root/drivers/crypto/bcm/spum.h

/* [<][>][^][v][top][bottom][index][help] */

INCLUDED FROM


   1 /* SPDX-License-Identifier: GPL-2.0-only */
   2 /*
   3  * Copyright 2016 Broadcom
   4  */
   5 
   6 /*
   7  * This file contains SPU message definitions specific to SPU-M.
   8  */
   9 
  10 #ifndef _SPUM_H_
  11 #define _SPUM_H_
  12 
  13 #define SPU_CRYPTO_OPERATION_GENERIC    0x1
  14 
  15 /* Length of STATUS field in tx and rx packets */
  16 #define SPU_TX_STATUS_LEN  4
  17 
  18 /* SPU-M error codes */
  19 #define SPU_STATUS_MASK                 0x0000FF00
  20 #define SPU_STATUS_SUCCESS              0x00000000
  21 #define SPU_STATUS_INVALID_ICV          0x00000100
  22 
  23 #define SPU_STATUS_ERROR_FLAG           0x00020000
  24 
  25 /* Request message. MH + EMH + BDESC + BD header */
  26 #define SPU_REQ_FIXED_LEN 24
  27 
  28 /*
  29  * Max length of a SPU message header. Used to allocate a buffer where
  30  * the SPU message header is constructed. Can be used for either a SPU-M
  31  * header or a SPU2 header.
  32  * For SPU-M, sum of the following:
  33  *    MH - 4 bytes
  34  *    EMH - 4
  35  *    SCTX - 3 +
  36  *      max auth key len - 64
  37  *      max cipher key len - 264 (RC4)
  38  *      max IV len - 16
  39  *    BDESC - 12
  40  *    BD header - 4
  41  * Total:  371
  42  *
  43  * For SPU2, FMD_SIZE (32) plus lengths of hash and cipher keys,
  44  * hash and cipher IVs. If SPU2 does not support RC4, then
  45  */
  46 #define SPU_HEADER_ALLOC_LEN  (SPU_REQ_FIXED_LEN + MAX_KEY_SIZE + \
  47                                 MAX_KEY_SIZE + MAX_IV_SIZE)
  48 
  49 /*
  50  * Response message header length. Normally MH, EMH, BD header, but when
  51  * BD_SUPPRESS is used for hash requests, there is no BD header.
  52  */
  53 #define SPU_RESP_HDR_LEN 12
  54 #define SPU_HASH_RESP_HDR_LEN 8
  55 
  56 /*
  57  * Max value that can be represented in the Payload Length field of the BD
  58  * header. This is a 16-bit field.
  59  */
  60 #define SPUM_NS2_MAX_PAYLOAD  (BIT(16) - 1)
  61 
  62 /*
  63  * NSP SPU is limited to ~9KB because of FA2 FIFO size limitations;
  64  * Set MAX_PAYLOAD to 8k to allow for addition of header, digest, etc.
  65  * and stay within limitation.
  66  */
  67 
  68 #define SPUM_NSP_MAX_PAYLOAD    8192
  69 
  70 /* Buffer Descriptor Header [BDESC]. SPU in big-endian mode. */
  71 struct BDESC_HEADER {
  72         u16 offset_mac;         /* word 0 [31-16] */
  73         u16 length_mac;         /* word 0 [15-0]  */
  74         u16 offset_crypto;      /* word 1 [31-16] */
  75         u16 length_crypto;      /* word 1 [15-0]  */
  76         u16 offset_icv;         /* word 2 [31-16] */
  77         u16 offset_iv;          /* word 2 [15-0]  */
  78 };
  79 
  80 /* Buffer Data Header [BD]. SPU in big-endian mode. */
  81 struct BD_HEADER {
  82         u16 size;
  83         u16 prev_length;
  84 };
  85 
  86 /* Command Context Header. SPU-M in big endian mode. */
  87 struct MHEADER {
  88         u8 flags;       /* [31:24] */
  89         u8 op_code;     /* [23:16] */
  90         u16 reserved;   /* [15:0] */
  91 };
  92 
  93 /* MH header flags bits */
  94 #define MH_SUPDT_PRES   BIT(0)
  95 #define MH_HASH_PRES    BIT(2)
  96 #define MH_BD_PRES      BIT(3)
  97 #define MH_MFM_PRES     BIT(4)
  98 #define MH_BDESC_PRES   BIT(5)
  99 #define MH_SCTX_PRES    BIT(7)
 100 
 101 /* SCTX word 0 bit offsets and fields masks */
 102 #define SCTX_SIZE               0x000000FF
 103 
 104 /* SCTX word 1 bit shifts and field masks */
 105 #define  UPDT_OFST              0x000000FF   /* offset of SCTX updateable fld */
 106 #define  HASH_TYPE              0x00000300   /* hash alg operation type */
 107 #define  HASH_TYPE_SHIFT                 8
 108 #define  HASH_MODE              0x00001C00   /* one of spu2_hash_mode */
 109 #define  HASH_MODE_SHIFT                10
 110 #define  HASH_ALG               0x0000E000   /* hash algorithm */
 111 #define  HASH_ALG_SHIFT                 13
 112 #define  CIPHER_TYPE            0x00030000   /* encryption operation type */
 113 #define  CIPHER_TYPE_SHIFT              16
 114 #define  CIPHER_MODE            0x001C0000   /* encryption mode */
 115 #define  CIPHER_MODE_SHIFT              18
 116 #define  CIPHER_ALG             0x00E00000   /* encryption algo */
 117 #define  CIPHER_ALG_SHIFT               21
 118 #define  ICV_IS_512                BIT(27)
 119 #define  ICV_IS_512_SHIFT               27
 120 #define  CIPHER_ORDER               BIT(30)
 121 #define  CIPHER_ORDER_SHIFT             30
 122 #define  CIPHER_INBOUND             BIT(31)
 123 #define  CIPHER_INBOUND_SHIFT           31
 124 
 125 /* SCTX word 2 bit shifts and field masks */
 126 #define  EXP_IV_SIZE                   0x7
 127 #define  IV_OFFSET                   BIT(3)
 128 #define  IV_OFFSET_SHIFT                 3
 129 #define  GEN_IV                      BIT(5)
 130 #define  GEN_IV_SHIFT                    5
 131 #define  EXPLICIT_IV                 BIT(6)
 132 #define  EXPLICIT_IV_SHIFT               6
 133 #define  SCTX_IV                     BIT(7)
 134 #define  SCTX_IV_SHIFT                   7
 135 #define  ICV_SIZE                   0x0F00
 136 #define  ICV_SIZE_SHIFT                  8
 137 #define  CHECK_ICV                  BIT(12)
 138 #define  CHECK_ICV_SHIFT                12
 139 #define  INSERT_ICV                 BIT(13)
 140 #define  INSERT_ICV_SHIFT               13
 141 #define  BD_SUPPRESS                BIT(19)
 142 #define  BD_SUPPRESS_SHIFT              19
 143 
 144 /* Generic Mode Security Context Structure [SCTX] */
 145 struct SCTX {
 146 /* word 0: protocol flags */
 147         u32 proto_flags;
 148 
 149 /* word 1: cipher flags */
 150         u32 cipher_flags;
 151 
 152 /* word 2: Extended cipher flags */
 153         u32 ecf;
 154 
 155 };
 156 
 157 struct SPUHEADER {
 158         struct MHEADER mh;
 159         u32 emh;
 160         struct SCTX sa;
 161 };
 162 
 163 #endif /* _SPUM_H_ */

/* [<][>][^][v][top][bottom][index][help] */