PRINTK 415 drivers/atm/ambassador.c PRINTK (KERN_ERR, "check_area failure: [%x,%x] - mail maintainer!", PRINTK 496 drivers/atm/ambassador.c PRINTK (KERN_INFO, "dropped over-size frame"); PRINTK 1020 drivers/atm/ambassador.c PRINTK (KERN_WARNING, "rejecting open with unspecified VPI/VCI (deprecated)"); PRINTK 1126 drivers/atm/ambassador.c PRINTK (KERN_ERR, "out of memory!"); PRINTK 1266 drivers/atm/ambassador.c PRINTK (KERN_ERR, "%s vcc=%p rxer[vci]=%p", PRINTK 1311 drivers/atm/ambassador.c PRINTK (KERN_ERR, "attempt to send on RX-only VC %x", vc); PRINTK 1321 drivers/atm/ambassador.c PRINTK (KERN_ERR, "sk_buff length greater than agreed max_sdu, dropping..."); PRINTK 1333 drivers/atm/ambassador.c PRINTK (KERN_ERR, "could not allocate TX descriptor"); PRINTK 1514 drivers/atm/ambassador.c PRINTK (KERN_ERR, "could not allocate queues"); PRINTK 1518 drivers/atm/ambassador.c PRINTK (KERN_ERR, "queues allocated in nasty area"); PRINTK 1602 drivers/atm/ambassador.c PRINTK (KERN_ERR, "bad queue alloc %p != %p (tell maintainer)", memory, limit); PRINTK 1721 drivers/atm/ambassador.c PRINTK (KERN_ERR, "%s", msg); PRINTK 1844 drivers/atm/ambassador.c PRINTK (KERN_ERR, "self-test failed: %s", msg); PRINTK 1918 drivers/atm/ambassador.c PRINTK (KERN_ERR, "Cannot load microcode data"); PRINTK 1961 drivers/atm/ambassador.c PRINTK(KERN_ERR, "Bad microcode data (%s)", errmsg); PRINTK 2031 drivers/atm/ambassador.c PRINTK (KERN_INFO, "microcode version is %u.%u", major, minor); PRINTK 2089 drivers/atm/ambassador.c PRINTK (KERN_ERR, "card reset failed!"); PRINTK 2094 drivers/atm/ambassador.c PRINTK (KERN_INFO, "failed to get loader version"); PRINTK 2096 drivers/atm/ambassador.c PRINTK (KERN_INFO, "loader version is %08x", version); PRINTK 2099 drivers/atm/ambassador.c PRINTK (KERN_ERR, "microcode failure"); PRINTK 2101 drivers/atm/ambassador.c PRINTK (KERN_ERR, "failed to get memory for queues"); PRINTK 2105 drivers/atm/ambassador.c PRINTK (KERN_ERR, "adapter did not accept queues"); PRINTK 2172 drivers/atm/ambassador.c PRINTK (KERN_INFO, "Changing PCI latency timer from %hu to %hu", PRINTK 2187 drivers/atm/ambassador.c PRINTK (KERN_ERR, "skipped broken (PLX rev 2) card"); PRINTK 2195 drivers/atm/ambassador.c PRINTK (KERN_ERR, "skipped broken (PLX rev 2) card"); PRINTK 2208 drivers/atm/ambassador.c PRINTK (KERN_ERR, "IO range already in use!"); PRINTK 2214 drivers/atm/ambassador.c PRINTK (KERN_ERR, "out of memory!"); PRINTK 2223 drivers/atm/ambassador.c PRINTK (KERN_ERR, "adapter initialisation failure"); PRINTK 2232 drivers/atm/ambassador.c PRINTK (KERN_ERR, "request IRQ failed!"); PRINTK 2303 drivers/atm/ambassador.c PRINTK (KERN_NOTICE, "debug bitmap is %hx", debug &= DBG_MASK); PRINTK 2306 drivers/atm/ambassador.c PRINTK (KERN_NOTICE, "no debugging support"); PRINTK 2310 drivers/atm/ambassador.c PRINTK (KERN_NOTICE, "cmds has been raised to %u", PRINTK 2314 drivers/atm/ambassador.c PRINTK (KERN_NOTICE, "txs has been raised to %u", PRINTK 2319 drivers/atm/ambassador.c PRINTK (KERN_NOTICE, "rxs[%hu] has been raised to %u", PRINTK 2326 drivers/atm/ambassador.c PRINTK (KERN_NOTICE, "useless pool (rxs_bs[%hu] = %u)", PRINTK 2332 drivers/atm/ambassador.c