UART_IER_RLSI 0x08 /* Enable receiver line status interrupt */ macro
|
| D | serial-tegra.c | 701 ier |= (UART_IER_RLSI | UART_IER_RTOIE | in tegra_uart_isr()
731 ier &= ~(UART_IER_RDI | UART_IER_RLSI | in tegra_uart_isr()
765 ier &= ~(UART_IER_RDI | UART_IER_RLSI | UART_IER_RTOIE | in tegra_uart_stop_rx()
911 tup->ier_shadow = UART_IER_RLSI | UART_IER_RTOIE | TEGRA_UART_IER_EORD; in tegra_uart_hw_init()
|
| D | omap-serial.c | 350 up->ier |= UART_IER_RLSI | UART_IER_RDI; in serial_omap_stop_tx()
364 up->ier &= ~(UART_IER_RLSI | UART_IER_RDI); in serial_omap_stop_rx()
448 up->ier &= ~(UART_IER_RLSI | UART_IER_RDI); in serial_omap_throttle()
462 up->ier |= UART_IER_RLSI | UART_IER_RDI; in serial_omap_unthrottle()
781 up->ier = UART_IER_RLSI | UART_IER_RDI; in serial_omap_startup()
|
| D | vr41xx_siu.c | 275 ier &= ~UART_IER_RLSI; in siu_stop_rx()
477 siu_write(port, UART_IER, UART_IER_RLSI | UART_IER_RDI); in siu_startup()
|
| D | pxa.c | 94 up->ier &= ~UART_IER_RLSI; in serial_pxa_stop_rx()
390 up->ier = UART_IER_RLSI | UART_IER_RDI | UART_IER_RTOIE | UART_IER_UUE; in serial_pxa_startup()
|
| D | m32r_sio.c | 294 up->ier &= ~UART_IER_RLSI; in m32r_sio_stop_rx()
649 up->ier = UART_IER_MSI | UART_IER_RLSI | UART_IER_RDI; in m32r_sio_startup()
|
| D | sunsu.c | 305 up->ier &= ~UART_IER_RLSI; in sunsu_stop_rx()
705 up->ier = UART_IER_RLSI | UART_IER_RDI; in sunsu_startup()
|
| /linux-4.4.14/arch/mn10300/kernel/ |
| D | gdb-io-serial.c | 72 GDBPORT_SERIAL_IER = UART_IER_RDI | UART_IER_RLSI; in gdbstub_io_init()
|
| /linux-4.4.14/arch/frv/kernel/ |
| D | gdb-io.c | 70 __UART(IER) = UART_IER_RDI | UART_IER_RLSI; in gdbstub_io_init()
|
| /linux-4.4.14/include/uapi/linux/ |
| D | serial_reg.h | 25 #define UART_IER_RLSI 0x04 /* Enable receiver line status interrupt */ macro
|
| /linux-4.4.14/drivers/staging/media/lirc/ |
| D | lirc_serial.c | 678 (~(UART_IER_MSI|UART_IER_RLSI|UART_IER_THRI|UART_IER_RDI))); in hardware_init_port()
817 (~(UART_IER_MSI|UART_IER_RLSI|UART_IER_THRI|UART_IER_RDI))); in set_use_dec()
957 (~(UART_IER_MSI|UART_IER_RLSI|UART_IER_THRI|UART_IER_RDI))); in lirc_serial_suspend()
|
| D | lirc_sir.c | 561 (~(UART_IER_MSI|UART_IER_RLSI|UART_IER_THRI|UART_IER_RDI))); in init_hardware()
|
| /linux-4.4.14/drivers/staging/speakup/ |
| D | serialio.c | 127 outb(UART_IER_MSI|UART_IER_RLSI|UART_IER_RDI, in start_serial_interrupt()
|
| /linux-4.4.14/drivers/tty/serial/8250/ |
| D | 8250_omap.c | 625 up->ier = UART_IER_RLSI | UART_IER_RDI; in omap_8250_startup()
692 up->ier &= ~(UART_IER_RLSI | UART_IER_RDI); in omap_8250_throttle()
709 up->ier |= UART_IER_RLSI | UART_IER_RDI; in omap_8250_unthrottle()
|
| D | 8250_port.c | 1356 up->ier &= ~(UART_IER_RLSI | UART_IER_RDI); in serial8250_stop_rx()
2029 up->ier = UART_IER_RLSI | UART_IER_RDI; in serial8250_do_startup()
|
| /linux-4.4.14/drivers/bluetooth/ |
| D | dtl1_cs.c | 484 outb(UART_IER_RLSI | UART_IER_RDI | UART_IER_THRI, iobase + UART_IER); in dtl1_open()
|
| D | btuart_cs.c | 388 outb(UART_IER_RLSI | UART_IER_RDI | UART_IER_THRI, iobase + UART_IER); in btuart_change_speed()
|
| /linux-4.4.14/drivers/staging/dgnc/ |
| D | dgnc_cls.c | 614 ier |= (UART_IER_RDI | UART_IER_RLSI); in cls_param()
616 ier &= ~(UART_IER_RDI | UART_IER_RLSI); in cls_param()
|
| D | dgnc_neo.c | 761 ier |= (UART_IER_RDI | UART_IER_RLSI); in neo_param()
763 ier &= ~(UART_IER_RDI | UART_IER_RLSI); in neo_param()
|
| /linux-4.4.14/drivers/mmc/card/ |
| D | sdio_uart.c | 371 port->ier &= ~UART_IER_RLSI; in sdio_uart_stop_rx()
646 port->ier = UART_IER_RLSI|UART_IER_RDI|UART_IER_RTOIE|UART_IER_UUE; in sdio_uart_activate()
|
| /linux-4.4.14/drivers/usb/serial/ |
| D | ark3116.c | 389 ark3116_write_reg(port->serial, UART_IER, UART_IER_MSI|UART_IER_RLSI); in ark3116_open()
|
| /linux-4.4.14/drivers/isdn/hisax/ |
| D | elsa_ser.c | 181 cs->hw.elsa.IER = UART_IER_MSI | UART_IER_RLSI | UART_IER_RDI; in mstartup()
|
| /linux-4.4.14/drivers/tty/serial/jsm/ |
| D | jsm_cls.c | 783 ier |= (UART_IER_RDI | UART_IER_RLSI); in cls_param()
|
| D | jsm_neo.c | 1053 ier |= (UART_IER_RDI | UART_IER_RLSI); in neo_param()
|
| /linux-4.4.14/drivers/net/irda/ |
| D | smsc-ircc2.c | 1172 outb(UART_IER_RLSI | UART_IER_RDI | UART_IER_THRI, iobase + UART_IER); in smsc_ircc_set_sir_speed()
1926 outb(UART_IER_RLSI | UART_IER_RDI |UART_IER_THRI, sir_base + UART_IER); in smsc_ircc_sir_start()
|
| /linux-4.4.14/drivers/tty/ |
| D | mxser.c | 926 info->IER = UART_IER_MSI | UART_IER_RLSI | UART_IER_RDI; in mxser_activate()
1051 info->IER &= ~UART_IER_RLSI; in mxser_close_port()
|