This source file includes following definitions.
- sdk7786_i2c_setup
- sdk7786_devices_setup
- sdk7786_mode_pins
- sdk7786_pcie_clk_enable
- sdk7786_pcie_clk_disable
- sdk7786_clk_init
- sdk7786_restart
- sdk7786_power_off
- sdk7786_setup
1
2
3
4
5
6
7
8 #include <linux/init.h>
9 #include <linux/platform_device.h>
10 #include <linux/io.h>
11 #include <linux/regulator/fixed.h>
12 #include <linux/regulator/machine.h>
13 #include <linux/smsc911x.h>
14 #include <linux/i2c.h>
15 #include <linux/irq.h>
16 #include <linux/clk.h>
17 #include <linux/clkdev.h>
18 #include <mach/fpga.h>
19 #include <mach/irq.h>
20 #include <asm/machvec.h>
21 #include <asm/heartbeat.h>
22 #include <linux/sizes.h>
23 #include <asm/clock.h>
24 #include <asm/reboot.h>
25 #include <asm/smp-ops.h>
26
27 static struct resource heartbeat_resource = {
28 .start = 0x07fff8b0,
29 .end = 0x07fff8b0 + sizeof(u16) - 1,
30 .flags = IORESOURCE_MEM | IORESOURCE_MEM_16BIT,
31 };
32
33 static struct platform_device heartbeat_device = {
34 .name = "heartbeat",
35 .id = -1,
36 .num_resources = 1,
37 .resource = &heartbeat_resource,
38 };
39
40
41 static struct regulator_consumer_supply dummy_supplies[] = {
42 REGULATOR_SUPPLY("vddvario", "smsc911x"),
43 REGULATOR_SUPPLY("vdd33a", "smsc911x"),
44 };
45
46 static struct resource smsc911x_resources[] = {
47 [0] = {
48 .name = "smsc911x-memory",
49 .start = 0x07ffff00,
50 .end = 0x07ffff00 + SZ_256 - 1,
51 .flags = IORESOURCE_MEM,
52 },
53 [1] = {
54 .name = "smsc911x-irq",
55 .start = evt2irq(0x2c0),
56 .end = evt2irq(0x2c0),
57 .flags = IORESOURCE_IRQ,
58 },
59 };
60
61 static struct smsc911x_platform_config smsc911x_config = {
62 .irq_polarity = SMSC911X_IRQ_POLARITY_ACTIVE_LOW,
63 .irq_type = SMSC911X_IRQ_TYPE_OPEN_DRAIN,
64 .flags = SMSC911X_USE_32BIT,
65 .phy_interface = PHY_INTERFACE_MODE_MII,
66 };
67
68 static struct platform_device smsc911x_device = {
69 .name = "smsc911x",
70 .id = -1,
71 .num_resources = ARRAY_SIZE(smsc911x_resources),
72 .resource = smsc911x_resources,
73 .dev = {
74 .platform_data = &smsc911x_config,
75 },
76 };
77
78 static struct resource smbus_fpga_resource = {
79 .start = 0x07fff9e0,
80 .end = 0x07fff9e0 + SZ_32 - 1,
81 .flags = IORESOURCE_MEM,
82 };
83
84 static struct platform_device smbus_fpga_device = {
85 .name = "i2c-sdk7786",
86 .id = 0,
87 .num_resources = 1,
88 .resource = &smbus_fpga_resource,
89 };
90
91 static struct resource smbus_pcie_resource = {
92 .start = 0x07fffc30,
93 .end = 0x07fffc30 + SZ_32 - 1,
94 .flags = IORESOURCE_MEM,
95 };
96
97 static struct platform_device smbus_pcie_device = {
98 .name = "i2c-sdk7786",
99 .id = 1,
100 .num_resources = 1,
101 .resource = &smbus_pcie_resource,
102 };
103
104 static struct i2c_board_info __initdata sdk7786_i2c_devices[] = {
105 {
106 I2C_BOARD_INFO("max6900", 0x68),
107 },
108 };
109
110 static struct platform_device *sh7786_devices[] __initdata = {
111 &heartbeat_device,
112 &smsc911x_device,
113 &smbus_fpga_device,
