DBG_REGS          297 drivers/atm/ambassador.c   PRINTD (DBG_FLOW|DBG_REGS, "wr: %08zx <- %08x", addr, data);
DBG_REGS          311 drivers/atm/ambassador.c   PRINTD (DBG_FLOW|DBG_REGS, "rd: %08zx -> %08x", addr, data);
DBG_REGS          317 drivers/atm/ambassador.c   PRINTD (DBG_FLOW|DBG_REGS, "wr: %08zx <- %08x b[%08x]", addr, data, be);
DBG_REGS          332 drivers/atm/ambassador.c   PRINTD (DBG_FLOW|DBG_REGS, "rd: %08zx -> %08x b[%08x]", addr, data, be);
DBG_REGS          340 drivers/atm/ambassador.c   if (debug & DBG_REGS) {
DBG_REGS          342 drivers/atm/ambassador.c     PRINTD (DBG_REGS, "reading PLX control: ");
DBG_REGS          345 drivers/atm/ambassador.c     PRINTD (DBG_REGS, "reading mailboxes: ");
DBG_REGS          348 drivers/atm/ambassador.c     PRINTD (DBG_REGS, "reading doorb irqev irqen reset:");
DBG_REGS          467 drivers/atm/horizon.c   PRINTD (DBG_REGS, "CONTROL 0: %#x", rd_regl (dev, CONTROL_0_REG));
DBG_REGS          468 drivers/atm/horizon.c   PRINTD (DBG_REGS, "RX CONFIG: %#x", rd_regw (dev, RX_CONFIG_OFF));
DBG_REGS          469 drivers/atm/horizon.c   PRINTD (DBG_REGS, "TX CONFIG: %#x", rd_regw (dev, TX_CONFIG_OFF));
DBG_REGS          470 drivers/atm/horizon.c   PRINTD (DBG_REGS, "TX STATUS: %#x", rd_regw (dev, TX_STATUS_OFF));
DBG_REGS          471 drivers/atm/horizon.c   PRINTD (DBG_REGS, "IRQ ENBLE: %#x", rd_regl (dev, INT_ENABLE_REG_OFF));
DBG_REGS          472 drivers/atm/horizon.c   PRINTD (DBG_REGS, "IRQ SORCE: %#x", rd_regl (dev, INT_SOURCE_REG_OFF));
DBG_REGS          482 drivers/atm/horizon.c   PRINTDB (DBG_REGS, "framer registers:");
DBG_REGS          484 drivers/atm/horizon.c     PRINTDM (DBG_REGS, " %02x", rd_framer (dev, i));
DBG_REGS          485 drivers/atm/horizon.c   PRINTDE (DBG_REGS,"");