4476 	OUTB (nc_istat, SIGP);  in ncr_put_start_queue()
4500 	OUTB (nc_stest3, TE);  in ncr_reset_scsi_bus()
4501 	OUTB (nc_scntl1, CRST);  in ncr_reset_scsi_bus()
4535 	OUTB (nc_scntl1, 0);  in ncr_reset_scsi_bus()
4698 	OUTB (nc_istat, SIGP);
4741 	OUTB (nc_dien , 0);  in ncr_detach()
4751 	OUTB(nc_dmode,	np->sv_dmode);  in ncr_detach()
4752 	OUTB(nc_dcntl,	np->sv_dcntl);  in ncr_detach()
4753 	OUTB(nc_ctest0,	np->sv_ctest0);  in ncr_detach()
4754 	OUTB(nc_ctest3,	np->sv_ctest3);  in ncr_detach()
4755 	OUTB(nc_ctest4,	np->sv_ctest4);  in ncr_detach()
4756 	OUTB(nc_ctest5,	np->sv_ctest5);  in ncr_detach()
4757 	OUTB(nc_gpcntl,	np->sv_gpcntl);  in ncr_detach()
4758 	OUTB(nc_stest2,	np->sv_stest2);  in ncr_detach()
5185 	OUTB (nc_istat,  SRST);  in ncr_chip_reset()
5187 	OUTB (nc_istat,  0   );  in ncr_chip_reset()
5190 		OUTB (nc_ctest0, EHP);  in ncr_chip_reset()
5192 		OUTB (nc_ctest4, MUX);  in ncr_chip_reset()
5214 		OUTB (nc_istat,  SRST);  in ncr_init()
5218 		OUTB (nc_stest3, TE|CSF);  in ncr_init()
5276 	OUTB (nc_scntl0, np->rv_scntl0 | 0xc0);  in ncr_init()
5278 	OUTB (nc_scntl1, 0x00);		/*  odd parity, and remove CRST!! */  in ncr_init()
5282 	OUTB (nc_scid  , RRE|np->myaddr);	/* Adapter SCSI address */  in ncr_init()
5284 	OUTB (nc_istat , SIGP	);		/*  Signal Process */  in ncr_init()
5285 	OUTB (nc_dmode , np->rv_dmode);		/* Burst length, dma mode */  in ncr_init()
5286 	OUTB (nc_ctest5, np->rv_ctest5);	/* Large fifo + large burst */  in ncr_init()
5288 	OUTB (nc_dcntl , NOCOM|np->rv_dcntl);	/* Protect SFBR */  in ncr_init()
5289 	OUTB (nc_ctest0, np->rv_ctest0);	/* 720: CDIS and EHP */  in ncr_init()
5290 	OUTB (nc_ctest3, np->rv_ctest3);	/* Write and invalidate */  in ncr_init()
5291 	OUTB (nc_ctest4, np->rv_ctest4);	/* Master parity checking */  in ncr_init()
5293 	OUTB (nc_stest2, EXT|np->rv_stest2);	/* Extended Sreq/Sack filtering */  in ncr_init()
5294 	OUTB (nc_stest3, TE);			/* TolerANT enable */  in ncr_init()
5295 	OUTB (nc_stime0, 0x0c	);		/* HTH disabled  STO 0.25 sec */  in ncr_init()
5316 	OUTB (nc_dien , MDPE|BF|ABRT|SSI|SIR|IID);  in ncr_init()
5503 	OUTB (nc_sxfer, tp->sval);  in ncr_set_sync_wide_status()
5505 	OUTB (nc_scntl3, tp->wval);  in ncr_set_sync_wide_status()
5918 		OUTB (nc_istat, (istat & SIGP) | INTF);  in ncr_exception()
5928 		OUTB (nc_istat, CABRT);  in ncr_exception()
6040 	OUTB (nc_stest3, TE|CSF);  in ncr_exception()
6057 		OUTB (HS_PRT, HS_UNEXPECTED);  in ncr_exception()
6218 	OUTB (nc_stest3, TE|CSF);	/* clear scsi fifo */  in ncr_int_par()
6310 	OUTB (nc_stest3, TE|CSF);	/* clear scsi fifo */  in ncr_int_ma()
6834 		OUTB (HS_PRT, HS_BUSY);  in ncr_int_sir()
6929 			OUTB (HS_PRT, HS_BUSY);  in ncr_int_sir()
7016 			OUTB (HS_PRT, HS_BUSY);  in ncr_int_sir()
7823 		OUTB(nc_scntl3,	scntl3);
7830 	OUTB(nc_stest1, DBLEN);	   /* Enable clock multiplier		  */
7839 	OUTB(nc_stest3, HSC);		/* Halt the scsi clock		*/
7840 	OUTB(nc_scntl3,	scntl3);
7841 	OUTB(nc_stest1, (DBLEN|DBLSEL));/* Select clock multiplier	*/
7842 	OUTB(nc_stest3, 0x00);		/* Restart scsi clock 		*/
7869 	OUTB (nc_stest1, 0);	/* make sure clock doubler is OFF */
7872 	OUTB (nc_dien , 0);	/* mask all dma interrupts */
7874 	OUTB (nc_scntl3, 4);	/* set pre-scaler to divide by 3 */
7875 	OUTB (nc_stime1, 0);	/* disable general purpose timer */
7876 	OUTB (nc_stime1, gen);	/* set to nominal delay of 1<<gen * 125us */
7881 	OUTB (nc_stime1, 0);	/* disable general purpose timer */
7887  	OUTB (nc_scntl3, 0);