PRINTK (KERN_NOTICE, "rx_lats has been raised to %u", PRINTK 1269 drivers/atm/horizon.c PRINTK (KERN_ERR, "zero-length frame!"); PRINTK 1319 drivers/atm/horizon.c PRINTK (KERN_INFO, "frame received on TX-only VC %x", rx_channel); PRINTK 1324 drivers/atm/horizon.c PRINTK (KERN_WARNING, "dropped over-size frame"); PRINTK 1566 drivers/atm/horizon.c PRINTK (KERN_ERR, "attempt to send on RX-only VC %x", channel); PRINTK 1575 drivers/atm/horizon.c PRINTK (KERN_ERR, "sk_buff length greater than agreed max_sdu, dropping..."); PRINTK 1612 drivers/atm/horizon.c PRINTK (KERN_INFO, "debug bitmap is now %hx", debug = d); PRINTK 2112 drivers/atm/horizon.c PRINTK (KERN_WARNING, "rejecting open with unspecified VPI/VCI (deprecated)"); PRINTK 2411 drivers/atm/horizon.c PRINTK (KERN_ERR, "out of memory!"); PRINTK 2510 drivers/atm/horizon.c PRINTK (KERN_ERR, "%s atm_vcc=%p rxer[channel]=%p", PRINTK 2718 drivers/atm/horizon.c PRINTK(KERN_INFO, "%s PCI latency timer from %hu to %hu", PRINTK 2820 drivers/atm/horizon.c PRINTK (KERN_NOTICE, "debug bitmap is %hx", debug &= DBG_MASK); PRINTK 2823 drivers/atm/horizon.c PRINTK (KERN_NOTICE, "no debug support in this image"); PRINTK 2827 drivers/atm/horizon.c PRINTK (KERN_ERR, "vpi_bits has been limited to %hu", PRINTK 2831 drivers/atm/horizon.c PRINTK (KERN_NOTICE, "max_tx_size has been limited to %hu", PRINTK 2835 drivers/atm/horizon.c PRINTK (KERN_NOTICE, "max_rx_size has been limited to %hu", PRINTK 224 drivers/atm/nicstar.c PRINTK("nicstar%d: freeing %d huge buffers.\n", i, card->hbpool.count); PRINTK 229 drivers/atm/nicstar.c PRINTK("nicstar%d: %d huge buffers freed.\n", i, j); PRINTK 231 drivers/atm/nicstar.c PRINTK("nicstar%d: freeing %d iovec buffers.\n", i, PRINTK 237 drivers/atm/nicstar.c PRINTK("nicstar%d: %d iovec buffers freed.\n", i, j); PRINTK 281 drivers/atm/nicstar.c PRINTK("nicstar: General debug enabled.\n"); PRINTK 398 drivers/atm/nicstar.c PRINTK("nicstar%d: membase at 0x%p.\n", i, card->membase); PRINTK 410 drivers/atm/nicstar.c PRINTK("nicstar%d: setting PCI latency timer to %d.\n", i, PRINTK 495 drivers/atm/nicstar.c PRINTK("nicstar%d: %dK x 32bit SRAM size.\n", i, card->sram_size); PRINTK 545 drivers/atm/nicstar.c PRINTK("nicstar%d: TSQ base at 0x%p.\n", i, card->tsq.base); PRINTK 564 drivers/atm/nicstar.c PRINTK("nicstar%d: RSQ base at 0x%p.\n", i, card->rsq.base); PRINTK 584 drivers/atm/nicstar.c PRINTK("nicstar%d: VBR-SCQ0 base at 0x%p.\n", i, card->scq0->base); PRINTK 1067 drivers/atm/nicstar.c PRINTK("nicstar%d: NICStAR generated an interrupt\n", card->index); PRINTK 1090 drivers/atm/nicstar.c PRINTK("nicstar%d: TSQ full.\n", card->index); PRINTK 1097 drivers/atm/nicstar.c PRINTK("nicstar%d: Timer overflow.\n", card->index); PRINTK 1103 drivers/atm/nicstar.c PRINTK("nicstar%d: PHY interrupt.\n", card->index); PRINTK 1224 drivers/atm/nicstar.c PRINTK("nicstar%d: end of interrupt service\n", card->index); PRINTK 1246 drivers/atm/nicstar.c PRINTK("nicstar%d: opening vpi.vci %d.%d \n", card->index, (int)vpi, PRINTK 1249 drivers/atm/nicstar.c PRINTK("nicstar%d: unsupported AAL.\n", card->index); PRINTK 1280 drivers/atm/nicstar.c PRINTK PRINTK 1291 drivers/atm/nicstar.c PRINTK("nicstar%d: target cell rate = %d.