root/arch/mips/dec/ioasic-irq.c

DEFINITIONS

1. unmask_ioasic_irq
2. mask_ioasic_irq
3. ack_ioasic_irq
4. clear_ioasic_dma_irq
5. init_ioasic_irqs

   1 // SPDX-License-Identifier: GPL-2.0-or-later
   2 /*
   3  *      DEC I/O ASIC interrupts.
   4  *
   5  *      Copyright (c) 2002, 2003, 2013  Maciej W. Rozycki
   6  */
   7 
   8 #include <linux/init.h>
   9 #include <linux/irq.h>
  10 #include <linux/types.h>
  11 
  12 #include <asm/dec/ioasic.h>
  13 #include <asm/dec/ioasic_addrs.h>
  14 #include <asm/dec/ioasic_ints.h>
  15 
  16 static int ioasic_irq_base;
  17 
  18 static void unmask_ioasic_irq(struct irq_data *d)
  19 {
  20         u32 simr;
  21 
  22         simr = ioasic_read(IO_REG_SIMR);
  23         simr |= (1 << (d->irq - ioasic_irq_base));
  24         ioasic_write(IO_REG_SIMR, simr);
  25 }
  26 
  27 static void mask_ioasic_irq(struct irq_data *d)
  28 {
  29         u32 simr;
  30 
  31         simr = ioasic_read(IO_REG_SIMR);
  32         simr &= ~(1 << (d->irq - ioasic_irq_base));
  33         ioasic_write(IO_REG_SIMR, simr);
  34 }
  35 
  36 static void ack_ioasic_irq(struct irq_data *d)
  37 {
  38         mask_ioasic_irq(d);
  39         fast_iob();
  40 }
  41 
  42 static struct irq_chip ioasic_irq_type = {
  43         .name = "IO-ASIC",
  44         .irq_ack = ack_ioasic_irq,
  45         .irq_mask = mask_ioasic_irq,
  46         .irq_mask_ack = ack_ioasic_irq,
  47         .irq_unmask = unmask_ioasic_irq,
  48 };
  49 
  50 static void clear_ioasic_dma_irq(struct irq_data *d)
  51 {
  52         u32 sir;
  53 
  54         sir = ~(1 << (d->irq - ioasic_irq_base));
  55         ioasic_write(IO_REG_SIR, sir);
  56         fast_iob();
  57 }
  58 
  59 static struct irq_chip ioasic_dma_irq_type = {
  60         .name = "IO-ASIC-DMA",
  61         .irq_ack = clear_ioasic_dma_irq,
  62         .irq_mask = mask_ioasic_irq,
  63         .irq_unmask = unmask_ioasic_irq,
  64         .irq_eoi = clear_ioasic_dma_irq,
  65 };
  66 
  67 /*
  68  * I/O ASIC implements two kinds of DMA interrupts, informational and
  69  * error interrupts.
  70  *
  71  * The formers do not stop DMA and should be cleared as soon as possible
  72  * so that if they retrigger before the handler has completed, usually as
  73  * a side effect of actions taken by the handler, then they are reissued.
  74  * These use the `handle_edge_irq' handler that clears the request right
  75  * away.
  76  *
  77  * The latters stop DMA and do not resume it until the interrupt has been
  78  * cleared.  This cannot be done until after a corrective action has been
  79  * taken and this also means they will not retrigger.  Therefore they use
  80  * the `handle_fasteoi_irq' handler that only clears the request on the
  81  * way out.  Because MIPS processor interrupt inputs, one of which the I/O
  82  * ASIC is cascaded to, are level-triggered it is recommended that error
  83  * DMA interrupt action handlers are registered with the IRQF_ONESHOT flag
  84  * set so that they are run with the interrupt line masked.
  85  *
  86  * This mask has `1' bits in the positions of informational interrupts.
  87  */
  88 #define IO_IRQ_DMA_INFO                                                 \
  89         (IO_IRQ_MASK(IO_INR_SCC0A_RXDMA) |                              \
  90          IO_IRQ_MASK(IO_INR_SCC1A_RXDMA) |                              \
  91          IO_IRQ_MASK(IO_INR_ISDN_TXDMA) |                               \
  92          IO_IRQ_MASK(IO_INR_ISDN_RXDMA) |                               \
  93          IO_IRQ_MASK(IO_INR_ASC_DMA))
  94 
  95 void __init init_ioasic_irqs(int base)
  96 {
  97         int i;
  98 
  99         /* Mask interrupts. */
 100         ioasic_write(IO_REG_SIMR, 0);
 101         fast_iob();
 102 
 103         for (i = base; i < base + IO_INR_DMA; i++)
 104                 irq_set_chip_and_handler(i, &ioasic_irq_type,
 105                                          handle_level_irq);
 106         for (; i < base + IO_IRQ_LINES; i++)
 107                 irq_set_chip_and_handler(i, &ioasic_dma_irq_type,
 108                                          1 << (i - base) & IO_IRQ_DMA_INFO ?
 109                                          handle_edge_irq : handle_fasteoi_irq);
 110 
 111         ioasic_irq_base = base;
 112 }