| /linux-4.1.27/drivers/block/drbd/ |
| D | drbd_actlog.c | 220 tmp = lc_find(device->resync, enr/AL_EXT_PER_BM_SECT); in find_active_resync_extent()
375 tmp = lc_find(device->resync, enr/AL_EXT_PER_BM_SECT); in drbd_al_begin_io_nonblock()
665 e = lc_find(device->resync, enr); in update_rs_extent()
667 e = lc_get(device->resync, enr); in update_rs_extent()
716 lc_committed(device->resync); in update_rs_extent()
719 lc_put(device->resync, &ext->lce); in update_rs_extent()
730 device->resync->nr_elements, in update_rs_extent()
731 device->resync->flags); in update_rs_extent()
893 if (device->resync_locked > device->resync->nr_elements/2) { in _bme_get()
897 e = lc_get(device->resync, enr); in _bme_get()
[all …]
|
| D | Kconfig | 56 4 resync data write
|
| D | drbd_proc.c | 336 lc_seq_printf_stats(seq, device->resync); in drbd_seq_show()
|
| D | drbd_debugfs.c | 713 lc_seq_printf_stats(m, device->resync); in device_resync_extents_show()
714 lc_seq_dump_details(m, device->resync, "rs_left flags", resync_dump_detail); in device_resync_extents_show()
|
| D | drbd_worker.c | 1762 lc_reset(device->resync); in drbd_start_resync()
1855 lc_destroy(device->resync); in drbd_ldev_destroy()
1856 device->resync = NULL; in drbd_ldev_destroy()
|
| D | drbd_int.h | 922 struct lru_cache *resync; member
|
| D | drbd_nl.c | 1723 device->resync = resync_lru; in drbd_adm_attach()
|
| D | drbd_main.c | 2188 lc_destroy(device->resync); in drbd_destroy_device()
|
| D | drbd_receiver.c | 2452 tmp = lc_find(device->resync, BM_SECT_TO_EXT(sector)); in drbd_rs_should_slow_down()
|
| /linux-4.1.27/Documentation/blockdev/drbd/ |
| D | disk-states-8.dot | 7 Consistent -> Inconsistent [ label = "start resync" ]
8 Outdated -> Inconsistent [ label = "start resync" ]
10 Inconsistent -> UpToDate [ label = "resync completed" ]
|
| /linux-4.1.27/Documentation/ |
| D | md-cluster.txt | 46 resync, and metadata superblock updates.
56 3.1.2 RESYNC: informs other nodes that a resync is initiated or ended
134 - initiates resync of the bitmap on the current node
136 The resync process, is the regular md resync. However, in a clustered
137 environment when a resync is performed, it needs to tell other nodes
138 of the areas which are suspended. Before a resync starts, the node
143 when the node performing resync finishes, it send RESYNC_FINISHED
|
| D | md.txt | 235 The point at which resync should start. If no resync is needed,
278 no resync can happen. no superblocks get written.
284 When written to inactive array, starts without resync
290 fully active: IO and resync can be happening.
291 When written to inactive array, starts with resync
491 resync - redundancy is being recalculated after unclean
501 similar to 'resync', but was requested by the
508 'idle' will stop an active resync/recovery etc. There is no
509 guarantee that another resync/recovery may not be automatically
512 'resync' or 'recovery' can be used to restart the
[all …]
|
| /linux-4.1.27/include/linux/ |
| D | raid_class.h | 48 int resync; member
75 DEFINE_RAID_ATTRIBUTE(int, resync)
|
| /linux-4.1.27/Documentation/device-mapper/ |
| D | dm-raid.txt | 176 of "resync" or "recover" can be considered complete.
180 resync - Array is undergoing its initial synchronization
206 "resync" - Initiate/continue a resync.
|
| /linux-4.1.27/arch/x86/platform/olpc/ |
| D | xo1-wakeup.S | 34 # Control registers were modified, pipeline resync is needed
|
| /linux-4.1.27/Documentation/devicetree/bindings/iio/frequency/ |
| D | adf4350.txt | 54 2: Phase resync enable
|
| /linux-4.1.27/drivers/scsi/ |
| D | raid_class.c | 211 raid_attr_ro_fn(resync);
|
| /linux-4.1.27/drivers/isdn/hardware/mISDN/ |
| D | netjet.c | 478 resync(struct tiger_ch *bc, struct tiger_hw *card) in resync() function
513 resync(bc, card); in fill_hdlc_flag()
563 resync(bc, card); in fill_dma()
|
| /linux-4.1.27/drivers/md/ |
| D | md.c | 4389 unsigned long resync, dt, db; in sync_speed_show() local
4392 resync = mddev->curr_mark_cnt - atomic_read(&mddev->recovery_active); in sync_speed_show()
4395 db = resync - mddev->resync_mark_cnt; in sync_speed_show()
4404 unsigned long long max_sectors, resync; in sync_completed_show() local
4419 resync = mddev->curr_resync_completed; in sync_completed_show()
4420 return sprintf(page, "%llu / %llu\n", resync, max_sectors); in sync_completed_show()
7083 sector_t max_sectors, resync, res; in status_resync() local
7090 resync = 0; in status_resync()
7092 resync = mddev->curr_resync in status_resync()
7112 res = (resync>>scale)*1000; in status_resync()
[all …]
|
| /linux-4.1.27/drivers/message/fusion/lsi/ |
| D | mpi_history.txt | 414 * 01-15-05 01.05.06 Added defaults for data scrub rate and resync rate to
|