root/drivers/media/dvb-frontends/m88ds3103.h

/* [<][>][^][v][top][bottom][index][help] */

INCLUDED FROM


DEFINITIONS

This source file includes following definitions.
  1. m88ds3103_attach

   1 /* SPDX-License-Identifier: GPL-2.0-or-later */
   2 /*
   3  * Montage Technology M88DS3103/M88RS6000 demodulator driver
   4  *
   5  * Copyright (C) 2013 Antti Palosaari <crope@iki.fi>
   6  */
   7 
   8 #ifndef M88DS3103_H
   9 #define M88DS3103_H
  10 
  11 #include <linux/dvb/frontend.h>
  12 
  13 /*
  14  * I2C address
  15  * 0x68,
  16  */
  17 
  18 /**
  19  * enum m88ds3103_ts_mode - TS connection mode
  20  * @M88DS3103_TS_SERIAL:        TS output pin D0, normal
  21  * @M88DS3103_TS_SERIAL_D7:     TS output pin D7
  22  * @M88DS3103_TS_PARALLEL:      TS Parallel mode
  23  * @M88DS3103_TS_CI:            TS CI Mode
  24  */
  25 enum m88ds3103_ts_mode {
  26         M88DS3103_TS_SERIAL,
  27         M88DS3103_TS_SERIAL_D7,
  28         M88DS3103_TS_PARALLEL,
  29         M88DS3103_TS_CI
  30 };
  31 
  32 /**
  33  * enum m88ds3103_clock_out
  34  * @M88DS3103_CLOCK_OUT_DISABLED:       Clock output is disabled
  35  * @M88DS3103_CLOCK_OUT_ENABLED:        Clock output is enabled with crystal
  36  *                                      clock.
  37  * @M88DS3103_CLOCK_OUT_ENABLED_DIV2:   Clock output is enabled with half
  38  *                                      crystal clock.
  39  */
  40 enum m88ds3103_clock_out {
  41         M88DS3103_CLOCK_OUT_DISABLED,
  42         M88DS3103_CLOCK_OUT_ENABLED,
  43         M88DS3103_CLOCK_OUT_ENABLED_DIV2
  44 };
  45 
  46 /**
  47  * struct m88ds3103_platform_data - Platform data for the m88ds3103 driver
  48  * @clk: Clock frequency.
  49  * @i2c_wr_max: Max bytes I2C adapter can write at once.
  50  * @ts_mode: TS mode.
  51  * @ts_clk: TS clock (KHz).
  52  * @ts_clk_pol: TS clk polarity. 1-active at falling edge; 0-active at rising
  53  *  edge.
  54  * @spec_inv: Input spectrum inversion.
  55  * @agc: AGC configuration.
  56  * @agc_inv: AGC polarity.
  57  * @clk_out: Clock output.
  58  * @envelope_mode: DiSEqC envelope mode.
  59  * @lnb_hv_pol: LNB H/V pin polarity. 0: pin high set to VOLTAGE_18, pin low to
  60  *  set VOLTAGE_13. 1: pin high set to VOLTAGE_13, pin low to set VOLTAGE_18.
  61  * @lnb_en_pol: LNB enable pin polarity. 0: pin high to disable, pin low to
  62  *  enable. 1: pin high to enable, pin low to disable.
  63  * @get_dvb_frontend: Get DVB frontend.
  64  * @get_i2c_adapter: Get I2C adapter.
  65  */
  66 struct m88ds3103_platform_data {
  67         u32 clk;
  68         u16 i2c_wr_max;
  69         enum m88ds3103_ts_mode ts_mode;
  70         u32 ts_clk;
  71         enum m88ds3103_clock_out clk_out;
  72         u8 ts_clk_pol:1;
  73         u8 spec_inv:1;
  74         u8 agc;
  75         u8 agc_inv:1;
  76         u8 envelope_mode:1;
  77         u8 lnb_hv_pol:1;
  78         u8 lnb_en_pol:1;
  79 
  80         struct dvb_frontend* (*get_dvb_frontend)(struct i2c_client *);
  81         struct i2c_adapter* (*get_i2c_adapter)(struct i2c_client *);
  82 
  83 /* private: For legacy media attach wrapper. Do not set value. */