\n", PRINTK 1307 drivers/atm/nicstar.c PRINTK PRINTK 1326 drivers/atm/nicstar.c PRINTK PRINTK 1344 drivers/atm/nicstar.c PRINTK PRINTK 1357 drivers/atm/nicstar.c PRINTK("nicstar%d: can't get fixed rate SCQ.\n", PRINTK 1419 drivers/atm/nicstar.c PRINTK("nicstar%d: closing vpi.vci %d.%d \n", card->index, PRINTK 1446 drivers/atm/nicstar.c PRINTK PRINTK 1536 drivers/atm/nicstar.c PRINTK PRINTK 1818 drivers/atm/nicstar.c PRINTK("nicstar%d: Timeout pushing TSR.\n", PRINTK 2690 drivers/atm/nicstar.c PRINTK("nicstar: Entering ns_poll().\n"); PRINTK 2712 drivers/atm/nicstar.c PRINTK("nicstar: Leaving ns_poll().\n"); PRINTK 181 drivers/net/ethernet/smsc/smc911x.c PRINTK(dev, "smc911x_reset timeout waiting for PM restore\n"); PRINTK 199 drivers/net/ethernet/smsc/smc911x.c PRINTK(dev, "chip reset timeout, retrying...\n"); PRINTK 206 drivers/net/ethernet/smsc/smc911x.c PRINTK(dev, "smc911x_reset timeout waiting for reset\n"); PRINTK 216 drivers/net/ethernet/smsc/smc911x.c PRINTK(dev, "smc911x_reset timeout waiting for EEPROM busy\n"); PRINTK 355 drivers/net/ethernet/smsc/smc911x.c PRINTK(dev, "timeout waiting for RX fast forward\n"); PRINTK 397 drivers/net/ethernet/smsc/smc911x.c PRINTK(dev, "Low memory, rcvd packet dropped.\n"); PRINTK 1584 drivers/net/ethernet/smsc/smc911x.c PRINTK(dev, "%s timeout waiting for EEPROM to respond\n", PRINTK 1592 drivers/net/ethernet/smsc/smc911x.c PRINTK(dev, "%s timeout waiting for EEPROM CMD not busy\n", PRINTK 1881 drivers/net/ethernet/smsc/smc911x.c PRINTK(dev, "ERROR -- no AFC_CFG setting found"); PRINTK 2012 drivers/net/ethernet/smsc/smc911x.c PRINTK(dev, "No PHY found\n"); PRINTK 2014 drivers/net/ethernet/smsc/smc911x.c PRINTK(dev, "LAN911x Internal PHY\n"); PRINTK 2016 drivers/net/ethernet/smsc/smc911x.c PRINTK(dev, "External PHY 0x%08x\n", lp->phy_type); PRINTK 590 drivers/net/ethernet/smsc/smc9194.c PRINTK((CARDNAME": In XMIT with no packet to send\n")); PRINTK 1137 drivers/net/ethernet/smsc/smc9194.c PRINTK((CARDNAME ": WARNING: smc_rcv with nothing on FIFO.\n")); PRINTK 1402 drivers/net/ethernet/smsc/smc9194.c PRINTK((CARDNAME ": UNSUPPORTED: EPH INTERRUPT\n")); PRINTK 1404 drivers/net/ethernet/smsc/smc9194.c PRINTK((CARDNAME ": UNSUPPORTED: ERCV INTERRUPT\n")); PRINTK 408 drivers/net/ethernet/smsc/smc91x.c PRINTK(dev, "smc_rcv with nothing on FIFO.\n"); PRINTK 713 drivers/net/ethernet/smsc/smc91x.c PRINTK(dev, "smc_tx with nothing on FIFO.\n"); PRINTK 734 drivers/net/ethernet/smsc/smc91x.c PRINTK(dev, "%s occurred on last xmit\n", PRINTK 1282 drivers/net/ethernet/smsc/smc91x.c PRINTK(dev, "UNSUPPORTED: ERCV INTERRUPT\n"); PRINTK 1293 drivers/net/ethernet/smsc/smc91x.c PRINTK(dev, "spurious interrupt (mask = 0x%02x)\n", PRINTK 1341 drivers/net/ethernet/smsc/smc91x.c PRINTK(dev, "TX timeout (INT 0x%02x INTMASK 0x%02x MEM 0x%04x FIFO 0x%04x EPH_ST 0x%04x)\n", PRINTK 2040 drivers/net/ethernet/smsc/smc91x.c PRINTK(dev, "No PHY found\n"); PRINTK 2042 drivers/net/ethernet/smsc/smc91x.c PRINTK(dev, "PHY LAN83C183 (LAN91C111 Internal)\n"); PRINTK 2044 drivers/net/ethernet/smsc/smc91x.c PRINTK(dev, "PHY LAN83C180\n"); PRINTK 1260 kernel/trace/trace.h C(PRINTK, "trace_printk"), \