root/arch/sh/boards/board-urquell.c

/* [<][>][^][v][top][bottom][index][help] */

DEFINITIONS

This source file includes following definitions.
  1. urquell_devices_setup
  2. urquell_power_off
  3. urquell_init_irq
  4. urquell_mode_pins
  5. urquell_clk_init
  6. urquell_setup

   1 // SPDX-License-Identifier: GPL-2.0
   2 /*
   3  * Renesas Technology Corp. SH7786 Urquell Support.
   4  *
   5  * Copyright (C) 2008  Kuninori Morimoto <morimoto.kuninori@renesas.com>
   6  * Copyright (C) 2009, 2010  Paul Mundt
   7  *
   8  * Based on board-sh7785lcr.c
   9  * Copyright (C) 2008  Yoshihiro Shimoda
  10  */
  11 #include <linux/init.h>
  12 #include <linux/platform_device.h>
  13 #include <linux/fb.h>
  14 #include <linux/smc91x.h>
  15 #include <linux/mtd/physmap.h>
  16 #include <linux/delay.h>
  17 #include <linux/gpio.h>
  18 #include <linux/irq.h>
  19 #include <linux/clk.h>
  20 #include <linux/sh_intc.h>
  21 #include <mach/urquell.h>
  22 #include <cpu/sh7786.h>
  23 #include <asm/heartbeat.h>
  24 #include <linux/sizes.h>
  25 #include <asm/smp-ops.h>
  26 
  27 /*
  28  * bit  1234 5678
  29  *----------------------------
  30  * SW1  0101 0010  -> Pck 33MHz version
  31  *     (1101 0010)    Pck 66MHz version
  32  * SW2  0x1x xxxx  -> little endian
  33  *                    29bit mode
  34  * SW47 0001 1000  -> CS0 : on-board flash
  35  *                    CS1 : SRAM, registers, LAN, PCMCIA
  36  *                    38400 bps for SCIF1
  37  *
  38  * Address
  39  * 0x00000000 - 0x04000000  (CS0)     Nor Flash
  40  * 0x04000000 - 0x04200000  (CS1)     SRAM
  41  * 0x05000000 - 0x05800000  (CS1)     on board register
  42  * 0x05800000 - 0x06000000  (CS1)     LAN91C111
  43  * 0x06000000 - 0x06400000  (CS1)     PCMCIA
  44  * 0x08000000 - 0x10000000  (CS2-CS3) DDR3
  45  * 0x10000000 - 0x14000000  (CS4)     PCIe
  46  * 0x14000000 - 0x14800000  (CS5)     Core0 LRAM/URAM
  47  * 0x14800000 - 0x15000000  (CS5)     Core1 LRAM/URAM
  48  * 0x18000000 - 0x1C000000  (CS6)     ATA/NAND-Flash
  49  * 0x1C000000 -             (CS7)     SH7786 Control register
  50  */
  51 
  52 /* HeartBeat */
  53 static struct resource heartbeat_resource = {
  54         .start  = BOARDREG(SLEDR),
  55         .end    = BOARDREG(SLEDR),
  56         .flags  = IORESOURCE_MEM | IORESOURCE_MEM_16BIT,
  57 };
  58 
  59 static struct platform_device heartbeat_device = {
  60         .name           = "heartbeat",
  61         .id             = -1,
  62         .num_resources  = 1,
  63         .resource       = &heartbeat_resource,
  64 };
  65 
  66 /* LAN91C111 */
  67 static struct smc91x_platdata smc91x_info = {
  68         .flags = SMC91X_USE_16BIT | SMC91X_NOWAIT,
  69 };
  70 
  71 static struct resource smc91x_eth_resources[] = {
  72         [0] = {
  73                 .name   = "SMC91C111" ,
  74                 .start  = 0x05800300,
  75                 .end    = 0x0580030f,
  76                 .flags  = IORESOURCE_MEM,
  77         },
  78         [1] = {
  79                 .start  = evt2irq(0x360),
  80                 .flags  = IORESOURCE_IRQ,
  81         },
  82 };
  83 
  84 static struct platform_device smc91x_eth_device = {
  85         .name           = "smc91x",
  86         .num_resources  = ARRAY_SIZE(smc91x_eth_resources),
  87         .resource       = smc91x_eth_resources,
  88         .dev    = {
  89                 .platform_data  = &smc91x_info,
  90         },
  91 };
  92 
  93 /* Nor Flash */
  94 static struct mtd_partition nor_flash_partitions[] = {
  95         {
  96                 .name           = "loader",
  97                 .offset         = 0x00000000,
  98                 .size           = SZ_512K,
  99                 .mask_flags     = MTD_WRITEABLE,        /* Read-only */
 100         },
 101         {
