1 /* SPDX-License-Identifier: GPL-2.0 */
2 /*
3 * Copyright (C) 2018 Cadence Design Systems Inc.
4 */
5
6 #ifndef __PHY_MIPI_DPHY_H_
7 #define __PHY_MIPI_DPHY_H_
8
9 /**
10 * struct phy_configure_opts_mipi_dphy - MIPI D-PHY configuration set
11 *
12 * This structure is used to represent the configuration state of a
13 * MIPI D-PHY phy.
14 */
15 struct phy_configure_opts_mipi_dphy {
16 /**
17 * @clk_miss:
18 *
19 * Timeout, in picoseconds, for receiver to detect absence of
20 * Clock transitions and disable the Clock Lane HS-RX.
21 *
22 * Maximum value: 60000 ps
23 */
24 unsigned int clk_miss;
25
26 /**
27 * @clk_post:
28 *
29 * Time, in picoseconds, that the transmitter continues to
30 * send HS clock after the last associated Data Lane has
31 * transitioned to LP Mode. Interval is defined as the period
32 * from the end of @hs_trail to the beginning of @clk_trail.
33 *
34 * Minimum value: 60000 ps + 52 * @hs_clk_rate period in ps
35 */
36 unsigned int clk_post;
37
38 /**
39 * @clk_pre:
40 *
41 * Time, in UI, that the HS clock shall be driven by
42 * the transmitter prior to any associated Data Lane beginning
43 * the transition from LP to HS mode.
44 *
45 * Minimum value: 8 UI
46 */
47 unsigned int clk_pre;
48
49 /**
50 * @clk_prepare:
51 *
52 * Time, in picoseconds, that the transmitter drives the Clock
53 * Lane LP-00 Line state immediately before the HS-0 Line
54 * state starting the HS transmission.
55 *
56 * Minimum value: 38000 ps
57 * Maximum value: 95000 ps
58 */
59 unsigned int clk_prepare;
60
61 /**
62 * @clk_settle:
63 *
64 * Time interval, in picoseconds, during which the HS receiver
65 * should ignore any Clock Lane HS transitions, starting from
66 * the beginning of @clk_prepare.
67 *
68 * Minimum value: 95000 ps
69 * Maximum value: 300000 ps
70 */
71 unsigned int clk_settle;
72
73 /**
74 * @clk_term_en:
75 *
76 * Time, in picoseconds, for the Clock Lane receiver to enable
77 * the HS line termination.
78 *
79 * Maximum value: 38000 ps
80 */
81 unsigned int clk_term_en;
82
83 /**
84 * @clk_trail:
85 *
86 * Time, in picoseconds, that the transmitter drives the HS-0
87 * state after the last payload clock bit of a HS transmission
88 * burst.
89 *
90 * Minimum value: 60000 ps
91 */
92 unsigned int clk_trail;
93
94 /**
95 * @clk_zero:
96 *
97 * Time, in picoseconds, that the transmitter drives the HS-0
98 * state prior to starting the Clock.
99 */
100 unsigned int clk_zero;
101
102 /**
103 * @d_term_en:
104 *
105 * Time, in picoseconds, for the Data Lane receiver to enable
106 * the HS line termination.
107 *
108 * Maximum value: 35000 ps + 4 * @hs_clk_rate period in ps
109 */
110 unsigned int d_term_en;
111
112 /**
113 * @eot:
114 *
115 * Transmitted time interval, in picoseconds, from the start
116 * of @hs_trail or @clk_trail, to the start of the LP- 11
117 * state following a HS burst.
118 *
119 * Maximum value: 105000 ps + 12 * @hs_clk_rate period in ps
120 */
121 unsigned int eot;
122
123 /**
124 * @hs_exit:
125 *
126 * Time, in picoseconds, that the transmitter drives LP-11
127 * following a HS burst.
128 *
129 * Minimum value: 100000 ps
130 */
131 unsigned int hs_exit;
132
133 /**
134 * @hs_prepare:
135 *
136 * Time, in picoseconds, that the transmitter drives the Data
137 * Lane LP-00 Line state immediately before the HS-0 Line
138 * state starting the HS transmission.
