root/include/linux/via-core.h

INCLUDED FROM

DEFINITIONS

1. via_read_reg
2. via_write_reg
3. via_write_reg_mask
4. via_write_misc_reg_mask

   1 /* SPDX-License-Identifier: GPL-2.0-or-later */
   2 /*
   3  * Copyright 1998-2009 VIA Technologies, Inc. All Rights Reserved.
   4  * Copyright 2001-2008 S3 Graphics, Inc. All Rights Reserved.
   5  * Copyright 2009-2010 Jonathan Corbet <corbet@lwn.net>
   6  * Copyright 2010 Florian Tobias Schandinat <FlorianSchandinat@gmx.de>
   7  */
   8 
   9 #ifndef __VIA_CORE_H__
  10 #define __VIA_CORE_H__
  11 #include <linux/types.h>
  12 #include <linux/io.h>
  13 #include <linux/spinlock.h>
  14 #include <linux/pci.h>
  15 
  16 /*
  17  * A description of each known serial I2C/GPIO port.
  18  */
  19 enum via_port_type {
  20         VIA_PORT_NONE = 0,
  21         VIA_PORT_I2C,
  22         VIA_PORT_GPIO,
  23 };
  24 
  25 enum via_port_mode {
  26         VIA_MODE_OFF = 0,
  27         VIA_MODE_I2C,           /* Used as I2C port */
  28         VIA_MODE_GPIO,  /* Two GPIO ports */
  29 };
  30 
  31 enum viafb_i2c_adap {
  32         VIA_PORT_26 = 0,
  33         VIA_PORT_31,
  34         VIA_PORT_25,
  35         VIA_PORT_2C,
  36         VIA_PORT_3D,
  37 };
  38 #define VIAFB_NUM_PORTS 5
  39 
  40 struct via_port_cfg {
  41         enum via_port_type      type;
  42         enum via_port_mode      mode;
  43         u16                     io_port;
  44         u8                      ioport_index;
  45 };
  46 
  47 /*
  48  * Allow subdevs to register suspend/resume hooks.
  49  */
  50 #ifdef CONFIG_PM
  51 struct viafb_pm_hooks {
  52         struct list_head list;
  53         int (*suspend)(void *private);
  54         int (*resume)(void *private);
  55         void *private;
  56 };
  57 
  58 void viafb_pm_register(struct viafb_pm_hooks *hooks);
  59 void viafb_pm_unregister(struct viafb_pm_hooks *hooks);
  60 #endif /* CONFIG_PM */
  61 
  62 /*
  63  * This is the global viafb "device" containing stuff needed by
  64  * all subdevs.
  65  */
  66 struct viafb_dev {
  67         struct pci_dev *pdev;
  68         int chip_type;
  69         struct via_port_cfg *port_cfg;
  70         /*
  71          * Spinlock for access to device registers.  Not yet
  72          * globally used.
  73          */
  74         spinlock_t reg_lock;
  75         /*
  76          * The framebuffer MMIO region.  Little, if anything, touches
  77          * this memory directly, and certainly nothing outside of the
  78          * framebuffer device itself.  We *do* have to be able to allocate
  79          * chunks of this memory for other devices, though.
  80          */
  81         unsigned long fbmem_start;
  82         long fbmem_len;
  83         void __iomem *fbmem;
  84 #if defined(CONFIG_VIDEO_VIA_CAMERA) || defined(CONFIG_VIDEO_VIA_CAMERA_MODULE)
  85         long camera_fbmem_offset;
  86         long camera_fbmem_size;
  87 #endif
  88         /*
  89          * The MMIO region for device registers.
  90          */
  91         unsigned long engine_start;
  92         unsigned long engine_len;
  93         void __iomem *engine_mmio;
  94 
  95 };
  96 
  97 /*
  98  * Interrupt management.
  99  */
 100 
 101 void viafb_irq_enable(u32 mask);
 102 void viafb_irq_disable(u32 mask);
 103 
 104 /*
 105  * The global interrupt control register and its bits.
 106  */
 107 #define VDE_INTERRUPT   0x200   /* Video interrupt flags/masks */
 108 #define   VDE_I_DVISENSE  0x00000001  /* DVI sense int status */
 109 #define   VDE_I_VBLANK    0x00000002  /* Vertical blank status */
 110 #define   VDE_I_MCCFI     0x00000004  /* MCE compl. frame int status */
 111 #define   VDE_I_VSYNC     0x00000008  /* VGA VSYNC int status */
 112 #define   VDE_I_DMA0DDONE 0x00000010  /* DMA 0 descr done */
 113 #define   VDE_I_DMA0TDONE 0x00000020  /* DMA 0 transfer done */
 114 #define   VDE_I_DMA1DDONE 0x00000040  /* DMA 1 descr done */
 115 #define   VDE_I_DMA1TDONE 0x00000080  /* DMA 1 transfer done */
 116 #define   VDE_I_C1AV      0x00000100  /* Cap Eng 1 act vid end */
 117 #define   VDE_I_HQV0      0x00000200  /* First HQV engine */
 118 #define   VDE_I_HQV1      0x00000400  /* Second HQV engine */
 119 #define   VDE_I_HQV1EN    0x00000800  /* Second HQV engine enable */
 120 #define   VDE_I_C0AV      0x00001000  /* Cap Eng 0 act vid end */