 102                 .name           = "bootenv",
 103                 .offset         = MTDPART_OFS_APPEND,
 104                 .size           = SZ_512K,
 105                 .mask_flags     = MTD_WRITEABLE,        /* Read-only */
 106         },
 107         {
 108                 .name           = "kernel",
 109                 .offset         = MTDPART_OFS_APPEND,
 110                 .size           = SZ_4M,
 111         },
 112         {
 113                 .name           = "data",
 114                 .offset         = MTDPART_OFS_APPEND,
 115                 .size           = MTDPART_SIZ_FULL,
 116         },
 117 };
 118 
 119 static struct physmap_flash_data nor_flash_data = {
 120         .width          = 2,
 121         .parts          = nor_flash_partitions,
 122         .nr_parts       = ARRAY_SIZE(nor_flash_partitions),
 123 };
 124 
 125 static struct resource nor_flash_resources[] = {
 126         [0] = {
 127                 .start  = NOR_FLASH_ADDR,
 128                 .end    = NOR_FLASH_ADDR + NOR_FLASH_SIZE - 1,
 129                 .flags  = IORESOURCE_MEM,
 130         }
 131 };
 132 
 133 static struct platform_device nor_flash_device = {
 134         .name           = "physmap-flash",
 135         .dev            = {
 136                 .platform_data  = &nor_flash_data,
 137         },
 138         .num_resources  = ARRAY_SIZE(nor_flash_resources),
 139         .resource       = nor_flash_resources,
 140 };
 141 
 142 static struct platform_device *urquell_devices[] __initdata = {
 143         &heartbeat_device,
 144         &smc91x_eth_device,
 145         &nor_flash_device,
 146 };
 147 
 148 static int __init urquell_devices_setup(void)
 149 {
 150         /* USB */
 151         gpio_request(GPIO_FN_USB_OVC0,  NULL);
 152         gpio_request(GPIO_FN_USB_PENC0, NULL);
 153 
 154         /* enable LAN */
 155         __raw_writew(__raw_readw(UBOARDREG(IRL2MSKR)) & ~0x00000001,
 156                   UBOARDREG(IRL2MSKR));
 157 
 158         return platform_add_devices(urquell_devices,
 159                                     ARRAY_SIZE(urquell_devices));
 160 }
 161 device_initcall(urquell_devices_setup);
 162 
 163 static void urquell_power_off(void)
 164 {
 165         __raw_writew(0xa5a5, UBOARDREG(SRSTR));
 166 }
 167 
 168 static void __init urquell_init_irq(void)
 169 {
 170         plat_irq_setup_pins(IRQ_MODE_IRL3210_MASK);
 171 }
 172 
 173 static int urquell_mode_pins(void)
 174 {
 175         return __raw_readw(UBOARDREG(MDSWMR));
 176 }
 177 
 178 static int urquell_clk_init(void)
 179 {
 180         struct clk *clk;
 181         int ret;
 182 
 183         /*
 184          * Only handle the EXTAL case, anyone interfacing a crystal
 185          * resonator will need to provide their own input clock.
 186          */
 187         if (test_mode_pin(MODE_PIN9))
 188                 return -EINVAL;
 189 
 190         clk = clk_get(NULL, "extal");
 191         if (IS_ERR(clk))
 192                 return PTR_ERR(clk);
 193         ret = clk_set_rate(clk, 33333333);
 194         clk_put(clk);
 195 
 196         return ret;
 197 }
 198 
 199 /* Initialize the board */
 200 static void __init urquell_setup(char **cmdline_p)
 201 {
 202         printk(KERN_INFO "Renesas Technology Corp. Urquell support.\n");
 203 
 204         pm_power_off = urquell_power_off;
 205 
 206         register_smp_ops(&shx3_smp_ops);
 207 }
 208 
 209 /*
 210  * The Machine Vector
 211  */
 212 static struct sh_machine_vector mv_urquell __initmv = {
 213         .mv_name        = "Urquell",
 214         .mv_setup       = urquell_setup,
 215         .mv_init_irq    = urquell_init_irq,
 216         .mv_mode_pins   = urquell_mode_pins,
 217         .mv_clk_init    = urquell_clk_init,
 218 };

/* [<][>][^][v][top][bottom][index][help] */