| /linux-4.1.27/Documentation/i2c/ |
| D | summary | 9 don't meet branding requirements, and so are not advertised as being I2C.
|
| /linux-4.1.27/drivers/net/ethernet/intel/igb/ |
| D | igb_ethtool.c | 2608 edata->advertised = in igb_get_eee()
2666 edata->advertised &= ~edata->advertised; in igb_get_eee()
2705 if (!edata->advertised || (edata->advertised & in igb_set_eee()
2711 adv100m_eee = !!(edata->advertised & ADVERTISE_100_FULL); in igb_set_eee()
2712 adv1g_eee = !!(edata->advertised & ADVERTISE_1000_FULL); in igb_set_eee()
2720 adapter->eee_advert = ethtool_adv_to_mmd_eee_adv_t(edata->advertised); in igb_set_eee()
|
| /linux-4.1.27/drivers/net/usb/ |
| D | ax88179_178a.c | 652 data->advertised = mmd_eee_adv_to_ethtool_adv_t(val); in ax88179_ethtool_get_eee()
667 u16 tmp16 = ethtool_adv_to_mmd_eee_adv_t(data->advertised); in ax88179_ethtool_set_eee()
1318 eee_data.advertised = 0; in ax88179_bind()
1609 eee_data.advertised = 0; in ax88179_reset()
|
| D | r8152.c | 3575 eee->advertised = adv; in r8152_get_eee()
3583 u16 val = ethtool_adv_to_mmd_eee_adv_t(eee->advertised); in r8152_set_eee()
3615 eee->advertised = adv; in r8153_get_eee()
3623 u16 val = ethtool_adv_to_mmd_eee_adv_t(eee->advertised); in r8153_set_eee()
|
| /linux-4.1.27/drivers/net/phy/ |
| D | phy.c | 1166 data->advertised = mmd_eee_adv_to_ethtool_adv_t(val); in phy_ethtool_get_eee()
1188 int val = ethtool_adv_to_mmd_eee_adv_t(data->advertised); in phy_ethtool_set_eee()
|
| /linux-4.1.27/drivers/net/ethernet/intel/ixgbe/ |
| D | ixgbe_ethtool.c | 311 u32 advertised, old; in ixgbe_set_settings() local
332 advertised = 0; in ixgbe_set_settings()
334 advertised |= IXGBE_LINK_SPEED_10GB_FULL; in ixgbe_set_settings()
337 advertised |= IXGBE_LINK_SPEED_1GB_FULL; in ixgbe_set_settings()
340 advertised |= IXGBE_LINK_SPEED_100_FULL; in ixgbe_set_settings()
342 if (old == advertised) in ixgbe_set_settings()
349 err = hw->mac.ops.setup_link(hw, advertised, true); in ixgbe_set_settings()
|
| /linux-4.1.27/include/uapi/linux/ |
| D | ethtool.h | 309 __u32 advertised; member
|
| /linux-4.1.27/Documentation/networking/ |
| D | e1000.txt | 52 advertised by the adapter. When this parameter is used, the Speed and
355 is advertised (The 1000BaseT spec requires auto-negotiation.)
363 speed and duplex combinations are advertised during the auto-negotiation
|
| D | ixgb.txt | 367 Frames, your system may require more than the advertised minimum
|
| D | rxrpc.txt | 884 Usually the other side won't stop sending packets until the advertised
|
| D | ip-sysctl.txt | 110 The advertised MSS depends on the first hop route MTU, but will
|
| /linux-4.1.27/drivers/net/ethernet/broadcom/bnx2x/ |
| D | bnx2x_ethtool.c | 2019 edata->advertised = in bnx2x_get_eee()
2040 u32 advertised; in bnx2x_set_eee() local
2057 advertised = bnx2x_adv_to_eee(edata->advertised, in bnx2x_set_eee()
2059 if ((advertised != (eee_cfg & SHMEM_EEE_ADV_STATUS_MASK))) { in bnx2x_set_eee()
|
| /linux-4.1.27/Documentation/input/ |
| D | gamepad.txt | 156 Rumble is advertised as FF_RUMBLE.
|
| /linux-4.1.27/Documentation/hwmon/ |
| D | vt1211 | 50 mode doesn't seem to work as advertised in the datasheet. In fact I couldn't
|
| /linux-4.1.27/drivers/net/ethernet/intel/e1000e/ |
| D | ethtool.c | 2174 edata->advertised = mmd_eee_adv_to_ethtool_adv_t(adapter->eee_advert); in e1000e_get_eee()
2231 if (edata->advertised & ~(ADVERTISE_100_FULL | ADVERTISE_1000_FULL)) { in e1000e_set_eee()
2236 adapter->eee_advert = ethtool_adv_to_mmd_eee_adv_t(edata->advertised); in e1000e_set_eee()
|
| /linux-4.1.27/Documentation/filesystems/ |
| D | affs.txt | 183 Quite a few things may not work as advertised. Not everything is
|
| /linux-4.1.27/drivers/usb/gadget/legacy/ |
| D | Kconfig | 256 advertised on alternative interface 0 (primary) and UAS is on
|
| /linux-4.1.27/Documentation/ |
| D | xillybus.txt | 7 Email: eli.billauer@gmail.com or as advertised on Xillybus' site.
|
| /linux-4.1.27/drivers/net/ethernet/micrel/ |
| D | ksz884x.c | 1212 u8 advertised; member
3315 if (local == info->advertised && remote == info->partner) in port_get_link_speed()
3318 info->advertised = local; in port_get_link_speed()
|
| /linux-4.1.27/drivers/net/ethernet/broadcom/ |
| D | tg3.c | 2375 dest->advertised = mmd_eee_adv_to_ethtool_adv_t(val); in tg3_eee_pull_config()
4361 tp->eee.advertised = 0; in tg3_phy_autoneg_cfg()
4363 tp->eee.advertised = advertise & in tg3_phy_autoneg_cfg()
4623 if (tp->eee.advertised != eee.advertised || in tg3_phy_eee_config_ok()
4629 if (eee.advertised) in tg3_phy_eee_config_ok()
14068 if (edata->advertised != tp->eee.advertised) { in tg3_set_eee()
15516 tp->eee.advertised = ADVERTISED_100baseT_Full | in tg3_phy_probe()
|