 121 #define   VDE_I_C0VBI     0x00002000  /* Cap Eng 0 VBI end */
 122 #define   VDE_I_C1VBI     0x00004000  /* Cap Eng 1 VBI end */
 123 #define   VDE_I_VSYNC2    0x00008000  /* Sec. Disp. VSYNC */
 124 #define   VDE_I_DVISNSEN  0x00010000  /* DVI sense enable */
 125 #define   VDE_I_VSYNC2EN  0x00020000  /* Sec Disp VSYNC enable */
 126 #define   VDE_I_MCCFIEN   0x00040000  /* MC comp frame int mask enable */
 127 #define   VDE_I_VSYNCEN   0x00080000  /* VSYNC enable */
 128 #define   VDE_I_DMA0DDEN  0x00100000  /* DMA 0 descr done enable */
 129 #define   VDE_I_DMA0TDEN  0x00200000  /* DMA 0 trans done enable */
 130 #define   VDE_I_DMA1DDEN  0x00400000  /* DMA 1 descr done enable */
 131 #define   VDE_I_DMA1TDEN  0x00800000  /* DMA 1 trans done enable */
 132 #define   VDE_I_C1AVEN    0x01000000  /* cap 1 act vid end enable */
 133 #define   VDE_I_HQV0EN    0x02000000  /* First hqv engine enable */
 134 #define   VDE_I_C1VBIEN   0x04000000  /* Cap 1 VBI end enable */
 135 #define   VDE_I_LVDSSI    0x08000000  /* LVDS sense interrupt */
 136 #define   VDE_I_C0AVEN    0x10000000  /* Cap 0 act vid end enable */
 137 #define   VDE_I_C0VBIEN   0x20000000  /* Cap 0 VBI end enable */
 138 #define   VDE_I_LVDSSIEN  0x40000000  /* LVDS Sense enable */
 139 #define   VDE_I_ENABLE    0x80000000  /* Global interrupt enable */
 140 
 141 #if defined(CONFIG_VIDEO_VIA_CAMERA) || defined(CONFIG_VIDEO_VIA_CAMERA_MODULE)
 142 /*
 143  * DMA management.
 144  */
 145 int viafb_request_dma(void);
 146 void viafb_release_dma(void);
 147 /* void viafb_dma_copy_out(unsigned int offset, dma_addr_t paddr, int len); */
 148 int viafb_dma_copy_out_sg(unsigned int offset, struct scatterlist *sg, int nsg);
 149 
 150 /*
 151  * DMA Controller registers.
 152  */
 153 #define VDMA_MR0        0xe00           /* Mod reg 0 */
 154 #define   VDMA_MR_CHAIN   0x01          /* Chaining mode */
 155 #define   VDMA_MR_TDIE    0x02          /* Transfer done int enable */
 156 #define VDMA_CSR0       0xe04           /* Control/status */
 157 #define   VDMA_C_ENABLE   0x01            /* DMA Enable */
 158 #define   VDMA_C_START    0x02            /* Start a transfer */
 159 #define   VDMA_C_ABORT    0x04            /* Abort a transfer */
 160 #define   VDMA_C_DONE     0x08            /* Transfer is done */
 161 #define VDMA_MARL0      0xe20           /* Mem addr low */
 162 #define VDMA_MARH0      0xe24           /* Mem addr high */
 163 #define VDMA_DAR0       0xe28           /* Device address */
 164 #define VDMA_DQWCR0     0xe2c           /* Count (16-byte) */
 165 #define VDMA_TMR0       0xe30           /* Tile mode reg */
 166 #define VDMA_DPRL0      0xe34           /* Not sure */
 167 #define   VDMA_DPR_IN     0x08          /* Inbound transfer to FB */
 168 #define VDMA_DPRH0      0xe38
 169 #define VDMA_PMR0       (0xe00 + 0x134) /* Pitch mode */
 170 
 171 /*
 172  * Useful stuff that probably belongs somewhere global.
 173  */
 174 #define VGA_WIDTH       640
 175 #define VGA_HEIGHT      480
 176 #endif /* CONFIG_VIDEO_VIA_CAMERA */
 177 
 178 /*
 179  * Indexed port operations.  Note that these are all multi-op
 180  * functions; every invocation will be racy if you're not holding
 181  * reg_lock.
 182  */
 183 
 184 #define VIAStatus   0x3DA  /* Non-indexed port */
 185 #define VIACR       0x3D4
 186 #define VIASR       0x3C4
 187 #define VIAGR       0x3CE
 188 #define VIAAR       0x3C0
 189 
 190 static inline u8 via_read_reg(u16 port, u8 index)
 191 {
 192         outb(index, port);
 193         return inb(port + 1);
 194 }
 195 
 196 static inline void via_write_reg(u16 port, u8 index, u8 data)
 197 {
 198         outb(index, port);
 199         outb(data, port + 1);
 200 }
 201 
 202 static inline void via_write_reg_mask(u16 port, u8 index, u8 data, u8 mask)
 203 {
 204         u8 old;
 205 
 206         outb(index, port);
 207         old = inb(port + 1);
 208         outb((data & mask) | (old & ~mask), port + 1);
 209 }
 210 
 211 #define VIA_MISC_REG_READ       0x03CC
 212 #define VIA_MISC_REG_WRITE      0x03C2
 213 
 214 static inline void via_write_misc_reg_mask(u8 data, u8 mask)
 215 {
 216         u8 old = inb(VIA_MISC_REG_READ);
 217         outb((data & mask) | (old & ~mask), VIA_MISC_REG_WRITE);
 218 }
 219 
 220 
 221 #endif /* __VIA_CORE_H__ */