root/drivers/cpufreq/kirkwood-cpufreq.c

/* [<][>][^][v][top][bottom][index][help] */

DEFINITIONS

This source file includes following definitions.
  1. kirkwood_cpufreq_get_cpu_frequency
  2. kirkwood_cpufreq_target
  3. kirkwood_cpufreq_cpu_init
  4. kirkwood_cpufreq_probe
  5. kirkwood_cpufreq_remove

   1 // SPDX-License-Identifier: GPL-2.0-or-later
   2 /*
   3  *      kirkwood_freq.c: cpufreq driver for the Marvell kirkwood
   4  *
   5  *      Copyright (C) 2013 Andrew Lunn <andrew@lunn.ch>
   6  */
   7 
   8 #include <linux/kernel.h>
   9 #include <linux/module.h>
  10 #include <linux/clk.h>
  11 #include <linux/cpufreq.h>
  12 #include <linux/of_device.h>
  13 #include <linux/platform_device.h>
  14 #include <linux/io.h>
  15 #include <asm/proc-fns.h>
  16 
  17 #define CPU_SW_INT_BLK BIT(28)
  18 
  19 static struct priv
  20 {
  21         struct clk *cpu_clk;
  22         struct clk *ddr_clk;
  23         struct clk *powersave_clk;
  24         struct device *dev;
  25         void __iomem *base;
  26 } priv;
  27 
  28 #define STATE_CPU_FREQ 0x01
  29 #define STATE_DDR_FREQ 0x02
  30 
  31 /*
  32  * Kirkwood can swap the clock to the CPU between two clocks:
  33  *
  34  * - cpu clk
  35  * - ddr clk
  36  *
  37  * The frequencies are set at runtime before registering this table.
  38  */
  39 static struct cpufreq_frequency_table kirkwood_freq_table[] = {
  40         {0, STATE_CPU_FREQ,     0}, /* CPU uses cpuclk */
  41         {0, STATE_DDR_FREQ,     0}, /* CPU uses ddrclk */
  42         {0, 0,                  CPUFREQ_TABLE_END},
  43 };
  44 
  45 static unsigned int kirkwood_cpufreq_get_cpu_frequency(unsigned int cpu)
  46 {
  47         return clk_get_rate(priv.powersave_clk) / 1000;
  48 }
  49 
  50 static int kirkwood_cpufreq_target(struct cpufreq_policy *policy,
  51                             unsigned int index)
  52 {
  53         unsigned int state = kirkwood_freq_table[index].driver_data;
  54         unsigned long reg;
  55 
  56         local_irq_disable();
  57 
  58         /* Disable interrupts to the CPU */
  59         reg = readl_relaxed(priv.base);
  60         reg |= CPU_SW_INT_BLK;
  61         writel_relaxed(reg, priv.base);
  62 
  63         switch (state) {
  64         case STATE_CPU_FREQ:
  65                 clk_set_parent(priv.powersave_clk, priv.cpu_clk);
  66                 break;
  67         case STATE_DDR_FREQ:
  68                 clk_set_parent(priv.powersave_clk, priv.ddr_clk);
  69                 break;
  70         }
  71 
  72         /* Wait-for-Interrupt, while the hardware changes frequency */
  73         cpu_do_idle();
  74 
  75         /* Enable interrupts to the CPU */
  76         reg = readl_relaxed(priv.base);
  77         reg &= ~CPU_SW_INT_BLK;
  78         writel_relaxed(reg, priv.base);
  79 
  80         local_irq_enable();
  81 
  82         return 0;
  83 }
  84 
  85 /* Module init and exit code */
  86 static int kirkwood_cpufreq_cpu_init(struct cpufreq_policy *policy)
  87 {
  88         cpufreq_generic_init(policy, kirkwood_freq_table, 5000);
  89         return 0;
  90 }
  91 
  92 static struct cpufreq_driver kirkwood_cpufreq_driver = {
  93         .flags  = CPUFREQ_NEED_INITIAL_FREQ_CHECK,
  94         .get    = kirkwood_cpufreq_get_cpu_frequency,
  95         .verify = cpufreq_generic_frequency_table_verify,
  96         .target_index = kirkwood_cpufreq_target,
  97         .init   = kirkwood_cpufreq_cpu_init,
  98         .name   = "kirkwood-cpufreq",
  99         .attr   = cpufreq_generic_attr,
 100 };
 101 
 102 static int kirkwood_cpufreq_probe(struct platform_device *pdev)
 103 {
 104         struct device_node *np;
