arch/powerpc/platforms/4xx/soc.c

/* [<][>][^][v][top][bottom][index][help] */
This source file includes following definitions.
l2c_diag
l2c_error_handler
ppc4xx_l2c_probe
ppc4xx_reset_system
   1 // SPDX-License-Identifier: GPL-2.0-or-later
   2 /*
   3  * IBM/AMCC PPC4xx SoC setup code
   4  *
   5  * Copyright 2008 DENX Software Engineering, Stefan Roese <sr@denx.de>
   6  *
   7  * L2 cache routines cloned from arch/ppc/syslib/ibm440gx_common.c which is:
   8  *   Eugene Surovegin <eugene.surovegin@zultys.com> or <ebs@ebshome.net>
   9  *   Copyright (c) 2003 - 2006 Zultys Technologies
  10  */
  11 
  12 #include <linux/stddef.h>
  13 #include <linux/kernel.h>
  14 #include <linux/init.h>
  15 #include <linux/errno.h>
  16 #include <linux/interrupt.h>
  17 #include <linux/irq.h>
  18 #include <linux/of_irq.h>
  19 #include <linux/of_platform.h>
  20 
  21 #include <asm/dcr.h>
  22 #include <asm/dcr-regs.h>
  23 #include <asm/reg.h>
  24 
  25 static u32 dcrbase_l2c;
  26 
  27 /*
  28  * L2-cache
  29  */
  30 
  31 /* Issue L2C diagnostic command */
  32 static inline u32 l2c_diag(u32 addr)
  33 {
  34         mtdcr(dcrbase_l2c + DCRN_L2C0_ADDR, addr);
  35         mtdcr(dcrbase_l2c + DCRN_L2C0_CMD, L2C_CMD_DIAG);
  36         while (!(mfdcr(dcrbase_l2c + DCRN_L2C0_SR) & L2C_SR_CC))
  37                 ;
  38 
  39         return mfdcr(dcrbase_l2c + DCRN_L2C0_DATA);
  40 }
  41 
  42 static irqreturn_t l2c_error_handler(int irq, void *dev)
  43 {
  44         u32 sr = mfdcr(dcrbase_l2c + DCRN_L2C0_SR);
  45 
  46         if (sr & L2C_SR_CPE) {
  47                 /* Read cache trapped address */
  48                 u32 addr = l2c_diag(0x42000000);
  49                 printk(KERN_EMERG "L2C: Cache Parity Error, addr[16:26] = 0x%08x\n",
  50                        addr);
  51         }
  52         if (sr & L2C_SR_TPE) {
  53                 /* Read tag trapped address */
  54                 u32 addr = l2c_diag(0x82000000) >> 16;
  55                 printk(KERN_EMERG "L2C: Tag Parity Error, addr[16:26] = 0x%08x\n",
  56                        addr);
  57         }
  58 
  59         /* Clear parity errors */
  60         if (sr & (L2C_SR_CPE | L2C_SR_TPE)){
  61                 mtdcr(dcrbase_l2c + DCRN_L2C0_ADDR, 0);
  62                 mtdcr(dcrbase_l2c + DCRN_L2C0_CMD, L2C_CMD_CCP | L2C_CMD_CTE);
  63         } else {
  64                 printk(KERN_EMERG "L2C: LRU error\n");
  65         }
  66 
  67         return IRQ_HANDLED;
  68 }
  69 
  70 static int __init ppc4xx_l2c_probe(void)
  71 {
  72         struct device_node *np;
  73         u32 r;
  74         unsigned long flags;
  75         int irq;
  76         const u32 *dcrreg;
  77         u32 dcrbase_isram;
  78         int len;
  79         const u32 *prop;
  80         u32 l2_size;
  81 
  82         np = of_find_compatible_node(NULL, NULL, "ibm,l2-cache");
  83         if (!np)
  84                 return 0;
  85 
  86         /* Get l2 cache size */
  87         prop = of_get_property(np, "cache-size", NULL);
  88         if (prop == NULL) {
  89                 printk(KERN_ERR "%pOF: Can't get cache-size!\n", np);
  90                 of_node_put(np);
  91                 return -ENODEV;
  92         }
  93         l2_size = prop[0];
  94 
  95         /* Map DCRs */
  96         dcrreg = of_get_property(np, "dcr-reg", &len);
  97         if (!dcrreg || (len != 4 * sizeof(u32))) {
  98                 printk(KERN_ERR "%pOF: Can't get DCR register base !", np);
  99                 of_node_put(np);
 100                 return -ENODEV;
 101         }
 102         dcrbase_isram = dcrreg[0];
 103         dcrbase_l2c = dcrreg[2];
 104 
 105         /* Get and map irq number from device tree */
 106         irq = irq_of_parse_and_map(np, 0);
 107         if (!irq) {
 108                 printk(KERN_ERR "irq_of_parse_and_map failed\n");
 109                 of_node_put(np);
 110                 return -ENODEV;
 111         }
 112 
 113         /* Install error handler */
 114         if (request_irq(irq, l2c_error_handler, 0, "L2C", 0) < 0) {
 115                 printk(KERN_ERR "Cannot install L2C error handler"
 116                        ", cache is not enabled\n");
 117                 of_node_put(np);
