root/arch/mips/pci/fixup-cobalt.c

/* [<][>][^][v][top][bottom][index][help] */

DEFINITIONS

This source file includes following definitions.
  1. qube_raq_galileo_early_fixup
  2. qube_raq_via_bmIDE_fixup
  3. qube_raq_galileo_fixup
  4. qube_raq_via_board_id_fixup
  5. pcibios_map_irq
  6. pcibios_plat_dev_init

   1 /*
   2  * Cobalt Qube/Raq PCI support
   3  *
   4  * This file is subject to the terms and conditions of the GNU General Public
   5  * License.  See the file "COPYING" in the main directory of this archive
   6  * for more details.
   7  *
   8  * Copyright (C) 1995, 1996, 1997, 2002, 2003 by Ralf Baechle
   9  * Copyright (C) 2001, 2002, 2003 by Liam Davies (ldavies@agile.tv)
  10  */
  11 #include <linux/types.h>
  12 #include <linux/pci.h>
  13 #include <linux/kernel.h>
  14 #include <linux/init.h>
  15 
  16 #include <asm/io.h>
  17 #include <asm/gt64120.h>
  18 
  19 #include <cobalt.h>
  20 #include <irq.h>
  21 
  22 /*
  23  * PCI slot numbers
  24  */
  25 #define COBALT_PCICONF_CPU      0x06
  26 #define COBALT_PCICONF_ETH0     0x07
  27 #define COBALT_PCICONF_RAQSCSI  0x08
  28 #define COBALT_PCICONF_VIA      0x09
  29 #define COBALT_PCICONF_PCISLOT  0x0A
  30 #define COBALT_PCICONF_ETH1     0x0C
  31 
  32 /*
  33  * The Cobalt board ID information.  The boards have an ID number wired
  34  * into the VIA that is available in the high nibble of register 94.
  35  */
  36 #define VIA_COBALT_BRD_ID_REG  0x94
  37 #define VIA_COBALT_BRD_REG_to_ID(reg)   ((unsigned char)(reg) >> 4)
  38 
  39 static void qube_raq_galileo_early_fixup(struct pci_dev *dev)
  40 {
  41         if (dev->devfn == PCI_DEVFN(0, 0) &&
  42                 (dev->class >> 8) == PCI_CLASS_MEMORY_OTHER) {
  43 
  44                 dev->class = (PCI_CLASS_BRIDGE_HOST << 8) | (dev->class & 0xff);
  45 
  46                 printk(KERN_INFO "Galileo: fixed bridge class\n");
  47         }
  48 }
  49 
  50 DECLARE_PCI_FIXUP_EARLY(PCI_VENDOR_ID_MARVELL, PCI_DEVICE_ID_MARVELL_GT64111,
  51          qube_raq_galileo_early_fixup);
  52 
  53 static void qube_raq_via_bmIDE_fixup(struct pci_dev *dev)
  54 {
  55         unsigned short cfgword;
  56         unsigned char lt;
  57 
  58         /* Enable Bus Mastering and fast back to back. */
  59         pci_read_config_word(dev, PCI_COMMAND, &cfgword);
  60         cfgword |= (PCI_COMMAND_FAST_BACK | PCI_COMMAND_MASTER);
  61         pci_write_config_word(dev, PCI_COMMAND, cfgword);
  62 
  63         /* Enable both ide interfaces. ROM only enables primary one.  */
  64         pci_write_config_byte(dev, 0x40, 0xb);
  65 
  66         /* Set latency timer to reasonable value. */
  67         pci_read_config_byte(dev, PCI_LATENCY_TIMER, &lt);
  68         if (lt < 64)
  69                 pci_write_config_byte(dev, PCI_LATENCY_TIMER, 64);
  70         pci_write_config_byte(dev, PCI_CACHE_LINE_SIZE, 8);
  71 }
  72 
  73 DECLARE_PCI_FIXUP_HEADER(PCI_VENDOR_ID_VIA, PCI_DEVICE_ID_VIA_82C586_1,
  74          qube_raq_via_bmIDE_fixup);
  75 
  76 static void qube_raq_galileo_fixup(struct pci_dev *dev)
  77 {
  78         if (dev->devfn != PCI_DEVFN(0, 0))
  79                 return;
  80 
  81         /* Fix PCI latency-timer and cache-line-size values in Galileo
  82          * host bridge.
  83          */
  84         pci_write_config_byte(dev, PCI_LATENCY_TIMER, 64);
  85         pci_write_config_byte(dev, PCI_CACHE_LINE_SIZE, 8);
  86 
  87         /*
  88          * The code described by the comment below has been removed
  89          * as it causes bus mastering by the Ethernet controllers
  90          * to break under any kind of network load. We always set
  91          * the retry timeouts to their maximum.
  92          *
