/linux-4.1.27/drivers/infiniband/hw/ipath/ |
D | ipath_eeprom.c | 418 ipath_dev_err(dd, "Failed reset probing device 0x%02X\n", in i2c_probe() 514 ipath_dev_err(dd, "Failed to write EEPROM address\n"); in ipath_eeprom_internal_read() 577 ipath_dev_err(dd, "Failed to write EEPROM " in ipath_eeprom_internal_write() 726 ipath_dev_err( in ipath_get_eeprom_info() 754 ipath_dev_err(dd, "Couldn't allocate memory to read %u " in ipath_get_eeprom_info() 764 ipath_dev_err(dd, "Failed reading GUID from eeprom\n"); in ipath_get_eeprom_info() 777 ipath_dev_err(dd, "Invalid GUID %llx from flash; " in ipath_get_eeprom_info() 830 ipath_dev_err(dd, "Board SN %s did not pass functional " in ipath_get_eeprom_info() 898 ipath_dev_err(dd, "Couldn't allocate memory to read %u " in ipath_update_eeprom_log() 908 ipath_dev_err(dd, "Unable to acquire EEPROM for logging\n"); in ipath_update_eeprom_log() [all …]
|
D | ipath_sysfs.c | 208 ipath_dev_err(dd, "attempt to set invalid LMC %u\n", lmc); in store_lmc() 244 ipath_dev_err(dd, "attempt to set invalid LID 0x%x\n", lid); in store_lid() 275 ipath_dev_err(dd, "attempt to set invalid MLID\n"); in store_mlid() 332 ipath_dev_err(dd, "attempt to set invalid GUID\n"); in store_guid() 399 ipath_dev_err(dd, "invalid jint_max_packets.\n"); in store_jint_max_packets() 426 ipath_dev_err(dd, "invalid jint_idle_ticks.\n"); in store_jint_idle_ticks() 589 ipath_dev_err(dd, "attempt to set invalid link state\n"); in store_link_state() 622 ipath_dev_err(dd, "attempt to set invalid MTU\n"); in store_mtu() 647 ipath_dev_err(dd, "attempt to use non-numeric on enable\n"); in store_enabled() 659 ipath_dev_err(dd, "Failed to enable unit %d\n", in store_enabled() [all …]
|
D | ipath_init_chip.c | 97 ipath_dev_err(dd, "allocation error for eager TID " in create_port0_egr() 113 ipath_dev_err(dd, "SKB allocation error for " in create_port0_egr() 271 ipath_dev_err(dd, "Unable to allocate portdata array, " in init_chip_first() 279 ipath_dev_err(dd, "Unable to allocate portdata for port " in init_chip_first() 403 ipath_dev_err(dd, "failed to allocate PIOavail reg area " in init_pioavailregs() 450 ipath_dev_err(dd, "failed to allocate shadow page * " in init_shadow_tids() 459 ipath_dev_err(dd, "failed to allocate shadow dma handle " in init_shadow_tids() 603 ipath_dev_err(dd, "Register read failures from chip, " in init_housekeeping() 624 ipath_dev_err(dd, "Driver only handles version %d, " in init_housekeeping() 787 ipath_dev_err(dd, "Early initialization failure\n"); in ipath_init_chip() [all …]
|
D | ipath_intr.c | 474 ipath_dev_err(dd, "Suppressed %u messages for " in handle_supp_msgs() 667 ipath_dev_err(dd, "error interrupt with unknown errors " in handle_errors() 706 ipath_dev_err(dd, "Temporarily disabling " in handle_errors() 852 ipath_dev_err(dd, "Got reset, requires re-init " in handle_errors() 862 ipath_dev_err(dd, "%s error\n", msg); in handle_errors() 942 ipath_dev_err(dd, "Now %u unexpected " in ipath_bad_intr() 952 ipath_dev_err(dd, "%u unexpected interrupts, " in ipath_bad_intr() 976 ipath_dev_err(dd, in ipath_bad_regread() 982 ipath_dev_err(dd, "Still bad interrupt status, " in ipath_bad_regread() 989 ipath_dev_err(dd, "Disabling interrupts, " in ipath_bad_regread() [all …]
|
