| /linux-4.1.27/Documentation/devicetree/bindings/pinctrl/ |
| D | marvell,armada-39x-pinctrl.txt | 19 mpp2 2 gpio, i2c0(sck)
32 mpp15 15 gpio, pcie0(rstout), spi0(mosi), i2c1(sck)
34 mpp17 17 gpio, ua1(rxd), spi0(sck), smi(mdio)
35 mpp18 18 gpio, ua1(txd), spi0(cs0), i2c2(sck)
40 mpp23 23 gpio, spi0(sck), dev(ad2)
43 mpp26 26 gpio, spi0(cs2), i2c1(sck), sd(d6), dev(cs1)
56 mpp39 39 gpio, i2c1(sck), ua0(cts), sd(d1), dev(a2), ge(rxd2)
69 mpp52 52 gpio, pcie0(rstout), tdm(intn) [1], audio(sdi) [1], sd(d6), i2c3(sck)
74 mpp57 57 gpio, spi1(sck), sd(clk), ua1(txd)
75 mpp58 58 gpio, i2c1(sck), pcie2(clkreq), spi1(miso), sd(d1), ua1(rxd)
|
| D | marvell,kirkwood-pinctrl.txt | 26 mpp2 2 gpo, nand(io4), spi(sck)
34 mpp9 9 gpio, twsi(sck), uart0(cts), uart1(cts), ptp(evreq),
36 mpp10 10 gpo, spi(sck), uart0(txd), ptp(trig)
64 mpp2 2 gpo, nand(io4), spi(sck)
72 mpp9 9 gpio, twsi(sck), uart0(cts), uart1(cts), ptp(evreq),
74 mpp10 10 gpo, spi(sck), uart0(txd), ptp(trig)
108 mpp2 2 gpo, nand(io4), spi(sck)
116 mpp9 9 gpio, twsi(sck), uart0(cts), uart1(cts), ptp(evreq),
118 mpp10 10 gpo, spi(sck), uart0(txd), ptp(trig), sata1(act)
139 mpp25 25 gpio, ge1(rxd1), ts(mp5), tdm(spi-sck), audio(lrclk)
[all …]
|
| D | marvell,armada-370-pinctrl.txt | 18 mpp2 2 gpio, i2c0(sck), uart0(txd)
31 mpp13 13 gpio, ge0(rxd2), i2c1(sck), sd0(d1), tdm(pclk),
51 mpp30 30 gpio, ge0(rxd7), ge1(rxclk), i2c1(sck)
56 mpp35 35 gpo, dev(oen), spi0(sck)
76 mpp52 52 gpio, dev(ad13), i2c1(sck), sd0(d3), spi1(sck)
94 mpp63 63 gpo, spi0(sck), tclk
|
| D | marvell,armada-38x-pinctrl.txt | 20 mpp2 2 gpio, i2c0(sck)
35 mpp17 17 gpio, ge0(rxclk), ptp(clk), ua1(rxd), spi0(sck), sata1(prsnt)
41 mpp23 23 gpio, spi0(sck), dev(ad2)
44 mpp26 26 gpio, spi0(cs2), i2c1(sck), sd0(d6), dev(cs1)
57 mpp39 39 gpio, i2c1(sck), ge1(rxd2), ua0(cts), sd0(d1), dev(a2)
75 mpp57 57 gpio, spi1(sck), sd0(clk)
76 mpp58 58 gpio, pcie1(clkreq) [1], i2c1(sck), pcie2(clkreq), spi1(miso), sd0(d1)
|
| D | marvell,armada-375-pinctrl.txt | 25 mpp9 9 gpio, spi0(sck), spi1(sck), nand(we)
31 mpp15 15 gpio, i2c0(sck), uart1(rxd)
48 mpp32 32 gpio, ge1(txd2), spi1(sck), ptp(triggen)
50 mpp34 34 gpio, ge1(txclkout), spi1(sck)
78 mpp62 62 gpio, i2c1(sck), led(p1)
|
| D | marvell,dove-pinctrl.txt | 27 mpp7 7 gpio, pmu, uart3(rxd), sdio1(ledctrl), spi1(sck), pmu*
43 mpp19 19 gpio, uart3(rxd), sdio0(ledctrl), twsi(sck)
50 mpp23 23 gpio, sdio0(ledctrl), sdio1(ledctrl), spi1(sck),
51 lcd-spi(sck), ssp(sclk)
|
| D | fsl,mxs-pinctrl.txt | 110 mmc_sck_cfg: mmc-sck-cfg {
119 applied on all these pins. And config nodes mmc-cd-cfg and mmc-sck-cfg are
|
| D | marvell,armada-xp-pinctrl.txt | 59 mpp38 38 gpio, spi(sck)
|
| /linux-4.1.27/Documentation/devicetree/bindings/spi/ |
