292 		e_err(probe, "Unable to allocate interrupt Error: %d\n", err);  in e1000_request_irq()
896 		e_err(probe, "Unknown MAC Type\n");  in e1000_init_hw_struct()
1092 		e_err(probe, "EEPROM initialization failed\n");  in e1000_probe()
1104 		e_err(probe, "The EEPROM Checksum Is Not Valid\n");  in e1000_probe()
1117 			e_err(probe, "EEPROM Read Error\n");  in e1000_probe()
1123 		e_err(probe, "Invalid MAC Address\n");  in e1000_probe()
1313 		e_err(probe, "Unable to allocate memory for queues\n");  in e1000_sw_init()
1530 		e_err(tx_err, "txdr align check failed: %u bytes at %p\n",  in e1000_setup_tx_resources()
1548 			e_err(probe, "Unable to allocate aligned memory "  in e1000_setup_tx_resources()
1580 			e_err(probe, "Allocation for Tx Queue %u failed\n", i);  in e1000_setup_all_tx_resources()
1722 		e_err(rx_err, "rxdr align check failed: %u bytes at %p\n",  in e1000_setup_rx_resources()
1740 			e_err(probe, "Unable to allocate aligned memory for "  in e1000_setup_rx_resources()
1772 			e_err(probe, "Allocation for Rx Queue %u failed\n", i);  in e1000_setup_all_rx_resources()
3172 					e_err(drv, "__pskb_pull_tail "  in e1000_xmit_frame()
3507 	e_err(drv, "Reset adapter\n");  in e1000_reset_task()
3539 		e_err(probe, "Invalid MTU setting\n");  in e1000_change_mtu()
3547 			e_err(probe, "Jumbo Frames not supported.\n");  in e1000_change_mtu()
3914 			e_err(drv, "Detected Tx Unit Hang\n"  in e1000_clean_tx_irq()
4591 			e_err(rx_err, "skb align check failed: %u bytes at "  in e1000_alloc_rx_buffers()
4632 			e_err(rx_err, "dma align check failed: %u bytes at "  in e1000_alloc_rx_buffers()
4848 		e_err(probe, "Error in setting MWI\n");  in e1000_pci_set_mwi()
5053 	e_err(probe, "Unsupported Speed/Duplex configuration\n");  in e1000_set_spd_dplx()