root/drivers/video/fbdev/geode/video_cs5530.c

DEFINITIONS

1. cs5530_set_dclk_frequency
2. cs5530_configure_display
3. cs5530_blank_display

   1 // SPDX-License-Identifier: GPL-2.0-or-later
   2 /*
   3  * drivers/video/geode/video_cs5530.c
   4  *   -- CS5530 video device
   5  *
   6  * Copyright (C) 2005 Arcom Control Systems Ltd.
   7  *
   8  * Based on AMD's original 2.4 driver:
   9  *   Copyright (C) 2004 Advanced Micro Devices, Inc.
  10  */
  11 #include <linux/fb.h>
  12 #include <linux/delay.h>
  13 #include <asm/io.h>
  14 #include <asm/delay.h>
  15 
  16 #include "geodefb.h"
  17 #include "video_cs5530.h"
  18 
  19 /*
  20  * CS5530 PLL table. This maps pixclocks to the appropriate PLL register
  21  * value.
  22  */
  23 struct cs5530_pll_entry {
  24         long pixclock; /* ps */
  25         u32 pll_value;
  26 };
  27 
  28 static const struct cs5530_pll_entry cs5530_pll_table[] = {
  29         { 39721, 0x31C45801, }, /*  25.1750 MHz */
  30         { 35308, 0x20E36802, }, /*  28.3220 */
  31         { 31746, 0x33915801, }, /*  31.5000 */
  32         { 27777, 0x31EC4801, }, /*  36.0000 */
  33         { 26666, 0x21E22801, }, /*  37.5000 */
  34         { 25000, 0x33088801, }, /*  40.0000 */
  35         { 22271, 0x33E22801, }, /*  44.9000 */
  36         { 20202, 0x336C4801, }, /*  49.5000 */
  37         { 20000, 0x23088801, }, /*  50.0000 */
  38         { 19860, 0x23088801, }, /*  50.3500 */
  39         { 18518, 0x3708A801, }, /*  54.0000 */
  40         { 17777, 0x23E36802, }, /*  56.2500 */
  41         { 17733, 0x23E36802, }, /*  56.3916 */
  42         { 17653, 0x23E36802, }, /*  56.6444 */
  43         { 16949, 0x37C45801, }, /*  59.0000 */
  44         { 15873, 0x23EC4801, }, /*  63.0000 */
  45         { 15384, 0x37911801, }, /*  65.0000 */
  46         { 14814, 0x37963803, }, /*  67.5000 */
  47         { 14124, 0x37058803, }, /*  70.8000 */
  48         { 13888, 0x3710C805, }, /*  72.0000 */
  49         { 13333, 0x37E22801, }, /*  75.0000 */
  50         { 12698, 0x27915801, }, /*  78.7500 */
  51         { 12500, 0x37D8D802, }, /*  80.0000 */
  52         { 11135, 0x27588802, }, /*  89.8000 */
  53         { 10582, 0x27EC4802, }, /*  94.5000 */
  54         { 10101, 0x27AC6803, }, /*  99.0000 */
  55         { 10000, 0x27088801, }, /* 100.0000 */
  56         {  9259, 0x2710C805, }, /* 108.0000 */
  57         {  8888, 0x27E36802, }, /* 112.5000 */
  58         {  7692, 0x27C58803, }, /* 130.0000 */
  59         {  7407, 0x27316803, }, /* 135.0000 */
  60         {  6349, 0x2F915801, }, /* 157.5000 */
  61         {  6172, 0x2F08A801, }, /* 162.0000 */
  62         {  5714, 0x2FB11802, }, /* 175.0000 */
  63         {  5291, 0x2FEC4802, }, /* 189.0000 */
  64         {  4950, 0x2F963803, }, /* 202.0000 */
  65         {  4310, 0x2FB1B802, }, /* 232.0000 */
  66 };
  67 
  68 static void cs5530_set_dclk_frequency(struct fb_info *info)
  69 {
  70         struct geodefb_par *par = info->par;
  71         int i;
  72         u32 value;
  73         long min, diff;
  74 
  75         /* Search the table for the closest pixclock. */
  76         value = cs5530_pll_table[0].pll_value;
  77         min = cs5530_pll_table[0].pixclock - info->var.pixclock;
  78         if (min < 0) min = -min;
  79         for (i = 1; i < ARRAY_SIZE(cs5530_pll_table); i++) {
  80                 diff = cs5530_pll_table[i].pixclock - info->var.pixclock;
  81                 if (diff < 0L) diff = -diff;
  82                 if (diff < min) {
  83                         min = diff;
  84                         value = cs5530_pll_table[i].pll_value;
  85                 }
  86         }
  87 
  88         writel(value, par->vid_regs + CS5530_DOT_CLK_CONFIG);
  89         writel(value | 0x80000100, par->vid_regs + CS5530_DOT_CLK_CONFIG); /* set reset and bypass */
  90         udelay(500); /* wait for PLL to settle */
  91         writel(value & 0x7FFFFFFF, par->vid_regs + CS5530_DOT_CLK_CONFIG); /* clear reset */