| D | spi-fsl-dspi.txt | 20 - fsl,spi-cs-sck-delay: a delay in nanoseconds between activating chip
22 - fsl,spi-sck-cs-delay: a delay in nanoseconds between stopping the clock
52 fsl,spi-cs-sck-delay = <100>;
53 fsl,spi-sck-cs-delay = <50>;
|
| D | spi-gpio.txt | 8 - gpio-sck: GPIO spec for the SCK line to use
23 gpio-sck = <&gpio 95 0>;
|
| /linux-4.1.27/include/linux/spi/ |
| D | spi_gpio.h | 64 unsigned sck; member
|
| /linux-4.1.27/drivers/misc/eeprom/ |
| D | digsy_mtc_eeprom.c | 45 .sck = GPIO_EEPROM_CLK,
|
| /linux-4.1.27/drivers/spi/ |
| D | spi-mxs.c | 69 unsigned int sck; /* Rate requested (vs actual) */ member
84 if (hz != spi->sck) { in mxs_spi_setup_transfer()
91 spi->sck = hz; in mxs_spi_setup_transfer()
|
| D | spi-gpio.c | 83 #define SPI_SCK_GPIO ((pdata)->sck)
366 pdata->sck = ret; in spi_gpio_probe_dt()
|
| /linux-4.1.27/Documentation/devicetree/bindings/sound/ |
| D | pcm512x.txt | 49 clocks = <&sck>;
|
| /linux-4.1.27/arch/arm/mach-s3c24xx/ |
| D | mach-jive.c | 395 .sck = S3C2410_GPG(8),
410 .sck = S3C2410_GPB(4),
|
| D | mach-qt2410.c | 214 .sck = S3C2410_GPG(7),
|
| /linux-4.1.27/arch/arm/boot/dts/ |
| D | bcm47081-buffalo-wzr-600dhp2.dts | 29 gpio-sck = <&chipcommon 7 0>;
|
| D | bcm4708-buffalo-wzr-1750dhp.dts | 29 gpio-sck = <&chipcommon 7 0>;
|
| D | imx28-cfa10056.dts | 102 gpio-sck = <&gpio2 16 0>;
|
| D | imx28-cfa10049.dts | 341 gpio-sck = <&gpio2 16 0>;
365 gpio-sck = <&gpio0 24 0>;
|
| D | imx28-cfa10055.dts | 143 gpio-sck = <&gpio2 16 0>;
|
| D | imx28-apx4devkit.dts | 84 mmc2_sck_cfg_apx4: mmc2-sck-cfg-apx4 {
|
| D | imx28.dtsi | 484 mmc0_sck_cfg: mmc0-sck-cfg {
515 mmc1_sck_cfg: mmc1-sck-cfg {
547 mmc2_sck_cfg: mmc2-sck-cfg {
|
| D | armada-xp-lenovo-ix4-300d.dts | 227 gpio-sck = <&gpio0 25 GPIO_ACTIVE_LOW>;
|
| D | exynos4210-universal_c210.dts | 406 gpio-sck = <&gpy3 1 0>;
|
| D | omap3-gta04.dtsi | 58 gpio-sck = <&gpio1 12 0>;
|
| D | imx28-tx28.dts | 217 gpio-sck = <&gpio2 24 GPIO_ACTIVE_HIGH>;
|
| /linux-4.1.27/arch/arm/mach-s3c64xx/ |
| D | mach-smartq.c | 210 .sck = S3C64XX_GPM(1),
|
| /linux-4.1.27/arch/mips/jz4740/ |
| D | board-qi_lb60.c | 302 .sck = JZ_GPIO_PORTC(23),
|
| /linux-4.1.27/arch/mips/alchemy/devboards/ |
| D | db1000.c | 449 .sck = 209,
|
| /linux-4.1.27/arch/arm/mach-pxa/ |
| D | cm-x300.c | 341 .sck = GPIO_LCD_SCL,
|
| D | raumfeld.c | 634 .sck = GPIO_SPI_CLK,
|
| /linux-4.1.27/drivers/pinctrl/sh-pfc/ |
| D | pfc-r8a7778.c | 1354 #define SCIF_PFC_CLK(name, sck) SH_PFC_MUX1(name, sck) argument
1625 #define SSI_PFC_CTRL(name, sck, ws) SH_PFC_MUX2(name, sck, ws) argument
|
| /linux-4.1.27/arch/powerpc/boot/dts/ |
| D | virtex440-ml510.dts | 324 xlnx,sck-ratio = <0x80>;
|