1 /* SPDX-License-Identifier: GPL-2.0-or-later */ 2 /* 3 * Simple Reset Controller ops 4 * 5 * Based on Allwinner SoCs Reset Controller driver 6 * 7 * Copyright 2013 Maxime Ripard 8 * 9 * Maxime Ripard <maxime.ripard@free-electrons.com> 10 */ 11 12 #ifndef __RESET_SIMPLE_H__ 13 #define __RESET_SIMPLE_H__ 14 15 #include <linux/io.h> 16 #include <linux/reset-controller.h> 17 #include <linux/spinlock.h> 18 19 /** 20 * struct reset_simple_data - driver data for simple reset controllers 21 * @lock: spinlock to protect registers during read-modify-write cycles 22 * @membase: memory mapped I/O register range 23 * @rcdev: reset controller device base structure 24 * @active_low: if true, bits are cleared to assert the reset. Otherwise, bits 25 * are set to assert the reset. Note that this says nothing about 26 * the voltage level of the actual reset line. 27 * @status_active_low: if true, bits read back as cleared while the reset is 28 * asserted. Otherwise, bits read back as set while the 29 * reset is asserted. 30 */ 31 struct reset_simple_data { 32 spinlock_t lock; 33 void __iomem *membase; 34 struct reset_controller_dev rcdev; 35 bool active_low; 36 bool status_active_low; 37 }; 38 39 extern const struct reset_control_ops reset_simple_ops; 40 41 #endif /* __RESET_SIMPLE_H__ */