 105         struct resource *res;
 106         int err;
 107 
 108         priv.dev = &pdev->dev;
 109 
 110         res = platform_get_resource(pdev, IORESOURCE_MEM, 0);
 111         priv.base = devm_ioremap_resource(&pdev->dev, res);
 112         if (IS_ERR(priv.base))
 113                 return PTR_ERR(priv.base);
 114 
 115         np = of_cpu_device_node_get(0);
 116         if (!np) {
 117                 dev_err(&pdev->dev, "failed to get cpu device node\n");
 118                 return -ENODEV;
 119         }
 120 
 121         priv.cpu_clk = of_clk_get_by_name(np, "cpu_clk");
 122         if (IS_ERR(priv.cpu_clk)) {
 123                 dev_err(priv.dev, "Unable to get cpuclk\n");
 124                 err = PTR_ERR(priv.cpu_clk);
 125                 goto out_node;
 126         }
 127 
 128         err = clk_prepare_enable(priv.cpu_clk);
 129         if (err) {
 130                 dev_err(priv.dev, "Unable to prepare cpuclk\n");
 131                 goto out_node;
 132         }
 133 
 134         kirkwood_freq_table[0].frequency = clk_get_rate(priv.cpu_clk) / 1000;
 135 
 136         priv.ddr_clk = of_clk_get_by_name(np, "ddrclk");
 137         if (IS_ERR(priv.ddr_clk)) {
 138                 dev_err(priv.dev, "Unable to get ddrclk\n");
 139                 err = PTR_ERR(priv.ddr_clk);
 140                 goto out_cpu;
 141         }
 142 
 143         err = clk_prepare_enable(priv.ddr_clk);
 144         if (err) {
 145                 dev_err(priv.dev, "Unable to prepare ddrclk\n");
 146                 goto out_cpu;
 147         }
 148         kirkwood_freq_table[1].frequency = clk_get_rate(priv.ddr_clk) / 1000;
 149 
 150         priv.powersave_clk = of_clk_get_by_name(np, "powersave");
 151         if (IS_ERR(priv.powersave_clk)) {
 152                 dev_err(priv.dev, "Unable to get powersave\n");
 153                 err = PTR_ERR(priv.powersave_clk);
 154                 goto out_ddr;
 155         }
 156         err = clk_prepare_enable(priv.powersave_clk);
 157         if (err) {
 158                 dev_err(priv.dev, "Unable to prepare powersave clk\n");
 159                 goto out_ddr;
 160         }
 161 
 162         err = cpufreq_register_driver(&kirkwood_cpufreq_driver);
 163         if (err) {
 164                 dev_err(priv.dev, "Failed to register cpufreq driver\n");
 165                 goto out_powersave;
 166         }
 167 
 168         of_node_put(np);
 169         return 0;
 170 
 171 out_powersave:
 172         clk_disable_unprepare(priv.powersave_clk);
 173 out_ddr:
 174         clk_disable_unprepare(priv.ddr_clk);
 175 out_cpu:
 176         clk_disable_unprepare(priv.cpu_clk);
 177 out_node:
 178         of_node_put(np);
 179 
 180         return err;
 181 }
 182 
 183 static int kirkwood_cpufreq_remove(struct platform_device *pdev)
 184 {
 185         cpufreq_unregister_driver(&kirkwood_cpufreq_driver);
 186 
 187         clk_disable_unprepare(priv.powersave_clk);
 188         clk_disable_unprepare(priv.ddr_clk);
 189         clk_disable_unprepare(priv.cpu_clk);
 190 
 191         return 0;
 192 }
 193 
 194 static struct platform_driver kirkwood_cpufreq_platform_driver = {
 195         .probe = kirkwood_cpufreq_probe,
 196         .remove = kirkwood_cpufreq_remove,
 197         .driver = {
 198                 .name = "kirkwood-cpufreq",
 199         },
 200 };
 201 
 202 module_platform_driver(kirkwood_cpufreq_platform_driver);
 203 
 204 MODULE_LICENSE("GPL v2");
 205 MODULE_AUTHOR("Andrew Lunn <andrew@lunn.ch");
 206 MODULE_DESCRIPTION("cpufreq driver for Marvell's kirkwood CPU");
 207 MODULE_ALIAS("platform:kirkwood-cpufreq");

/* [<][>][^][v][top][bottom][index][help] */