Searched refs:plldiv (Results 1 – 15 of 15) sorted by relevance
| /linux-4.1.27/drivers/clk/at91/ |
| D | clk-plldiv.c | 30 struct clk_plldiv *plldiv = to_clk_plldiv(hw); in clk_plldiv_recalc_rate() local
31 struct at91_pmc *pmc = plldiv->pmc; in clk_plldiv_recalc_rate()
59 struct clk_plldiv *plldiv = to_clk_plldiv(hw); in clk_plldiv_set_rate() local
60 struct at91_pmc *pmc = plldiv->pmc; in clk_plldiv_set_rate()
86 struct clk_plldiv *plldiv; in at91_clk_register_plldiv() local
90 plldiv = kzalloc(sizeof(*plldiv), GFP_KERNEL); in at91_clk_register_plldiv()
91 if (!plldiv) in at91_clk_register_plldiv()
100 plldiv->hw.init = &init; in at91_clk_register_plldiv()
101 plldiv->pmc = pmc; in at91_clk_register_plldiv()
103 clk = clk_register(NULL, &plldiv->hw); in at91_clk_register_plldiv()
[all …]
|
| D | Makefile | 6 obj-y += clk-slow.o clk-main.o clk-pll.o clk-plldiv.o clk-master.o
|
| /linux-4.1.27/arch/mips/kernel/ |
| D | csrc-bcm1480.c | 49 unsigned int plldiv; in sb1480_clocksource_init() local
52 plldiv = G_BCM1480_SYS_PLL_DIV(__raw_readq(IOADDR(A_SCD_SYSTEM_CFG))); in sb1480_clocksource_init()
53 zbbus = ((plldiv >> 1) * 50000000) + ((plldiv & 1) * 25000000); in sb1480_clocksource_init()
|
| /linux-4.1.27/arch/mips/sibyte/bcm1480/ |
| D | setup.c | 121 int plldiv; in bcm1480_setup() local
134 plldiv = G_BCM1480_SYS_PLL_DIV(__raw_readq(IOADDR(A_SCD_SYSTEM_CFG))); in bcm1480_setup()
135 zbbus_mhz = ((plldiv >> 1) * 50) + ((plldiv & 1) * 25); in bcm1480_setup()
|
| /linux-4.1.27/arch/mips/sibyte/sb1250/ |
| D | setup.c | 183 int plldiv; in sb1250_setup() local
196 plldiv = G_SYS_PLL_DIV(__raw_readq(IOADDR(A_SCD_SYSTEM_CFG))); in sb1250_setup()
197 zbbus_mhz = ((plldiv >> 1) * 50) + ((plldiv & 1) * 25); in sb1250_setup()
|
| /linux-4.1.27/arch/c6x/platforms/ |
| D | pll.c | 211 u32 v, plldiv = 0; in clk_sysclk_recalc() local
245 plldiv = (v & PLLDIV_RATIO_MASK) + 1; in clk_sysclk_recalc()
247 if (plldiv == 0) in clk_sysclk_recalc()
248 plldiv = 1; in clk_sysclk_recalc()
250 rate /= plldiv; in clk_sysclk_recalc()
253 clk->name, plldiv, rate / 1000); in clk_sysclk_recalc()
|
| /linux-4.1.27/drivers/cpufreq/ |
| D | blackfin-cpufreq.c | 133 unsigned int plldiv; in bfin_target() local
148 plldiv = (bfin_read_PLL_DIV() & SSEL) | dpm_state_table[index].csel; in bfin_target()
149 bfin_write_PLL_DIV(plldiv); in bfin_target()
|
| /linux-4.1.27/sound/soc/codecs/ |
| D | ml26124.c | 61 u8 plldiv; member
386 coeff_div[i].plldiv); in ml26124_hw_params()
400 coeff_div[i].plldiv); in ml26124_hw_params()
414 coeff_div[i].plldiv); in ml26124_hw_params()
|
| /linux-4.1.27/arch/arm/mach-davinci/ |
| D | clock.c | 285 u32 v, plldiv; in clk_sysclk_recalc() local
313 plldiv = (v & pll->div_ratio_mask) + 1; in clk_sysclk_recalc()
314 if (plldiv) in clk_sysclk_recalc()
315 rate /= plldiv; in clk_sysclk_recalc()
|
| /linux-4.1.27/Documentation/devicetree/bindings/clock/ |
| D | at91-clock.txt | 55 "atmel,at91sam9x5-clk-plldiv":
323 Required properties for plldiv clocks (plldiv = pll / 2):
331 compatible = "atmel,at91sam9x5-clk-plldiv";
|
| /linux-4.1.27/arch/arm/boot/dts/ |
| D | at91sam9n12.dtsi | 149 compatible = "atmel,at91sam9x5-clk-plldiv";
|
| D | at91sam9x5.dtsi | 157 compatible = "atmel,at91sam9x5-clk-plldiv";
|
| D | at91sam9g45.dtsi | 157 compatible = "atmel,at91sam9x5-clk-plldiv";
|
| D | sama5d3.dtsi | 955 compatible = "atmel,at91sam9x5-clk-plldiv";
|
| D | sama5d4.dtsi | 432 compatible = "atmel,at91sam9x5-clk-plldiv";
|