169 			hw_dbg(hw, "I2C byte read combined error - Retry.\n");  in ixgbe_read_i2c_combined_generic()
171 			hw_dbg(hw, "I2C byte read combined error.\n");  in ixgbe_read_i2c_combined_generic()
226 			hw_dbg(hw, "I2C byte write combined error - Retry.\n");  in ixgbe_write_i2c_combined_generic()
228 			hw_dbg(hw, "I2C byte write combined error.\n");  in ixgbe_write_i2c_combined_generic()
306 		hw_dbg(hw, "MNG_VETO bit detected.\n");  in ixgbe_check_reset_blocked()
416 		hw_dbg(hw, "PHY reset polling failed to complete.\n");  in ixgbe_reset_phy_generic()
457 		hw_dbg(hw, "PHY address command did not complete.\n");  in ixgbe_read_phy_reg_mdi()
484 		hw_dbg(hw, "PHY read command didn't complete\n");  in ixgbe_read_phy_reg_mdi()
560 		hw_dbg(hw, "PHY address cmd didn't complete\n");  in ixgbe_write_phy_reg_mdi()
588 		hw_dbg(hw, "PHY write cmd didn't complete\n");  in ixgbe_write_phy_reg_mdi()
964 		hw_dbg(hw, "PHY reset did not complete.\n");  in ixgbe_reset_phy_nl()
989 			hw_dbg(hw, "DELAY: %d MS\n", edata);  in ixgbe_reset_phy_nl()
993 			hw_dbg(hw, "DATA:\n");  in ixgbe_reset_phy_nl()
1006 				hw_dbg(hw, "Wrote %4.4x to %4.4x\n", eword,  in ixgbe_reset_phy_nl()
1014 			hw_dbg(hw, "CONTROL:\n");  in ixgbe_reset_phy_nl()
1016 				hw_dbg(hw, "EOL\n");  in ixgbe_reset_phy_nl()
1019 				hw_dbg(hw, "SOL\n");  in ixgbe_reset_phy_nl()
1021 				hw_dbg(hw, "Bad control value\n");  in ixgbe_reset_phy_nl()
1026 			hw_dbg(hw, "Bad control type\n");  in ixgbe_reset_phy_nl()
1309 		hw_dbg(hw, "SFP+ module not supported\n");  in ixgbe_identify_sfp_module_generic()
1488 			hw_dbg(hw, "QSFP module not supported\n");  in ixgbe_identify_qsfp_module_generic()
1571 				hw_dbg(hw, "SFP+ module not supported\n");  in ixgbe_get_sfp_init_sequence_offsets()
1584 		hw_dbg(hw, "No matching SFP+ module found\n");  in ixgbe_get_sfp_init_sequence_offsets()
1713 			hw_dbg(hw, "I2C byte read error - Retrying.\n");  in ixgbe_read_i2c_byte_generic()
1715 			hw_dbg(hw, "I2C byte read error.\n");  in ixgbe_read_i2c_byte_generic()
1778 			hw_dbg(hw, "I2C byte write error - Retrying.\n");  in ixgbe_write_i2c_byte_generic()
1780 			hw_dbg(hw, "I2C byte write error.\n");  in ixgbe_write_i2c_byte_generic()
1923 		hw_dbg(hw, "I2C ack was not received.\n");  in ixgbe_get_i2c_ack()
1988 		hw_dbg(hw, "I2C data was not set to %X\n", data);  in ixgbe_clock_out_i2c_bit()
2063 		hw_dbg(hw, "Error - I2C data was not set to %X.\n", data);  in ixgbe_set_i2c_data()