pta               534 arch/ia64/include/asm/processor.h ia64_set_pta (__u64 pta)
pta               537 arch/ia64/include/asm/processor.h 	ia64_setreg(_IA64_REG_CR_PTA, pta);
pta               878 arch/ia64/include/asm/sal.h 	u64 pta;
pta               304 arch/ia64/mm/init.c 	unsigned long pta, impl_va_bits;
pta               354 arch/ia64/mm/init.c 	pta = POW2(61) - POW2(vmlpt_bits);
pta               362 arch/ia64/mm/init.c 	ia64_set_pta(pta | (0 << 8) | (vmlpt_bits << 2) | VHPT_ENABLE_BIT);
pta               932 drivers/cpufreq/powernow-k8.c 	struct powernowk8_target_arg *pta = arg;
pta               933 drivers/cpufreq/powernow-k8.c 	struct cpufreq_policy *pol = pta->pol;
pta               934 drivers/cpufreq/powernow-k8.c 	unsigned newstate = pta->newstate;
pta               989 drivers/cpufreq/powernow-k8.c 	struct powernowk8_target_arg pta = { .pol = pol, .newstate = index };
pta               991 drivers/cpufreq/powernow-k8.c 	return work_on_cpu(pol->cpu, powernowk8_target_fn, &pta);
pta               545 drivers/net/wireless/ti/wl1251/acx.c 	struct acx_bt_wlan_coex *pta;
pta               550 drivers/net/wireless/ti/wl1251/acx.c 	pta = kzalloc(sizeof(*pta), GFP_KERNEL);
pta               551 drivers/net/wireless/ti/wl1251/acx.c 	if (!pta)
pta               554 drivers/net/wireless/ti/wl1251/acx.c 	pta->enable = SG_ENABLE;
pta               556 drivers/net/wireless/ti/wl1251/acx.c 	ret = wl1251_cmd_configure(wl, ACX_SG_ENABLE, pta, sizeof(*pta));
pta               563 drivers/net/wireless/ti/wl1251/acx.c 	kfree(pta);
pta               480 drivers/net/wireless/ti/wlcore/acx.c 	struct acx_bt_wlan_coex *pta;
pta               485 drivers/net/wireless/ti/wlcore/acx.c 	pta = kzalloc(sizeof(*pta), GFP_KERNEL);
pta               486 drivers/net/wireless/ti/wlcore/acx.c 	if (!pta) {
pta               492 drivers/net/wireless/ti/wlcore/acx.c 		pta->enable = wl->conf.sg.state;
pta               494 drivers/net/wireless/ti/wlcore/acx.c 		pta->enable = CONF_SG_DISABLE;
pta               496 drivers/net/wireless/ti/wlcore/acx.c 	ret = wl1271_cmd_configure(wl, ACX_SG_ENABLE, pta, sizeof(*pta));
pta               503 drivers/net/wireless/ti/wlcore/acx.c 	kfree(pta);
pta              2129 drivers/pinctrl/tegra/pinctrl-tegra20.c 	MUX_PG(pta,    I2C2,      HDMI,      GMI,       RSVD4,         0x14, 24, 0x98, 22, 0xa4, 4),