D | ipath_iba6110.c | 521 ipath_dev_err(dd, "Read of hardware error status failed " in ipath_ht_handle_hwerrors() 555 ipath_dev_err(dd, "hwerror interrupt with unknown errors " in ipath_ht_handle_hwerrors() 655 ipath_dev_err(dd, "Fatal Hardware Error (freeze " in ipath_ht_handle_hwerrors() 673 ipath_dev_err(dd, "%s hardware error\n", msg); in ipath_ht_handle_hwerrors() 715 ipath_dev_err(dd, "Don't yet know about board " in ipath_ht_boardname() 725 ipath_dev_err(dd, "Unsupported InfiniPath board %s!\n", name); in ipath_ht_boardname() 733 ipath_dev_err(dd, in ipath_ht_boardname() 747 ipath_dev_err(dd, in ipath_ht_boardname() 841 ipath_dev_err(dd, "Couldn't read HT link control%d " in slave_or_pri_blk() 891 ipath_dev_err(dd, "Couldn't read HT link width " in slave_or_pri_blk() [all …]
|
D | ipath_driver.c | 164 ipath_dev_err(dd, "failed to read bar0 before enable: " in read_bars() 169 ipath_dev_err(dd, "failed to read bar1 before enable: " in read_bars() 371 ipath_dev_err(dd, in ipath_verify_pioperf() 422 ipath_dev_err(dd, "enable unit %d failed: error %d\n", in ipath_init_one() 441 ipath_dev_err(dd, "rewrite of BAR0 " in ipath_init_one() 448 ipath_dev_err(dd, "rewrite of BAR1 " in ipath_init_one() 453 ipath_dev_err(dd, "BAR is 0 (probable RESET), " in ipath_init_one() 519 ipath_dev_err(dd, "Found unknown QLogic deviceid 0x%x, " in ipath_init_one() 533 ipath_dev_err(dd, "No valid address in BAR 0!\n"); in ipath_init_one() 562 ipath_dev_err(dd, "Failed to setup config space; " in ipath_init_one() [all …]
|
D | ipath_stats.c | 81 ipath_dev_err(dd, "Error! Read counter 0x%x timed out\n", in ipath_snap_cntr() 308 ipath_dev_err(dd, "Re-enabling masked errors " in ipath_get_faststats()
|
D | ipath_wc_x86_64.c | 107 ipath_dev_err(dd, "No way to align address/size " in ipath_enable_wc()
|
D | ipath_fs.c | 158 ipath_dev_err(dd, "failed to read from flash\n"); in flash_read() 212 ipath_dev_err(dd, "failed to write to flash\n"); in flash_write()
|
D | ipath_diag.c | 98 ipath_dev_err(dd, "Couldn't create ipath_diagpkt " in ipath_diag_add() 110 ipath_dev_err(dd, "Couldn't create %s device: %d", in ipath_diag_add()
|
D | ipath_sdma.c | 384 ipath_dev_err(dd, "failed to allocate SendDMA descriptor " in alloc_sdma() 397 ipath_dev_err(dd, "failed to allocate SendDMA head memory\n"); in alloc_sdma() 432 ipath_dev_err(dd, "SendDMA memory not allocated\n"); in setup_sdma()
|
D | ipath_verbs.c | 2208 ipath_dev_err(dd, "cannot register verbs: %d!\n", -ret); in ipath_register_ib_device() 2228 ipath_dev_err(dev->dd, "pending list not empty!\n"); in ipath_unregister_ib_device() 2230 ipath_dev_err(dev->dd, "piowait list not empty!\n"); in ipath_unregister_ib_device() 2232 ipath_dev_err(dev->dd, "rnrwait list not empty!\n"); in ipath_unregister_ib_device() 2234 ipath_dev_err(dev->dd, "multicast table memory leak!\n"); in ipath_unregister_ib_device() 2241 ipath_dev_err(dev->dd, "QP memory leak! %u still in use\n", in ipath_unregister_ib_device()
|
D | ipath_file_ops.c | 1598 ipath_dev_err(dd, "Unable to allocate portdata " in try_alloc_port() 2574 ipath_dev_err(dd, "Unable to set up user support: " in ipath_user_add() 2581 ipath_dev_err(dd, "Could not create wildcard " in ipath_user_add() 2594 ipath_dev_err(dd, "Could not create user minor %d, %s\n", in ipath_user_add()
|
D | ipath_kernel.h | 1325 #define ipath_dev_err(dd,fmt,...) \ macro
|