Searched refs:U300_PIN_BIT (Results 1 - 1 of 1) sorted by relevance
| /linux-4.4.14/drivers/pinctrl/ |
| H A D | pinctrl-coh901.c | 100 #define U300_PIN_BIT(pin) \ macro
224 return readl(U300_PIN_REG(offset, dir)) & U300_PIN_BIT(offset); u300_gpio_get()
237 writel(val | U300_PIN_BIT(offset), U300_PIN_REG(offset, dor)); u300_gpio_set()
239 writel(val & ~U300_PIN_BIT(offset), U300_PIN_REG(offset, dor)); u300_gpio_set()
299 biasmode = !!(readl(U300_PIN_REG(offset, per)) & U300_PIN_BIT(offset)); u300_gpio_config_get()
360 writel(val | U300_PIN_BIT(offset), U300_PIN_REG(offset, per)); u300_gpio_config_set()
364 writel(val & ~U300_PIN_BIT(offset), U300_PIN_REG(offset, per)); u300_gpio_config_set()
418 writel(val & ~U300_PIN_BIT(offset), U300_PIN_REG(offset, icr)); u300_toggle_trigger()
423 writel(val | U300_PIN_BIT(offset), U300_PIN_REG(offset, icr)); u300_toggle_trigger()
447 port->toggle_edge_mode |= U300_PIN_BIT(offset); u300_gpio_irq_type()
453 writel(val | U300_PIN_BIT(offset), U300_PIN_REG(offset, icr)); u300_gpio_irq_type()
454 port->toggle_edge_mode &= ~U300_PIN_BIT(offset); u300_gpio_irq_type()
459 writel(val & ~U300_PIN_BIT(offset), U300_PIN_REG(offset, icr)); u300_gpio_irq_type()
460 port->toggle_edge_mode &= ~U300_PIN_BIT(offset); u300_gpio_irq_type()
479 writel(val | U300_PIN_BIT(offset), U300_PIN_REG(offset, ien)); u300_gpio_irq_enable()
493 writel(val & ~U300_PIN_BIT(offset), U300_PIN_REG(offset, ien)); u300_gpio_irq_disable()
538 if (port->toggle_edge_mode & U300_PIN_BIT(offset)) u300_gpio_irq_handler()
|
Completed in 56 milliseconds