139 *
140 * Minimum value: 40000 ps + 4 * @hs_clk_rate period in ps
141 * Maximum value: 85000 ps + 6 * @hs_clk_rate period in ps
142 */
143 unsigned int hs_prepare;
144
145 /**
146 * @hs_settle:
147 *
148 * Time interval, in picoseconds, during which the HS receiver
149 * shall ignore any Data Lane HS transitions, starting from
150 * the beginning of @hs_prepare.
151 *
152 * Minimum value: 85000 ps + 6 * @hs_clk_rate period in ps
153 * Maximum value: 145000 ps + 10 * @hs_clk_rate period in ps
154 */
155 unsigned int hs_settle;
156
157 /**
158 * @hs_skip:
159 *
160 * Time interval, in picoseconds, during which the HS-RX
161 * should ignore any transitions on the Data Lane, following a
162 * HS burst. The end point of the interval is defined as the
163 * beginning of the LP-11 state following the HS burst.
164 *
165 * Minimum value: 40000 ps
166 * Maximum value: 55000 ps + 4 * @hs_clk_rate period in ps
167 */
168 unsigned int hs_skip;
169
170 /**
171 * @hs_trail:
172 *
173 * Time, in picoseconds, that the transmitter drives the
174 * flipped differential state after last payload data bit of a
175 * HS transmission burst
176 *
177 * Minimum value: max(8 * @hs_clk_rate period in ps,
178 * 60000 ps + 4 * @hs_clk_rate period in ps)
179 */
180 unsigned int hs_trail;
181
182 /**
183 * @hs_zero:
184 *
185 * Time, in picoseconds, that the transmitter drives the HS-0
186 * state prior to transmitting the Sync sequence.
187 */
188 unsigned int hs_zero;
189
190 /**
191 * @init:
192 *
193 * Time, in microseconds for the initialization period to
194 * complete.
195 *
196 * Minimum value: 100 us
197 */
198 unsigned int init;
199
200 /**
201 * @lpx:
202 *
203 * Transmitted length, in picoseconds, of any Low-Power state
204 * period.
205 *
206 * Minimum value: 50000 ps
207 */
208 unsigned int lpx;
209
210 /**
211 * @ta_get:
212 *
213 * Time, in picoseconds, that the new transmitter drives the
214 * Bridge state (LP-00) after accepting control during a Link
215 * Turnaround.
216 *
217 * Value: 5 * @lpx
218 */
219 unsigned int ta_get;
220
221 /**
222 * @ta_go:
223 *
224 * Time, in picoseconds, that the transmitter drives the
225 * Bridge state (LP-00) before releasing control during a Link
226 * Turnaround.
227 *
228 * Value: 4 * @lpx
229 */
230 unsigned int ta_go;
231
232 /**
233 * @ta_sure:
234 *
235 * Time, in picoseconds, that the new transmitter waits after
236 * the LP-10 state before transmitting the Bridge state
237 * (LP-00) during a Link Turnaround.
238 *
239 * Minimum value: @lpx
240 * Maximum value: 2 * @lpx
241 */
242 unsigned int ta_sure;
243
244 /**
245 * @wakeup:
246 *
247 * Time, in microseconds, that a transmitter drives a Mark-1
248 * state prior to a Stop state in order to initiate an exit
249 * from ULPS.
250 *
251 * Minimum value: 1000 us
252 */
253 unsigned int wakeup;
254
255 /**
256 * @hs_clk_rate:
257 *
258 * Clock rate, in Hertz, of the high-speed clock.
259 */
260 unsigned long hs_clk_rate;
261
262 /**
263 * @lp_clk_rate:
264 *
265 * Clock rate, in Hertz, of the low-power clock.
266 */
267 unsigned long lp_clk_rate;
268
269 /**
270 * @lanes:
271 *
272 * Number of active, consecutive, data lanes, starting from
273 * lane 0, used for the transmissions.
274 */
275 unsigned char lanes;
276 };
277
278 int phy_mipi_dphy_get_default_config(unsigned long pixel_clock,
279 unsigned int bpp,
280 unsigned int lanes,
281 struct phy_configure_opts_mipi_dphy *cfg);
282 int phy_mipi_dphy_config_validate(struct phy_configure_opts_mipi_dphy *cfg);
283
284 #endif /* __PHY_MIPI_DPHY_H_ */