1/*
2 * DTS file for all SPEAr1340 SoCs
3 *
4 * Copyright 2012 Viresh Kumar <viresh.linux@gmail.com>
5 *
6 * The code contained herein is licensed under the GNU General Public
7 * License. You may obtain a copy of the GNU General Public License
8 * Version 2 or later at the following locations:
9 *
10 * http://www.opensource.org/licenses/gpl-license.html
11 * http://www.gnu.org/copyleft/gpl.html
12 */
13
14/include/ "spear13xx.dtsi"
15
16/ {
17	compatible = "st,spear1340";
18
19	ahb {
20
21		spics: spics@e0700000{
22			compatible = "st,spear-spics-gpio";
23			reg = <0xe0700000 0x1000>;
24			st-spics,peripcfg-reg = <0x42c>;
25			st-spics,sw-enable-bit = <21>;
26			st-spics,cs-value-bit = <20>;
27			st-spics,cs-enable-mask = <3>;
28			st-spics,cs-enable-shift = <18>;
29			gpio-controller;
30			#gpio-cells = <2>;
31			status = "disabled";
32		};
33
34		miphy0: miphy@eb800000 {
35			compatible = "st,spear1340-miphy";
36			reg = <0xeb800000 0x4000>;
37			misc = <&misc>;
38			#phy-cells = <1>;
39			status = "disabled";
40		};
41
42		ahci0: ahci@b1000000 {
43			compatible = "snps,spear-ahci";
44			reg = <0xb1000000 0x10000>;
45			interrupts = <0 72 0x4>;
46			phys = <&miphy0 0>;
47			phy-names = "sata-phy";
48			status = "disabled";
49		};
50
51		pcie0: pcie@b1000000 {
52			compatible = "st,spear1340-pcie", "snps,dw-pcie";
53			reg = <0xb1000000 0x4000>, <0x80000000 0x20000>;
54			reg-names = "dbi", "config";
55			interrupts = <0 68 0x4>;
56			interrupt-map-mask = <0 0 0 0>;
57			interrupt-map = <0x0 0 &gic 0 68 0x4>;
58			num-lanes = <1>;
59			phys = <&miphy0 1>;
60			phy-names = "pcie-phy";
61			#address-cells = <3>;
62			#size-cells = <2>;
63			device_type = "pci";
64			ranges = <0x81000000 0 0	 0x80020000 0 0x00010000   /* downstream I/O */
65				0x82000000 0 0x80030000 0xc0030000 0 0x0ffd0000>; /* non-prefetchable memory */
66			status = "disabled";
67		};
68
69		i2s-play@b2400000 {
70			compatible = "snps,designware-i2s";
71			reg = <0xb2400000 0x10000>;
72			interrupt-names = "play_irq";
73			interrupts = <0 98 0x4
74				      0 99 0x4>;
75			play;
76			channel = <8>;
77			status = "disabled";
78		};
79
80		i2s-rec@b2000000 {
81			compatible = "snps,designware-i2s";
82			reg = <0xb2000000 0x10000>;
83			interrupt-names = "record_irq";
84			interrupts = <0 100  0x4
85				      0 101 0x4>;
86			record;
87			channel = <8>;
88			status = "disabled";
89		};
90
91		pinmux: pinmux@e0700000 {
92			compatible = "st,spear1340-pinmux";
93			reg = <0xe0700000 0x1000>;
94			#gpio-range-cells = <3>;
95		};
96
97		pwm: pwm@e0180000 {
98			compatible ="st,spear13xx-pwm";
99			reg = <0xe0180000 0x1000>;
100			#pwm-cells = <2>;
101			status = "disabled";
102		};
103
104		spdif-in@d0100000 {
105			compatible = "st,spdif-in";
106			reg = < 0xd0100000 0x20000
107				0xd0110000 0x10000 >;
108			interrupts = <0 84 0x4>;
109			status = "disabled";
110		};
111
112		spdif-out@d0000000 {
113			compatible = "st,spdif-out";
114			reg = <0xd0000000 0x20000>;
115			interrupts = <0 85 0x4>;
116			status = "disabled";
117		};
118
119		spi1: spi@5d400000 {
120			compatible = "arm,pl022", "arm,primecell";
121			reg = <0x5d400000 0x1000>;
122			#address-cells = <1>;
123			#size-cells = <0>;
124			interrupts = <0 99 0x4>;
125			status = "disabled";
126		};
127
128		apb {
129			i2c1: i2c@b4000000 {
130				#address-cells = <1>;
131				#size-cells = <0>;
132				compatible = "snps,designware-i2c";
133				reg = <0xb4000000 0x1000>;
134				interrupts = <0 104 0x4>;
135				write-16bit;
136				status = "disabled";
137			};
138
139			serial@b4100000 {
140				compatible = "arm,pl011", "arm,primecell";
141				reg = <0xb4100000 0x1000>;
142				interrupts = <0 105 0x4>;
143				status = "disabled";
144				dmas = <&dwdma0 0x600 0 0 1>, /* 0xC << 11 */
145					<&dwdma0 0x680 0 1 0>; /* 0xD << 7 */
146				dma-names = "tx", "rx";
147			};
148
149			thermal@e07008c4 {
150				st,thermal-flags = <0x2a00>;
151			};
152
153			gpiopinctrl: gpio@e2800000 {
154				compatible = "st,spear-plgpio";
155				reg = <0xe2800000 0x1000>;
156				interrupts = <0 107 0x4>;
157				#interrupt-cells = <1>;
158				interrupt-controller;
159				gpio-controller;
160				#gpio-cells = <2>;
161				gpio-ranges = <&pinmux 0 0 252>;
162				status = "disabled";
163
164				st-plgpio,ngpio = <250>;
165				st-plgpio,wdata-reg = <0x40>;
166				st-plgpio,dir-reg = <0x00>;
167				st-plgpio,ie-reg = <0x80>;
168				st-plgpio,rdata-reg = <0x20>;
169				st-plgpio,mis-reg = <0xa0>;
170				st-plgpio,eit-reg = <0x60>;
171			};
172		};
173	};
174};
175