 118                 return -ENODEV;
 119         }
 120 
 121         local_irq_save(flags);
 122         asm volatile ("sync" ::: "memory");
 123 
 124         /* Disable SRAM */
 125         mtdcr(dcrbase_isram + DCRN_SRAM0_DPC,
 126               mfdcr(dcrbase_isram + DCRN_SRAM0_DPC) & ~SRAM_DPC_ENABLE);
 127         mtdcr(dcrbase_isram + DCRN_SRAM0_SB0CR,
 128               mfdcr(dcrbase_isram + DCRN_SRAM0_SB0CR) & ~SRAM_SBCR_BU_MASK);
 129         mtdcr(dcrbase_isram + DCRN_SRAM0_SB1CR,
 130               mfdcr(dcrbase_isram + DCRN_SRAM0_SB1CR) & ~SRAM_SBCR_BU_MASK);
 131         mtdcr(dcrbase_isram + DCRN_SRAM0_SB2CR,
 132               mfdcr(dcrbase_isram + DCRN_SRAM0_SB2CR) & ~SRAM_SBCR_BU_MASK);
 133         mtdcr(dcrbase_isram + DCRN_SRAM0_SB3CR,
 134               mfdcr(dcrbase_isram + DCRN_SRAM0_SB3CR) & ~SRAM_SBCR_BU_MASK);
 135 
 136         /* Enable L2_MODE without ICU/DCU */
 137         r = mfdcr(dcrbase_l2c + DCRN_L2C0_CFG) &
 138                 ~(L2C_CFG_ICU | L2C_CFG_DCU | L2C_CFG_SS_MASK);
 139         r |= L2C_CFG_L2M | L2C_CFG_SS_256;
 140         mtdcr(dcrbase_l2c + DCRN_L2C0_CFG, r);
 141 
 142         mtdcr(dcrbase_l2c + DCRN_L2C0_ADDR, 0);
 143 
 144         /* Hardware Clear Command */
 145         mtdcr(dcrbase_l2c + DCRN_L2C0_CMD, L2C_CMD_HCC);
 146         while (!(mfdcr(dcrbase_l2c + DCRN_L2C0_SR) & L2C_SR_CC))
 147                 ;
 148 
 149         /* Clear Cache Parity and Tag Errors */
 150         mtdcr(dcrbase_l2c + DCRN_L2C0_CMD, L2C_CMD_CCP | L2C_CMD_CTE);
 151 
 152         /* Enable 64G snoop region starting at 0 */
 153         r = mfdcr(dcrbase_l2c + DCRN_L2C0_SNP0) &
 154                 ~(L2C_SNP_BA_MASK | L2C_SNP_SSR_MASK);
 155         r |= L2C_SNP_SSR_32G | L2C_SNP_ESR;
 156         mtdcr(dcrbase_l2c + DCRN_L2C0_SNP0, r);
 157 
 158         r = mfdcr(dcrbase_l2c + DCRN_L2C0_SNP1) &
 159                 ~(L2C_SNP_BA_MASK | L2C_SNP_SSR_MASK);
 160         r |= 0x80000000 | L2C_SNP_SSR_32G | L2C_SNP_ESR;
 161         mtdcr(dcrbase_l2c + DCRN_L2C0_SNP1, r);
 162 
 163         asm volatile ("sync" ::: "memory");
 164 
 165         /* Enable ICU/DCU ports */
 166         r = mfdcr(dcrbase_l2c + DCRN_L2C0_CFG);
 167         r &= ~(L2C_CFG_DCW_MASK | L2C_CFG_PMUX_MASK | L2C_CFG_PMIM
 168                | L2C_CFG_TPEI | L2C_CFG_CPEI | L2C_CFG_NAM | L2C_CFG_NBRM);
 169         r |= L2C_CFG_ICU | L2C_CFG_DCU | L2C_CFG_TPC | L2C_CFG_CPC | L2C_CFG_FRAN
 170                 | L2C_CFG_CPIM | L2C_CFG_TPIM | L2C_CFG_LIM | L2C_CFG_SMCM;
 171 
 172         /* Check for 460EX/GT special handling */
 173         if (of_device_is_compatible(np, "ibm,l2-cache-460ex") ||
 174             of_device_is_compatible(np, "ibm,l2-cache-460gt"))
 175                 r |= L2C_CFG_RDBW;
 176 
 177         mtdcr(dcrbase_l2c + DCRN_L2C0_CFG, r);
 178 
 179         asm volatile ("sync; isync" ::: "memory");
 180         local_irq_restore(flags);
 181 
 182         printk(KERN_INFO "%dk L2-cache enabled\n", l2_size >> 10);
 183 
 184         of_node_put(np);
 185         return 0;
 186 }
 187 arch_initcall(ppc4xx_l2c_probe);
 188 
 189 /*
 190  * Apply a system reset. Alternatively a board specific value may be
 191  * provided via the "reset-type" property in the cpu node.
 192  */
 193 void ppc4xx_reset_system(char *cmd)
 194 {
 195         struct device_node *np;
 196         u32 reset_type = DBCR0_RST_SYSTEM;
 197         const u32 *prop;
 198 
 199         np = of_get_cpu_node(0, NULL);
 200         if (np) {
 201                 prop = of_get_property(np, "reset-type", NULL);
 202 
 203                 /*
 204                  * Check if property exists and if it is in range:
 205                  * 1 - PPC4xx core reset
 206                  * 2 - PPC4xx chip reset
 207                  * 3 - PPC4xx system reset (default)
 208                  */
 209                 if ((prop) && ((prop[0] >= 1) && (prop[0] <= 3)))
 210                         reset_type = prop[0] << 28;
 211         }
 212 
 213         mtspr(SPRN_DBCR0, mfspr(SPRN_DBCR0) | reset_type);
 214 
 215         while (1)
 216                 ;       /* Just in case the reset doesn't work */
 217 }
/* [<][>][^][v][top][bottom][index][help] */
root/arch/powerpc/platforms/4xx/soc.c

DEFINITIONS