  84         u8 attach_in_use:1;
  85 };
  86 
  87 /**
  88  * struct m88ds3103_config - m88ds3102 configuration
  89  *
  90  * @i2c_addr:   I2C address. Default: none, must set. Example: 0x68, ...
  91  * @clock:      Device's clock. Default: none, must set. Example: 27000000
  92  * @i2c_wr_max: Max bytes I2C provider is asked to write at once.
  93  *              Default: none, must set. Example: 33, 65, ...
  94  * @ts_mode:    TS output mode, as defined by &enum m88ds3103_ts_mode.
  95  *              Default: M88DS3103_TS_SERIAL.
  96  * @ts_clk:     TS clk in KHz. Default: 0.
  97  * @ts_clk_pol: TS clk polarity.Default: 0.
  98  *              1-active at falling edge; 0-active at rising edge.
  99  * @spec_inv:   Spectrum inversion. Default: 0.
 100  * @agc_inv:    AGC polarity. Default: 0.
 101  * @clock_out:  Clock output, as defined by &enum m88ds3103_clock_out.
 102  *              Default: M88DS3103_CLOCK_OUT_DISABLED.
 103  * @envelope_mode: DiSEqC envelope mode. Default: 0.
 104  * @agc:        AGC configuration. Default: none, must set.
 105  * @lnb_hv_pol: LNB H/V pin polarity. Default: 0. Values:
 106  *              1: pin high set to VOLTAGE_13, pin low to set VOLTAGE_18;
 107  *              0: pin high set to VOLTAGE_18, pin low to set VOLTAGE_13.
 108  * @lnb_en_pol: LNB enable pin polarity. Default: 0. Values:
 109  *              1: pin high to enable, pin low to disable;
 110  *              0: pin high to disable, pin low to enable.
 111  */
 112 struct m88ds3103_config {
 113         u8 i2c_addr;
 114         u32 clock;
 115         u16 i2c_wr_max;
 116         u8 ts_mode;
 117         u32 ts_clk;
 118         u8 ts_clk_pol:1;
 119         u8 spec_inv:1;
 120         u8 agc_inv:1;
 121         u8 clock_out;
 122         u8 envelope_mode:1;
 123         u8 agc;
 124         u8 lnb_hv_pol:1;
 125         u8 lnb_en_pol:1;
 126 };
 127 
 128 #if defined(CONFIG_DVB_M88DS3103) || \
 129                 (defined(CONFIG_DVB_M88DS3103_MODULE) && defined(MODULE))
 130 /**
 131  * Attach a m88ds3103 demod
 132  *
 133  * @config: pointer to &struct m88ds3103_config with demod configuration.
 134  * @i2c: i2c adapter to use.
 135  * @tuner_i2c: on success, returns the I2C adapter associated with
 136  *              m88ds3103 tuner.
 137  *
 138  * return: FE pointer on success, NULL on failure.
 139  * Note: Do not add new m88ds3103_attach() users! Use I2C bindings instead.
 140  */
 141 extern struct dvb_frontend *m88ds3103_attach(
 142                 const struct m88ds3103_config *config,
 143                 struct i2c_adapter *i2c,
 144                 struct i2c_adapter **tuner_i2c);
 145 extern int m88ds3103_get_agc_pwm(struct dvb_frontend *fe, u8 *_agc_pwm);
 146 #else
 147 static inline struct dvb_frontend *m88ds3103_attach(
 148                 const struct m88ds3103_config *config,
 149                 struct i2c_adapter *i2c,
 150                 struct i2c_adapter **tuner_i2c)
 151 {
 152         pr_warn("%s: driver disabled by Kconfig\n", __func__);
 153         return NULL;
 154 }
 155 #define m88ds3103_get_agc_pwm NULL
 156 #endif
 157 
 158 #endif

/* [<][>][^][v][top][bottom][index][help] */