  93          * --x--x--x--x--x--x--x--x--x--x--x--x--x--x--x--x--x--x--x--x--
  94          *
  95          * On all machines prior to Q2, we had the STOP line disconnected
  96          * from Galileo to VIA on PCI.  The new Galileo does not function
  97          * correctly unless we have it connected.
  98          *
  99          * Therefore we must set the disconnect/retry cycle values to
 100          * something sensible when using the new Galileo.
 101          */
 102 
 103         printk(KERN_INFO "Galileo: revision %u\n", dev->revision);
 104 
 105 #if 0
 106         if (dev->revision >= 0x10) {
 107                 /* New Galileo, assumes PCI stop line to VIA is connected. */
 108                 GT_WRITE(GT_PCI0_TOR_OFS, 0x4020);
 109         } else if (dev->revision == 0x1 || dev->revision == 0x2)
 110 #endif
 111         {
 112                 signed int timeo;
 113                 /* XXX WE MUST DO THIS ELSE GALILEO LOCKS UP! -DaveM */
 114                 timeo = GT_READ(GT_PCI0_TOR_OFS);
 115                 /* Old Galileo, assumes PCI STOP line to VIA is disconnected. */
 116                 GT_WRITE(GT_PCI0_TOR_OFS,
 117                         (0xff << 16) |          /* retry count */
 118                         (0xff << 8) |           /* timeout 1   */
 119                         0xff);                  /* timeout 0   */
 120 
 121                 /* enable PCI retry exceeded interrupt */
 122                 GT_WRITE(GT_INTRMASK_OFS, GT_INTR_RETRYCTR0_MSK | GT_READ(GT_INTRMASK_OFS));
 123         }
 124 }
 125 
 126 DECLARE_PCI_FIXUP_HEADER(PCI_VENDOR_ID_MARVELL, PCI_DEVICE_ID_MARVELL_GT64111,
 127          qube_raq_galileo_fixup);
 128 
 129 int cobalt_board_id;
 130 
 131 static void qube_raq_via_board_id_fixup(struct pci_dev *dev)
 132 {
 133         u8 id;
 134         int retval;
 135 
 136         retval = pci_read_config_byte(dev, VIA_COBALT_BRD_ID_REG, &id);
 137         if (retval) {
 138                 panic("Cannot read board ID");
 139                 return;
 140         }
 141 
 142         cobalt_board_id = VIA_COBALT_BRD_REG_to_ID(id);
 143 
 144         printk(KERN_INFO "Cobalt board ID: %d\n", cobalt_board_id);
 145 }
 146 
 147 DECLARE_PCI_FIXUP_HEADER(PCI_VENDOR_ID_VIA, PCI_DEVICE_ID_VIA_82C586_0,
 148          qube_raq_via_board_id_fixup);
 149 
 150 static char irq_tab_qube1[] = {
 151   [COBALT_PCICONF_CPU]     = 0,
 152   [COBALT_PCICONF_ETH0]    = QUBE1_ETH0_IRQ,
 153   [COBALT_PCICONF_RAQSCSI] = SCSI_IRQ,
 154   [COBALT_PCICONF_VIA]     = 0,
 155   [COBALT_PCICONF_PCISLOT] = PCISLOT_IRQ,
 156   [COBALT_PCICONF_ETH1]    = 0
 157 };
 158 
 159 static char irq_tab_cobalt[] = {
 160   [COBALT_PCICONF_CPU]     = 0,
 161   [COBALT_PCICONF_ETH0]    = ETH0_IRQ,
 162   [COBALT_PCICONF_RAQSCSI] = SCSI_IRQ,
 163   [COBALT_PCICONF_VIA]     = 0,
 164   [COBALT_PCICONF_PCISLOT] = PCISLOT_IRQ,
 165   [COBALT_PCICONF_ETH1]    = ETH1_IRQ
 166 };
 167 
 168 static char irq_tab_raq2[] = {
 169   [COBALT_PCICONF_CPU]     = 0,
 170   [COBALT_PCICONF_ETH0]    = ETH0_IRQ,
 171   [COBALT_PCICONF_RAQSCSI] = RAQ2_SCSI_IRQ,
 172   [COBALT_PCICONF_VIA]     = 0,
 173   [COBALT_PCICONF_PCISLOT] = PCISLOT_IRQ,
 174   [COBALT_PCICONF_ETH1]    = ETH1_IRQ
 175 };
 176 
 177 int pcibios_map_irq(const struct pci_dev *dev, u8 slot, u8 pin)
 178 {
 179         if (cobalt_board_id <= COBALT_BRD_ID_QUBE1)
 180                 return irq_tab_qube1[slot];
 181 
 182         if (cobalt_board_id == COBALT_BRD_ID_RAQ2)
 183                 return irq_tab_raq2[slot];
 184 
 185         return irq_tab_cobalt[slot];
 186 }
 187 
 188 /* Do platform specific device initialization at pci_enable_device() time */
 189 int pcibios_plat_dev_init(struct pci_dev *dev)
 190 {
 191         return 0;
 192 }

/* [<][>][^][v][top][bottom][index][help] */