  92         writel(value & 0x7FFFFEFF, par->vid_regs + CS5530_DOT_CLK_CONFIG); /* clear bypass */
  93 }
  94 
  95 static void cs5530_configure_display(struct fb_info *info)
  96 {
  97         struct geodefb_par *par = info->par;
  98         u32 dcfg;
  99 
 100         dcfg = readl(par->vid_regs + CS5530_DISPLAY_CONFIG);
 101 
 102         /* Clear bits from existing mode. */
 103         dcfg &= ~(CS5530_DCFG_CRT_SYNC_SKW_MASK | CS5530_DCFG_PWR_SEQ_DLY_MASK
 104                   | CS5530_DCFG_CRT_HSYNC_POL   | CS5530_DCFG_CRT_VSYNC_POL
 105                   | CS5530_DCFG_FP_PWR_EN       | CS5530_DCFG_FP_DATA_EN
 106                   | CS5530_DCFG_DAC_PWR_EN      | CS5530_DCFG_VSYNC_EN
 107                   | CS5530_DCFG_HSYNC_EN);
 108 
 109         /* Set default sync skew and power sequence delays.  */
 110         dcfg |= (CS5530_DCFG_CRT_SYNC_SKW_INIT | CS5530_DCFG_PWR_SEQ_DLY_INIT
 111                  | CS5530_DCFG_GV_PAL_BYP);
 112 
 113         /* Enable DACs, hsync and vsync for CRTs */
 114         if (par->enable_crt) {
 115                 dcfg |= CS5530_DCFG_DAC_PWR_EN;
 116                 dcfg |= CS5530_DCFG_HSYNC_EN | CS5530_DCFG_VSYNC_EN;
 117         }
 118         /* Enable panel power and data if using a flat panel. */
 119         if (par->panel_x > 0) {
 120                 dcfg |= CS5530_DCFG_FP_PWR_EN;
 121                 dcfg |= CS5530_DCFG_FP_DATA_EN;
 122         }
 123 
 124         /* Sync polarities. */
 125         if (info->var.sync & FB_SYNC_HOR_HIGH_ACT)
 126                 dcfg |= CS5530_DCFG_CRT_HSYNC_POL;
 127         if (info->var.sync & FB_SYNC_VERT_HIGH_ACT)
 128                 dcfg |= CS5530_DCFG_CRT_VSYNC_POL;
 129 
 130         writel(dcfg, par->vid_regs + CS5530_DISPLAY_CONFIG);
 131 }
 132 
 133 static int cs5530_blank_display(struct fb_info *info, int blank_mode)
 134 {
 135         struct geodefb_par *par = info->par;
 136         u32 dcfg;
 137         int blank, hsync, vsync;
 138 
 139         switch (blank_mode) {
 140         case FB_BLANK_UNBLANK:
 141                 blank = 0; hsync = 1; vsync = 1;
 142                 break;
 143         case FB_BLANK_NORMAL:
 144                 blank = 1; hsync = 1; vsync = 1;
 145                 break;
 146         case FB_BLANK_VSYNC_SUSPEND:
 147                 blank = 1; hsync = 1; vsync = 0;
 148                 break;
 149         case FB_BLANK_HSYNC_SUSPEND:
 150                 blank = 1; hsync = 0; vsync = 1;
 151                 break;
 152         case FB_BLANK_POWERDOWN:
 153                 blank = 1; hsync = 0; vsync = 0;
 154                 break;
 155         default:
 156                 return -EINVAL;
 157         }
 158 
 159         dcfg = readl(par->vid_regs + CS5530_DISPLAY_CONFIG);
 160 
 161         dcfg &= ~(CS5530_DCFG_DAC_BL_EN | CS5530_DCFG_DAC_PWR_EN
 162                   | CS5530_DCFG_HSYNC_EN | CS5530_DCFG_VSYNC_EN
 163                   | CS5530_DCFG_FP_DATA_EN | CS5530_DCFG_FP_PWR_EN);
 164 
 165         if (par->enable_crt) {
 166                 if (!blank)
 167                         dcfg |= CS5530_DCFG_DAC_BL_EN | CS5530_DCFG_DAC_PWR_EN;
 168                 if (hsync)
 169                         dcfg |= CS5530_DCFG_HSYNC_EN;
 170                 if (vsync)
 171                         dcfg |= CS5530_DCFG_VSYNC_EN;
 172         }
 173         if (par->panel_x > 0) {
 174                 if (!blank)
 175                         dcfg |= CS5530_DCFG_FP_DATA_EN;
 176                 if (hsync && vsync)
 177                         dcfg |= CS5530_DCFG_FP_PWR_EN;
 178         }
 179 
 180         writel(dcfg, par->vid_regs + CS5530_DISPLAY_CONFIG);
 181 
 182         return 0;
 183 }
 184 
 185 const struct geode_vid_ops cs5530_vid_ops = {
 186         .set_dclk          = cs5530_set_dclk_frequency,
 187         .configure_display = cs5530_configure_display,
 188         .blank_display     = cs5530_blank_display,
 189 };