1 /* SPDX-License-Identifier: GPL-2.0 */ 2 #ifndef _ASM_X86_PROCESSOR_FLAGS_H 3 #define _ASM_X86_PROCESSOR_FLAGS_H 4 5 #include <uapi/asm/processor-flags.h> 6 #include <linux/mem_encrypt.h> 7 8 #ifdef CONFIG_VM86 9 #define X86_VM_MASK X86_EFLAGS_VM 10 #else 11 #define X86_VM_MASK 0 /* No VM86 support */ 12 #endif 13 14 /* 15 * CR3's layout varies depending on several things. 16 * 17 * If CR4.PCIDE is set (64-bit only), then CR3[11:0] is the address space ID. 18 * If PAE is enabled, then CR3[11:5] is part of the PDPT address 19 * (i.e. it's 32-byte aligned, not page-aligned) and CR3[4:0] is ignored. 20 * Otherwise (non-PAE, non-PCID), CR3[3] is PWT, CR3[4] is PCD, and 21 * CR3[2:0] and CR3[11:5] are ignored. 22 * 23 * In all cases, Linux puts zeros in the low ignored bits and in PWT and PCD. 24 * 25 * CR3[63] is always read as zero. If CR4.PCIDE is set, then CR3[63] may be 26 * written as 1 to prevent the write to CR3 from flushing the TLB. 27 * 28 * On systems with SME, one bit (in a variable position!) is stolen to indicate 29 * that the top-level paging structure is encrypted. 30 * 31 * All of the remaining bits indicate the physical address of the top-level 32 * paging structure. 33 * 34 * CR3_ADDR_MASK is the mask used by read_cr3_pa(). 35 */ 36 #ifdef CONFIG_X86_64 37 /* Mask off the address space ID and SME encryption bits. */ 38 #define CR3_ADDR_MASK __sme_clr(0x7FFFFFFFFFFFF000ull) 39 #define CR3_PCID_MASK 0xFFFull 40 #define CR3_NOFLUSH BIT_ULL(63) 41 42 #else 43 /* 44 * CR3_ADDR_MASK needs at least bits 31:5 set on PAE systems, and we save 45 * a tiny bit of code size by setting all the bits. 46 */ 47 #define CR3_ADDR_MASK 0xFFFFFFFFull 48 #define CR3_PCID_MASK 0ull 49 #define CR3_NOFLUSH 0 50 #endif 51 52 #ifdef CONFIG_PAGE_TABLE_ISOLATION 53 # define X86_CR3_PTI_PCID_USER_BIT 11 54 #endif 55 56 #endif /* _ASM_X86_PROCESSOR_FLAGS_H */