114 &smbus_pcie_device,
115 };
116
117 static int sdk7786_i2c_setup(void)
118 {
119 unsigned int tmp;
120
121
122
123
124 tmp = fpga_read_reg(SBCR);
125 tmp &= ~SCBR_I2CCEN;
126 tmp |= SCBR_I2CMEN;
127 fpga_write_reg(tmp, SBCR);
128
129 return i2c_register_board_info(0, sdk7786_i2c_devices,
130 ARRAY_SIZE(sdk7786_i2c_devices));
131 }
132
133 static int __init sdk7786_devices_setup(void)
134 {
135 int ret;
136
137 ret = platform_add_devices(sh7786_devices, ARRAY_SIZE(sh7786_devices));
138 if (unlikely(ret != 0))
139 return ret;
140
141 return sdk7786_i2c_setup();
142 }
143 device_initcall(sdk7786_devices_setup);
144
145 static int sdk7786_mode_pins(void)
146 {
147 return fpga_read_reg(MODSWR);
148 }
149
150
151
152
153
154
155
156
157
158
159
160
161
162
163
164 static int sdk7786_pcie_clk_enable(struct clk *clk)
165 {
166 fpga_write_reg(fpga_read_reg(PCIECR) | PCIECR_CLKEN, PCIECR);
167 return 0;
168 }
169
170 static void sdk7786_pcie_clk_disable(struct clk *clk)
171 {
172 fpga_write_reg(fpga_read_reg(PCIECR) & ~PCIECR_CLKEN, PCIECR);
173 }
174
175 static struct sh_clk_ops sdk7786_pcie_clk_ops = {
176 .enable = sdk7786_pcie_clk_enable,
177 .disable = sdk7786_pcie_clk_disable,
178 };
179
180 static struct clk sdk7786_pcie_clk = {
181 .ops = &sdk7786_pcie_clk_ops,
182 };
183
184 static struct clk_lookup sdk7786_pcie_cl = {
185 .con_id = "pcie_plat_clk",
186 .clk = &sdk7786_pcie_clk,
187 };
188
189 static int sdk7786_clk_init(void)
190 {
191 struct clk *clk;
192 int ret;
193
194
195
196
197
198 if (test_mode_pin(MODE_PIN9))
199 return -EINVAL;
200
201 clk = clk_get(NULL, "extal");
202 if (IS_ERR(clk))
203 return PTR_ERR(clk);
204 ret = clk_set_rate(clk, 33333333);
205 clk_put(clk);
206
207
208
209
210 ret = clk_register(&sdk7786_pcie_clk);
211 if (unlikely(ret)) {
212 pr_err("FPGA clock registration failed\n");
213 return ret;
214 }
215
216 clkdev_add(&sdk7786_pcie_cl);
217
218 return 0;
219 }
220
221 static void sdk7786_restart(char *cmd)
222 {
223 fpga_write_reg(0xa5a5, SRSTR);
224 }
225
226 static void sdk7786_power_off(void)
227 {
228 fpga_write_reg(fpga_read_reg(PWRCR) | PWRCR_PDWNREQ, PWRCR);
229
230
231
232
233
234
235 while ((fpga_read_reg(PWRCR) & PWRCR_PDWNACK) == 0)
236 cpu_sleep();
237 }
238
239
240 static void __init sdk7786_setup(char **cmdline_p)
241 {
242 pr_info("Renesas Technology Europe SDK7786 support:\n");
243
244 regulator_register_fixed(0, dummy_supplies, ARRAY_SIZE(dummy_supplies));
245
246 sdk7786_fpga_init();
247 sdk7786_nmi_init();
248
249 pr_info("\tPCB revision:\t%d\n", fpga_read_reg(PCBRR) & 0xf);
250
251 machine_ops.restart = sdk7786_restart;
252 pm_power_off = sdk7786_power_off;
253
254 register_smp_ops(&shx3_smp_ops);
255 }
256
257
258
259
260 static struct sh_machine_vector mv_sdk7786 __initmv = {
261 .mv_name = "SDK7786",
262 .mv_setup = sdk7786_setup,
263 .mv_mode_pins = sdk7786_mode_pins,
264 .mv_clk_init = sdk7786_clk_init,
265 .mv_init_irq = sdk7786_init_irq,
266 };