Searched refs:CMD_REG (Results 1 – 4 of 4) sorted by relevance
| /linux-4.1.27/drivers/scsi/ |
| D | NCR53c406a.c | 249 static int CMD_REG; /* command register */ variable
718 outb(FLUSH_FIFO, CMD_REG); /* reset the fifos */ in NCR53c406a_queue_lck()
723 outb(SELECT_NO_ATN, CMD_REG); in NCR53c406a_queue_lck()
738 outb(CHIP_RESET, CMD_REG); in DEF_SCSI_QCMD()
739 outb(SCSI_NOP, CMD_REG); /* required after reset */ in DEF_SCSI_QCMD()
740 outb(SCSI_RESET, CMD_REG); in DEF_SCSI_QCMD()
870 outb(FLUSH_FIFO, CMD_REG); in NCR53c406a_intr()
877 outb(TRANSFER_INFO | DMA_OP, CMD_REG); in NCR53c406a_intr()
892 outb(FLUSH_FIFO, CMD_REG); in NCR53c406a_intr()
898 outb(TRANSFER_INFO | DMA_OP, CMD_REG); in NCR53c406a_intr()
[all …]
|
| /linux-4.1.27/drivers/scsi/pcmcia/ |
| D | sym53c500_cs.c | 97 #define CMD_REG 0x03 /* command register */ macro
238 outb(CHIP_RESET, io_port + CMD_REG); in SYM53C500_int_host_reset()
239 outb(SCSI_NOP, io_port + CMD_REG); /* required after reset */ in SYM53C500_int_host_reset()
240 outb(SCSI_RESET, io_port + CMD_REG); in SYM53C500_int_host_reset()
426 outb(FLUSH_FIFO, port_base + CMD_REG); in SYM53C500_intr()
428 outb(TRANSFER_INFO | DMA_OP, port_base + CMD_REG); in SYM53C500_intr()
445 outb(FLUSH_FIFO, port_base + CMD_REG); in SYM53C500_intr()
447 outb(TRANSFER_INFO | DMA_OP, port_base + CMD_REG); in SYM53C500_intr()
465 outb(FLUSH_FIFO, port_base + CMD_REG); in SYM53C500_intr()
466 outb(INIT_CMD_COMPLETE, port_base + CMD_REG); in SYM53C500_intr()
[all …]
|
| /linux-4.1.27/drivers/clk/qcom/ |
| D | clk-rcg2.c | 29 #define CMD_REG 0x0 macro
56 ret = regmap_read(rcg->clkr.regmap, rcg->cmd_rcgr + CMD_REG, &cmd); in clk_rcg2_is_enabled()
94 ret = regmap_update_bits(rcg->clkr.regmap, rcg->cmd_rcgr + CMD_REG, in update_config()
101 ret = regmap_read(rcg->clkr.regmap, rcg->cmd_rcgr + CMD_REG, &cmd); in update_config()
|
| /linux-4.1.27/drivers/net/ieee802154/ |
| D | at86rf230.c | 258 #define CMD_REG 0x80 macro
456 .write_flag_mask = CMD_REG | CMD_WRITE,
457 .read_flag_mask = CMD_REG,
498 tx_buf[0] = (reg & CMD_REG_MASK) | CMD_REG; in at86rf230_async_read_reg()
713 buf[0] = (RG_TRX_STATE & CMD_REG_MASK) | CMD_REG | CMD_WRITE; in at86rf230_async_state_change_start()
932 buf[0] = (RG_IRQ_STATUS & CMD_REG_MASK) | CMD_REG; in at86rf230_isr()
957 buf[0] = (RG_TRX_STATE & CMD_REG_MASK) | CMD_REG | CMD_WRITE; in at86rf230_write_frame_complete()
|